ملخص المحتوى في الصفحة رقم 1
WS-9035TWC
Wireless 433 MHz
Radio-controlled Weather Station
Instruction Manual
ملخص المحتوى في الصفحة رقم 2
TABLE OF CONTENTS Topic Page Inventory of Contents/Additional Equipment 3 About WWVB 3 Quick Set-Up Guide 4 Detailed Set-Up Guide Battery installation 5 Program Mode Program Sequence and Default Settings 6 Function Keys 6 Setting the LCD Contrast 6-7 Setting the Time Zone 7 Daylight Saving Time Setting 7 Radio-controlled Time Setting 7 12/24-hour Time Setting 8 Setting the Time 8 Setting the Year, Day and Month 9 Setting the Snooze 9 Setting t
ملخص المحتوى في الصفحة رقم 3
INVENTORY OF CONTENTS 1. The WS-9035U weather station (Figure 1). 2. One TX8U remote temperature/humidity sensor (Figure 2). 3. One TX15U wind speed sensor (Figure 3). 4. Mounting hardware 5. Instruction manual and warranty card. Figure 1 Figure 2 Time LCD Date LCD Moon Phase LCD Indoor LCD Forecast LCD Outdoor LCD Wind Speed LCD Figure 3 ADDITIONAL EQUIPMENT (not included) 1. Three fresh AA 1.5V batteri
ملخص المحتوى في الصفحة رقم 4
QUICK SET-UP GUIDE Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the indoor weather station, remote temperature/humidity sensor and wind speed sensor 3 to 5 feet apart. 2. Insert the telephone plug (RJ-11) from the wind speed sensor into the receptacle on the remote temperature/humidity sensor. 3. Batteries should be out of both the indoor weather station and remote temperature/humidity sensor units for 10 minutes. 4. Place the batteries into the r
ملخص المحتوى في الصفحة رقم 5
1. Remove the battery cover. To do this, insert a solid object in the space provided at the lower-central position of the battery cover, then push up and pull out on the battery cover. 2. Observe the correct polarity, and install 3 AA batteries. 3. Replace the battery cover. Note: Immediately after the batteries have been installed, the LCD (Liquid Crystal Display) will flash. Within 15 seconds the indoor temperature, indoor relative humidity, and the weather icons (sun and clouds) w
ملخص المحتوى في الصفحة رقم 6
III. SETTING THE LCD CONTRAST 1. Press and hold the SET button for 5 seconds. 2. “LCD” will show in the TIME LCD and the number setting will flash. Note: There are 8 LCD contrast levels to choose from—“Lcd 0” is the lightest, and “Lcd 7” is the darkest. 3. Press and release the ALM/+ button to select the level you desire. 4. Press and release the SET button to confirm and advance to the Time Zone setting. IV. TIME ZONE SETTING 1. Press and hold the SET button for 5 seconds
ملخص المحتوى في الصفحة رقم 7
2. “LCD” will show in the TIME LCD and the number setting will flash. 3. Press and release the SET button three times. 4. “RCC” will appear in the DATE LCD and “ON” or “OFF” will flash in the TIME LCD. 5. Press and release the ALM/+ button to select radio-controlled time on or off. 6. Press and release the SET button to confirm and advance to the 12/24- hour time setting. VII. 12 OR 24 HOUR TIME SETTING 1. Press and hold the SET button for 5 seconds. 2. “LCD” will show in the TIME
ملخص المحتوى في الصفحة رقم 8
IX. SETTING THE YEAR, DAY AND MONTH Note: Reception of the WWVB signal will also set the date and day. The reception of the signal will override any programmed date and day. 1. Press and hold the SET button for 5 seconds. 2. “LCD” will show in the TIME LCD and the number setting will flash. 3. Press and release the SET button seven times. 4. The year will flash in the DATE LCD. 5. Press and release the ALM/+ button to advance the year. 6. Press and release the SET button to confir
ملخص المحتوى في الصفحة رقم 9
4. Either “1”, “2” or “3” will flash in the TIME LCD and the forecast icon and tendency arrows will flash in the FORECAST LCD. 5. Press and release the ALM/+ button to select the forecast sensitivity 6. Press and release the SET button to confirm the forecast sensitivity and complete the programming. FEATURES OF THE WS-9035U Radio-controlled WWVB Tower time icon Icon (indicates (indicates radio- time reception) controlled time turned on) Current moon phase display
ملخص المحتوى في الصفحة رقم 10
Sunny—indicates that the weather is expected to improve (not that the weather will be sunny). Sun with Clouds—indicates that the weather is expected to be fair (not that the weather will be sunny with clouds). Clouds with Rain—indicates that the weather is expected to get worse (not that the weather will be rainy). These icons indicate the expected weather change in the next 12 to 24 hours. The icon does not give an exact prediction of the weather, however it should be viewed as a general
ملخص المحتوى في الصفحة رقم 11
2. Press and release the OUT/MIN button again (once while “MAX” is still displayed, twice otherwise). “MIN” appears to the right of the outdoor temperature, indicating that the minimum temperature and the time and date of occurrence are displayed. 3. While “MIN” is still displayed press and release the OUT/MIN button again to return to the current data display. Or you can wait 30 seconds, during either the minimum or the maximum readings, and the unit will automatically return to curren
ملخص المحتوى في الصفحة رقم 12
1. Press and hold the SET button for 5 seconds. 2. The record will now be reset and show the current time in the TIME LCD and dew point reading in the OUTDOOR LCD. To return to the outdoor temperature/humidity viewing mode: 1. Press and hold the OUT/MIN button for 5 seconds. 2. The OUTDOOR LCD will switch back to show the outdoor temperature and humidity (DEW POINT will no longer be visible in the upper left corner of the OUTDOOR LCD). VII. WIND SPEED, WIND CHILL, MINIMUM AND MAXIMU
ملخص المحتوى في الصفحة رقم 13
Beaufort Number Wind Speed Description Effects Land / Sea or Force mph km/hr knots Still, calm air, smoke will rise vertically. 0 <1 <1 <1 Calm Water is mirror-like. Rising smoke drifts, wind vane is inactive. 1-3 1-5 1-3 1 Light Air mph kph knots Small ripples appear on water surface. Leaves rustle, can feel wind on your face, wind vanes begin to move. 4-7 6-11 4-6 Light Breeze 2 mph kph knots Small wavelets develop, crests are glassy. Leaves and small twigs move, l
ملخص المحتوى في الصفحة رقم 14
Slight damage occurs to buildings, shingles are blown off of roofs. 47-54 75-88 41-47 9 Strong Gale High waves (6 meters), mph kph knots rolling seas, dense foam, Blowing spray reduces visibility. Trees are broken or uprooted, building damage is considerable. 55-63 89-102 48-55 Large waves (6-9 10 Whole Gale or Storm mph kph knots meters), overhanging crests, sea becomes white with foam, heavy rolling, reduced visibility. Extensive widespread damage. 64-72 103-117 56-63
ملخص المحتوى في الصفحة رقم 15
MOUNTING Note: Before permanently mounting ensure that the indoor weather station is able to receive WWVB signals from the desired location. Also, extreme and sudden changes in temperature will decrease the accuracy of the indoor weather station, and changes in elevation will result with inaccurate weather forecasting for the next 12 to 24 hours. These changes will require a 12 to 24 hour wait before obtaining reliable data. To achieve a true temperature reading, avoid mounting where
ملخص المحتوى في الصفحة رقم 16
II. THE REMOTE WIND SPEED SENSOR The remote wind speed sensor can be mounted two ways: • With the use of screws • Using nylon straps A. MOUNTING WITH SCREWS 1) Unlock the mounting bracket from the remote wind speed sensor leaving the wire going through the bracket. 2) Place the mounting bracket over the desired location. 3) Through the two screw holes of the bracket, mark the mounting surface with a pencil. 4) Screw the mounting bracket onto the mounting surface. Ensure that the
ملخص المحتوى في الصفحة رقم 17
5) Place the remote temperature/humidity sensor and indoor weather station in position so the straight-line signal is not passing through more than two or three walls. Problem: Temperatures do not match if units are placed next to each other. Solution: Each temperature/humidity sensor is manufactured to be accurate to within 2 degree plus or minus and under normal conditions, so two sensors could be as much as 4 degrees different. However, the difference can be exaggerated further becaus
ملخص المحتوى في الصفحة رقم 18
SPECIFICATIONS Weather data measuring range: Indoor: 14.2°F to 139.8°F with 0.1°F resolution (0°C to 59.9°C with 0.1°C resolution) “OFL” displayed if outside this range Outdoor and dew point: -21.8°F to 157.8°F with 0.1°F resolution (-29.9°C to 69.9°C with 0.1°C resolution) “OFL” displayed if outside this range Wind chill: -21.8°F to 157.8°F with 0.1°F resolution (-29.9°C to 69.9°C with 0.1°C resolution) “OFL” displayed if outside range Indoor relative humidity 1% to 99% with 1
ملخص المحتوى في الصفحة رقم 19
WARRANTY INFORMATION La Crosse Technology provides a 1-year warranty on this weather station. Contact La Crosse Technology immediately upon discovery of any defects covered by this warranty. Before sending the Weather Station in for repairs, contact La Crosse Technology. The Weather Station will be repaired or replaced with the same or similar model. This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty batteries, or the Weather Stations
