ملخص المحتوى في الصفحة رقم 1
Operating and Installation
Instructions
Ventilation System
DA 251-4
DA 252-4
DA 259-4
To prevent accidents en - US, CA
and machine damage,
read these instructions
before
installation or use. M.-Nr. 06 712 760
ملخص المحتوى في الصفحة رقم 2
Contents IMPORTANT SAFETY INSTRUCTIONS Functional description Guide to the appliance Operation Turning on the fan .................................................10 Selecting the power level............................................10 Delayed Shut Down................................................12 Turning off the fan .................................................12 Turning the lighting on / off ..........................................13 Dimming the lighting ..........................
ملخص المحتوى في الصفحة رقم 3
IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is designed to vent ~ This appliance is intended for cooking smoke and odors only. residential use only. Use the Be certain your appliance is ~ appliance only for its intended properly installed and grounded by a purpose. The manufacturer cannot qualified technician. be held responsible for damages To guarantee the electrical safety of this caused by imprope
ملخص المحتوى في الصفحة رقم 4
IMPORTANT SAFETY INSTRUCTIONS This equipment is not designed for Use ~ maritime use or for use in mobile Do not allow children to play with or ~ installations such as recreational operate the appliance or its controls. vehicles or aircraft. However, under Supervise its use by the elderly or certain conditions it may be possible for infirm. installation in these applications. Please contact the nearest Miele dealer or the Do not flambé or grill with an open ~ Technical Service Department with fla
ملخص المحتوى في الصفحة رقم 5
IMPORTANT SAFETY INSTRUCTIONS , WARNING - TO REDUCE , WARNING TO REDUCE THE RISK OF INJURY THE RISK OF A COOKTOP TO PERSONS IN THE EVENT OF A GREASE FIRE: COOKTOP GREASE FIRE, OBSERVE Never leave surface units ~ THE FOLLOWING: unattended at high settings. Boilovers SMOTHER FLAMES with a close ~ cause smoking and greasy spillovers fitting lid, cookie sheet, or metal tray may ignite. Heat oils slowly on low or then turn off the burner. medium settings. BE CAREFUL TO PREVENT BURNS. Always turn the
ملخص المحتوى في الصفحة رقم 6
IMPORTANT SAFETY INSTRUCTIONS Installation Any fittings, sealant, or materials ~ used to install the ductwork must be , WARNING ~ made of approved non-flammable To reduce the risk of fire only use materials. metal ductwork. Never connect an exhaust hood to ~ Provided a larger distance is not ~ an active chimney, dryer vent, vent flue, given by the manufacturer of the or room ventilating ductwork. Seek cooktop, follow the minimum safety professional advice before connecting distances between a co
ملخص المحتوى في الصفحة رقم 7
Functional description The ventilation hood works by air extraction. The air is drawn in and cleaned by the grease filter and directed outside. The hood comes equipped with a non-return flap. This flap automatically closes when the hood is turned off so that no exchange of outside air and room air can occur. When the hood is turned on, the air pressure of the exhaust fan automatically opens the flap blowing the inside air and cooking odors outside. 7
ملخص المحتوى في الصفحة رقم 8
Guide to the appliance 8
ملخص المحتوى في الصفحة رقم 9
Guide to the appliance a Chimney extension k Indirect light button b Chimney l Overhead light button This button turns the light on and off c Canopy and also dims the light. The lighting can be used independently d Grease filter of the fan. e Overhead lighting m On/Off button f Recirculation vent n Fan power level buttons Four fan speed selection. g Indirect lighting o Delayed Shut Down h Glass shelves This button activates the Delayed Shut Each holds up to 8 lbs. Down feature. The fan can be se
ملخص المحتوى في الصفحة رقم 10
Operation Turning on the fan Automatically switching back the Intensive power level The intensive level "4" can be programmed to automatically switch back to level "3" after 10 minutes. ^ Press the On/Off button. ^ Turn the fan and the lights off. The fan runs at power level "2". The On/Off indicator lights. Selecting the power level ^ Press and hold the Delay Shut Down button for 10 secs. The first indicator of the fan power levels lights. ^ Press the following buttons one after another, ^ Use
ملخص المحتوى في الصفحة رقم 11
Operation Fan performance The maximum air flow capacity is 625 cfm. Factors such as narrow duct diameter and bends will affect this If the power level indicators "1" and "4" value. flash the automatic switch back is not Level 1 operates at 40% capacity activated. Level 2 operates at 60% capacity ^ To activate the automatic switch back Level 3 operates at 80% capacity press the "+" button. Level 4 operates at 100% capacity The power level indicators "1" and "4" light. ^ To deactivate the automati
ملخص المحتوى في الصفحة رقم 12
Operation Delayed Shut Down Turning off the fan If odors or smoke remain in the kitchen after cooking has been completed, the Delayed Shut Down feature can be selected to allow the hood to continue running for either 5 or 15 minutes. ^ Press the On/Off button to turn the fan off. The indicator goes out. Automatic Safety Shut Off ^ Press the Delayed Shut Down button The fan will be turned off automatically while the fan is still running. 10 hours after the last button was Press once = 5 minute de
ملخص المحتوى في الصفحة رقم 13
Operation Turning the lighting on / off Dimming the lighting The overhead lighting can be turned on The brightness of the lighting can be and off independently of the fan. adjusted. ^ While the lighting is turned on, press the right light button. The lighting will dim until the button is released. ^ Press the light button briefly to turn ^ If the button is pressed again, the on the lighting. lighting will brighten until the button is The light button indicator illuminates. released. ^ Press the
ملخص المحتوى في الصفحة رقم 14
Operation Grease filter timer Checking the grease filter timer A timer monitors the hours of fan To check the percentage of time operation. The indicator for the grease already used: filter will light after 30 hours of operation. The grease filters must then be cleaned. After the grease filters have been cleaned and put in place, the grease ^ Press the On/Off button to turn the filter timer must be reset. fan on. ^ To do this, press the grease filter ^ Press the grease filter button. button for
ملخص المحتوى في الصفحة رقم 15
Operation Reprogramming the grease filter timer The grease filter timer is preset to 30 hours. This time can be lengthened or The indicator for the grease filter and shortened to 20, 30, 40 or 50 hours. one of the "–/+" indicators will flash. – A time of 20 hours should be The lit "–/+" indicator shows the programmed in kitchens with programmed time: frequent pan or deep frying. 1st indicator from the left = 20 hours – A time of 20 hours should also be 2nd indicator from the left = 30 hours prog
ملخص المحتوى في الصفحة رقم 16
Cleaning and Care Stainless steel Before cleaning or servicing the hood, disconnect it from the power Stainless steel surfaces can be cleaned supply by either removing the fuse, using a non-abrasive stainless steel unplugging it from the outlet or cleaner. manually "tripping" the circuit To help prevent resoiling, a conditioner breaker. for stainless steel can also be used. Apply sparingly with even pressure. Cleaning the casing Stainless steel colored controls ,Never use abrasive cleaners, scou
ملخص المحتوى في الصفحة رقم 17
Cleaning and Care Grease filters ^ In a dishwasher: place the filters vertically in the lower basket, making The reusable metal grease filters sure that the spray arm is not remove solid particles from the vented blocked. kitchen air (grease, dust, etc). Use a hot temperature program, e.g. "Heavy Soil" or "Pots and pans". Use the recommended amount of dishwasher detergent. Overuse could destroy the filter. The grease filters should be cleaned Depending on the detergent, every3-4 weeks or wheneve
ملخص المحتوى في الصفحة رقم 18
Cleaning and Care Changing the light bulbs Overhead light Before changing the light bulbs, disconnect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. When in use halogen bulbs become extremely hot, and they can burn your hands. Do not attempt to change the bulbs until they have had sufficient time to cool. Do not touch the bulb surface. Fingerprints or body oils deposited ^ To change the halogen bulb, remove on the bulb will
ملخص المحتوى في الصفحة رقم 19
Cleaning and Care Indirect lighting ^ Remove the two screws securing the light cover. ^ Carefully raise the front of the bulb and pull it out of its socket. ^ Insert the new bulb into the socket and lower it into its holder. ^ Replace the light cover and the two screws. 19
ملخص المحتوى في الصفحة رقم 20
After Sales Service Repairs MieleCare In the event of a fault which you cannot MieleCare, our Extended Service easily fix yourself, please contact the Contract program, gives you the Miele Technical Service Department. assurance of knowing that your appliance investment is covered by ^ When contacting the Technical 5 years of worry free ownership. Service Department, please quote MieleCare is the only Extended Service the model and serial number of your Contract in the industry that guarantees a
