Peerless Lighting ACC570 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Models: ACC570, ACC570S,
Installation and Assembly - Round Ceiling Plate
ACC570W
This product is UL Listed. It must be
NOTE: Read entire instruction sheet before beginning installation and
installed by a qualified professional


assembly. installer.
Maximum UL Load Capacity: 150 lb (68 kg)
Before you begin, make sure all parts shown are included with your product.
Parts List
ACC 570 ACC 570S ACC 570W
Description Qty. Part # Part # Part #
A round ceiling plate 1 055-1798 055-4798 055-2798
B #14

ملخص المحتوى في الصفحة رقم 2

Place grommet (F) into hole of ceiling plate (A). 1 NOTE: Make sure grommet overlaps retaining A collar. Grommet may require some force to fit in hole and will appear slightly deformed. RETAINING COLLAR F WARNING  For safety, extension column must be locked to threaded fitting with screw. Extension Column Applications Insert end of extension column into threaded fitting of 2 A ceiling plate (A). Tighten four or five complete turns. THREADED Align slot in extension column with one of the small F

ملخص المحتوى في الصفحة رقم 3

Installation to Wood Joist Finished Ceilings, Exposed Wood Joists, or Wood Beam Ceilings WARNING  Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.  Tighten wood screws so that ceiling plate is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power.  Never tighten in excess of 80 in.  lb (9 N.M.).  Make sure that mounting screws are an

ملخص المحتوى في الصفحة رقم 4

Installation to Solid Concrete or Cinder Block WARNING  When installing Peerless ceiling plates on cinder block, verify that you have a minimum of 1-3/8" of actual concrete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90 specifications. It is suggested that a standard electric drill on slow setting is used to drill the hol