Audiovox 640 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

FOR
50 - - 015 SERIES 1181272























These i








5. 18 GA wire 4' - 6' 6. 1/4" Hex Socket Bit
o Module


NOT FOR VEHICLES EQUIPPED WITH SUN ROOF.




-
Printed in the U.S.A

0044A INSTALLATION INSTRUCTION # 44
Nov. 8, 1999
NOT FOR USE IN VEHICLES EQUIPPED WITH FACTORY REAR A

ملخص المحتوى في الصفحة رقم 2

1 1 2 - 2 6 3 4 2 SCREW, # 8 X 1 1/2" PWH 4 1 2 5 3 1 6 7 1 4 8 1 9 1 10 1 5 - 00 44A Nov. 8, 1999 Printed in the U.S.A.

ملخص المحتوى في الصفحة رقم 3

Caution: Before cutting indicated. Make sure that the 7" cut is centered ure 2. DO NOT 4. pg. 2) with the 5. Secure front of bracket to front roof brace using (2) two # 10 X 1/2" 3 FIGURE 3 screws (item 1 pg 2). roof. See Fig. 3 and Fig. 4. notches in bracket with center lines scribed on rear tabs engage rear O.E.

ملخص المحتوى في الصفحة رقم 4

7. Construct a jumper h See Figure 5.

ملخص المحتوى في الصفحة رقم 5

suggested routing of the - the B - pillar to the floor. Route the power lead to an accessory controlled source. Connect the Sensor extension, etc.) to the VCP location. - 32 x 3/4" secure rear then tighten (2) two 6 - See Figure 7. 5 FIGURE 7 32 screws previously installed. (item 4 pg. 2). Make sure console alignment is straigh

ملخص المحتوى في الصفحة رقم 6

Lower video sc ort phone Note : Make sure wires do not get pinched between video system and console. (4) four 6 - Caution : Do not overtighten screws. Caution: Do not overtighten screws or damage to 19. 20. (2) # 6 X 1/2" screws (item 5 pg 2). 21.