Amana UMTK30 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Proper installation is the installer's responsibility! Tools required to perform installation: Electrical rating of this oven:
Write the model & serial numbers on the owner's
,120VAC@60Hz
• Phillips Screwdriver
manual. The model number label is located on the
• 13A/1100W
• Saw (Electric or Hand)
could be exposed to excessive microwave en-
oven front.
• You need a DEDICATED 120 VAC, 60 Hz, 20A,
• Drill with 7/64" drill bits (Electric or Hand)
• Tape Measure fused electrical supply (located in the

ملخص المحتوى في الصفحة رقم 2

1. "SET" installment in Bracket Base 3. Fixing 'location screw' in cabinet 5. Installment of Bracket Bottom 7. Installment of Trim Frame With product, use boxed screw(4 x 20 ram). Leave the screws protruding from a minimum of 3.5 to a maximum of 4.5 mm 4,5 mmm_ install Trim Frame to make contact cabinet. Place Bracket Bottom on Bracket Base like picture Remove 4 screws from the lower right and left parts Fix '1" screw' at the bottom of cabinet with use of B. Make holes of position A fit to Brack