ملخص المحتوى في الصفحة رقم 1
Instruction Manual
Underwater Case
PT-022
For the digital camera
CAMEDIA C-760 Ultra Zoom/
C-770 Ultra Zoom
Thank you for buying the Underwater Case PT-022.
Please read this instruction manual carefully and use the product safely
and correctly.
Please keep this instruction manual for reference after reading it.
Wrong use may cause damage to the camera on the inside from water
leakage, and repair may not be possible.
Before use, perform an advance check as described in this manual.
ملخص المحتوى في الصفحة رقم 2
Introduction Unauthorized copying of this manual in part or in full, except for private use, is prohibited. Unauthorized reproduction is strictly prohibited. OLYMPUS CORPORATION shall not be responsible in any way for lost profits or any claims by third parties in case of any damage occurring from unsuitable use of this product. OLYMPUS CORPORATION shall not be responsible for damage, lost profits, etc. caused by loss of image data because of defects, disassembly, repair or modification o
ملخص المحتوى في الصفحة رقم 3
WARNING 1. Keep this product out of the reach of babies, infants, and children. There is the possibility of occurrence of the following types of accidents. Injury by dropping onto the body from a height. Injury from parts of the body getting caught in parts which open and close. Swallowing of small parts. Please consult a physician immediately if any parts have been swallowed. Triggering of the flash in front of the eyes may cause permanent vision impairment etc. 2. Do not store with a b
ملخص المحتوى في الصفحة رقم 4
5. Jumping into the water with the Case in your pocket or in your hand, throwing the Case from a boat or ship into the water, and other rough handling may cause water leakage. Please handle with sufficient care, when handing it over from hand to hand etc. 6. If the camera on the inside should become wet because of water leakage etc., immediately wipe off all moisture and confirm the operation. 7. Please remove the O-ring when traveling by air. Otherwise air pressure may make it impossible to ope
ملخص المحتوى في الصفحة رقم 5
For Prevention of Water Leakage Accidents When water leakage occurs while this product is being used, repair of the camera housed in this product may become impossible. Please observe the following cautions for use. 1. When sealing this product, make sure that no hairs, fibers, sand particles or other foreign matter stick not only to the O-ring, but also to the contact surface (flat part of the front cover). Even a single hair or a single grain of sand may cause water leakage. Please check with
ملخص المحتوى في الصفحة رقم 6
8. When the O-ring contact surface is pressed strongly from the outside of the Case, or when the Case is twisted, the waterproof function may be lost. Take care not to exert excessive force. 9. Please use the Case after performing the advance test and the final check. 10.If you should notice drops of water or other signs of water leakage while taking pictures, immediately stop the dive, remove any water from the camera and the product, test according to the item "Final check", and confirm whethe
ملخص المحتوى في الصفحة رقم 7
Do not use the following chemicals for cleaning, corrosion prevention, prevention of fogging, repair or other purposes. When these are used for the Case directly or indirectly (with the chemicals in vaporized state), they may cause cracking under high pressure or other problems. Chemicals which cannot be used Explanation Do not clean the Case with alcohol, gasoline, thinner Volatile organic solvents, or other volatile organic solvents or with chemical chemical detergents detergents etc. Pure w
ملخص المحتوى في الصفحة رقم 8
Contents Introduction ................................................................................E-1 Please read the following items before use ..............................E-1 For safe use ..............................................................................E-1 Batteries ....................................................................................E-3 For Prevention of Water Leakage Accidents..............................E-4 Handling the Product.............................
ملخص المحتوى في الصفحة رقم 9
Check the loading status. ........................................................E-22 Seal the Case. ........................................................................E-22 Install the special balance weight. ..........................................E-22 Installation and Removal of the LCD Hood ..............................E-23 Installation ............................................................................E-23 Removal.............................................................
ملخص المحتوى في الصفحة رقم 10
1. Preparations Check the contents of the package. Check that all accessories are in the box. Contact your dealer if accessories should be missing or damaged. CD-ROM E-9
ملخص المحتوى في الصفحة رقم 11
Names of the parts Palm grip ❈ Flash button Balance weight Buckle open/close lever ❈ Flash mode/Protect button O-ring removing pick Buckle hook ❈ Self-timer/Erase button LCD inner hood Diffusion plate and diffusion plate cover ❈ Flash storage button LCD hood O-ring ❈ Power switch dial knob (C-770) LCD hood strap ❈ Shutter lever ❈ Power switch button (C-760) Light shield hood ❈ Zoom lever ❈ Mode dial knob Buckle opener Hand
ملخص المحتوى في الصفحة رقم 12
Install the strap. Install the strap on the Case body. Installation explanation Finished installation Hand strap Hand strap ring CAUTION : Please install the strap correctly as shown above. OLYMPUS CORPORATION shall bear no responsibility for damage etc. caused by dropping the Case because of incorrect installation of the strap. Master the basic operation. Please master the basic operation of the Case before taking pictures. Holding the Case Hold the Case securely with both hands, keep your elb
ملخص المحتوى في الصفحة رقم 13
How to Press the Shutter When pressing the shutter lever, press it gently, so that there will be no movement of the camera. Note: • For detailed operation of the shutter, refer to the instruction manual for the digital camera. How to Use the Mode Dial This Case is equipped with a Mode mode dial knob which permits dial knob operation of the mode dial of the loaded digital camera from the outside. After loading the digital camera into the Case, seal the Case and confirm that the mode dial can be o
ملخص المحتوى في الصفحة رقم 14
Setting the Zoom Lever When loading the digital camera in the Case, fit the projecting part of the zoom lever of the digital camera into the recessed part of the zoom lever on the inside of the Case. CAUTION : •When loading the camera, confirm that the projecting part of the zoom lever of the camera is properly set to the recessed part of the zoom lever of the Case. • When the setting is insufficient, the loading of the camera becomes imperfect and it may not be possible to seal the Case or zoom
ملخص المحتوى في الصفحة رقم 15
C-770 Ultra Zoom 1)Turn the power switch button counterclockwise until it clicks. 2) Before closing the rear lid of the case, turn the power switch dial knob counterclockwise so that the index on the power switch slide lever (located on the inner side of the case) comes on the OFF position. 3) Make sure that the extremity of the power switch slide lever fits into the power switch of the camera. Tip of power switch slide lever 4) Turn the power switch dial knob to turn the camera ON/OFF. (The pow
ملخص المحتوى في الصفحة رقم 16
Flash operation procedure Press the flash button to raise the flash out of the camera. Moving the flash storage button again to store the flash inside the camera. Note: • For details about using the flash for taking pictures, refer to the instruction manual for the camera. E-15
ملخص المحتوى في الصفحة رقم 17
Removing the TLL cable connector cap TTL flash shooting by combining this case (PT-022) and the case for FL-20 flash (optional PFL-01): Remove the TTL cable connector 1 TTL cable Remove. cap from this case. connector cap ❈ The PFL-01 can be used only with the C-770 Ultra Zoom. Connect the underwater TTL 2 cable connector, provided with the PFL-01, to the TTL cable Turn counter clockwise. 1 connector on this case. Underwater 2 TTL cable Insert into the connector. Turn the threaded section of t
ملخص المحتوى في الصفحة رقم 18
Removing the hot shoe cable cap To perform TTL flash shooting when this case is used, connect the hot shoe cable provided with the optional PFL-01 between the connector on this case and the C-770 Ultra Zoom's hot shoe. Turn the hot shoe cable connector cap inside 1 the case counterclockwise to remove it. Insert the connector of the hot shoe cable into the case's connector and turn the connector 2 screws all the way clockwise to connect them firmly. Insert the cable's hot shoe into the C-770 Ultr
ملخص المحتوى في الصفحة رقم 19
2. Advance Check of the Case Advance test before use This Case has been the subject of thorough quality control for the parts during the manufacturing process and thorough function inspections during the assembly. In addition, a water pressure test is performed with a water pressure tester for all products to confirm that the performance conforms to the specifications. However, depending on the carrying and storage conditions, the maintenance status, etc., the waterproof function may be damaged.
ملخص المحتوى في الصفحة رقم 20
3. Install the digital camera. Check the digital camera. Check the digital camera before loading it in the Case. Battery Confirmation As the LCD monitor is used for picture confirmation while taking pictures under water, the battery life becomes short. Confirm that the remaining battery capacity is sufficient. Do not use alkaline batteries, as it is quite possible that they will become unusable during a dive. Note: • In order to avoid losing shutter chances due to an exhausted battery, you shoul
