ملخص المحتوى في الصفحة رقم 1
SL202B_ManualEN_050107.qxp 5/1/2007 4:15 PM Page i
™
V-2 MILLION POWER SERIES SPOTLIGHT
INSTRUCTION MANUAL
Catalog Number SL202B
Thank you for choosing Black & Decker!
Go to www.BlackandDecker.com/NewOwner
to register your new product
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON PLEASE CALL
1-800-544-6986
BEFORE YOU CALL, HAVE THE CATALOG No, AND DATE CODE
AVAILABLE. IN MOST CASES, A BLACK & DECKER REPRESENTATIVE
CAN RESOLVE THE PROBLEM OVER THE PHONE. IF YOU HAVE A
SUGGESTION OR COMMENT, G
ملخص المحتوى في الصفحة رقم 2
SL202B_ManualEN_050107.qxp 5/1/2007 4:15 PM Page 1 GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES READ ALL INSTRUCTIONS WARNING: Read all instructions before operating product. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. • AVOID DANGEROUS ENVIRONMENTS Don’t use appliances in damp or wet locations. Don’t use appliances in the rain. KEEP CHILDREN AWAY. All visitors should be kept at a distance from work area. STORE I
ملخص المحتوى في الصفحة رقم 3
SL202B_ManualEN_050107.qxp 5/1/2007 4:15 PM Page 2 EXTENSION CORDS. Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The following table shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the gage number
ملخص المحتوى في الصفحة رقم 4
SL202B_ManualEN_050107.qxp 5/1/2007 4:15 PM Page 3 Do not immerse spotlight in water. Do not drop or throw spotlight. It contains glass and a sealed lead acid battery. Only replace bulb with type indicated in specifications (6 volt, H3 55 watt quartz halogen). Use only with AC or DC charging adapters that are provided with unit. Plug in the charging adapter at the spotlight first, then plug into the charging source. Do not overcharge: – AC recharge up to 30 hours maximum. – DC rec
ملخص المحتوى في الصفحة رقم 5
SL202B_ManualEN_050107.qxp 5/1/2007 4:15 PM Page 4 CHARGING/RECHARGING THE SPOTLIGHT This unit is shipped in a partially charged state. Charge unit BEFORE first use using the 120 Volt AC Charger for 20-30 hours or until the green Battery Status LED flashes. Charge after each use until green LED flashes. Charging/Recharging Using the 120 Volt AC Charger and a Standard Household Extension Cord (not included) Plug a standard North American 120 volt AC extension cord (not included) into the 120 V
ملخص المحتوى في الصفحة رقم 6
SL202B_ManualEN_050107.qxp 5/1/2007 4:15 PM Page 5 Using the Built-In Carry Lanyard The Carry Lanyard may be used to store or carry the Spotlight. Adjust the slide on the cords to keep the Lanyard secure around the supporting object. CARE AND MAINTENANCE All batteries lose charge with time, especially when they are warm. Recharge the unit every two months when not in frequent use, preferably using the 120 volt AC method. Never submerge the unit in water. If the unit gets dirty, gently clean t
ملخص المحتوى في الصفحة رقم 7
SL202B_ManualEN_050107.qxp 5/1/2007 4:15 PM Page 6 12. Connect the bulb power wire to the red power wire. 13. Tighten the retaining screw on the flange. 14. Place the reflector in position in the body of the spotlight. 15. Replace the rubber “O” ring in the groove around the perimeter of the reflector. 16. Replace glass and retaining ring so the screw holes are aligned. 17. Secure retaining ring with two screws. 18. Replace rubber bezel. 19. Operate switch to ensure proper operation of spotli
ملخص المحتوى في الصفحة رقم 8
SL202B_ManualEN_050107.qxp 5/1/2007 4:15 PM Page 7 Accessories Recommended accessories for use with your tool are available from your local dealer or authorized service center. If you need assistance regarding accessories, please call: 1-800-544-6986. WARNING: The use of any accessory not recommended for use with this tool could be hazardous. SERVICE INFORMATION All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool se
