ملخص المحتوى في الصفحة رقم 1
®
CARE AND USE MANUAL
for
PH and PHI SERIES PROFESSIONAL
WALL and ISLAND HOODS
PH30ZS, PH36ZS, PH42ZS,
PH48ZS, PH54ZS,
PHI48ZS and PHI60ZS
READ AND SAVE THESE INSTRUCTIONS
ملخص المحتوى في الصفحة رقم 2
A special message to Our Customers, Thank you for buying a Thermador Hood. Please take the time to read and understand this entire booklet before using your new appliance. We hope that the information in this manual will help you easily operate and care for your Hood with years of satisfaction. Please contact us if you have any questions or comments. Thermador’s address and phone number are listed on the last page of each language section in this booklet. TABLE OF CONTENTS Important Safety Ins
ملخص المحتوى في الصفحة رقم 3
IMPORTANT SAFETY INSTRUCTIONS WARNING WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC TO REDUCE THE RISK OF INJURY TO PERSONS, SHOCK, OR INJURY TO PERSONS, IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING: OBSERVE THE FOLLOWING: 1. Use this unit only in the manner a) SMOTHER FLAMES with a close-fitting lid, intended by the manufacturer. If you cookie sheet, or other metal tray, then turn have questions, contact the off the gas burner or the electric element. manufacturer (800/735-432
ملخص المحتوى في الصفحة رقم 4
OPERATING THE HOOD Drafts across the range or cooktop will reduce the The blower should be turned on for about 5 minutes effectiveness of the hood. Such drafts should be before cooking in order to establish air currents prevented when possible. upward through the hood. Thus when heat, smoke, moisture, grease and cooking odors are produced, The best job of ventilation in the kitchen is done where they will be carried outside instead of drifting into the only air currents are those created by t
ملخص المحتوى في الصفحة رقم 5
HOOD CONTROL BUTTONS OFF HEAT SENSOR Pressing button once turns ventilator off and resets Your hood is equipped with a heat sensor that will control. turn the blower to Low speed if excessive heat occurs above the cooking surfaces. FAN SPEED Pressing button once, from an off state, turns the 1. If the blower is off – it turns the blower on to low ventilator on low. Each successive press of the button speed. increases the fan speed until high where the fan 2. If the blower is already on any speed
ملخص المحتوى في الصفحة رقم 6
CARE AND CLEANING To Clean Hood Surface • For general care, wipe the outside of the stainless steel with sudsy water or household cleaners ® ® such as Fantastic or Formula 409 , rinse well and dry with a clean soft cloth to avoid water ® marks. Wipe and dry stainless steel in the same direction 12 3 as the grain. Avoid using too much pressure, which may mar the surface. Do not use abrasive products such as steel wool. OFF DELA A AY Y LIGHT FAN FIL L LTER TER SHUT OFF SPEED To remove fing
ملخص المحتوى في الصفحة رقم 7
MAINTENANCE LIGHTS NOTE: Turn off the lights and fan. Allow the lights to cool before handling. If new lights do not operate, be sure lights are inserted correctly before calling service. Halogen Light Replacement (for PH and PHI Model Wall and Island Hoods) Using a flat edge from a screwdriver or equivalent tool, pry loose the lens cover as shown in Figure 5. Remove the damaged light and replace with a new 12 Volt, 20 Watt (maximum) halogen light made for a G-4 base. Follow package dir
ملخص المحتوى في الصفحة رقم 8
THERMADOR HOOD WARRANTY FULL ONE YEAR WARRANTY Covers one year from date of installation, or date of occupancy on a new, or previously unoccupied dwelling. Save your dated receipt or other evidence of installation/ occupancy date. Thermador Will Pay For: All repair labor and replacement parts found to be defective due to materials and workmanship. Service must be provided by a Factory Authorized Service Agency, during normal working hours. For a Service Agency nearest you, please call 800/735-4
