ملخص المحتوى في الصفحة رقم 1
instruction manual
NXD-CV7 and NXT-CV7
7" Modero Widescreen Video Touch Panels
(Firmware version G4)
Touch Panels and Accessories
ملخص المحتوى في الصفحة رقم 2
AMX Limited Warranty and Disclaimer AMX Corporation warrants its products to be free of defects in material and workmanship under normal use for three (3) years from the date of purchase from AMX Corporation, with the following exceptions: • Electroluminescent and LCD Control Panels are warranted for three (3) years, except for the display and touch overlay components that are warranted for a period of one (1) year. Disk drive mechanisms, pan/tilt heads, power supplies, and MX Series product
ملخص المحتوى في الصفحة رقم 3
FCC Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received; including interference that may cause undesired operation. Federal Communications Commission (FCC) Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are de
ملخص المحتوى في الصفحة رقم 4
ملخص المحتوى في الصفحة رقم 5
Table of Contents Table of Contents Introduction ...............................................................................................................1 CV7 Specifications ............................................................................................................ 3 CV7 Panels - Connector Layout........................................................................................ 6 CV7 Touch Panel Accessories ............................................................
ملخص المحتوى في الصفحة رقم 6
Table of Contents Installation ..............................................................................................................29 Unpacking the Panel....................................................................................................... 29 Installing the Internal Components.................................................................................. 29 Installing the No-Button Trim Ring ...........................................................................
ملخص المحتوى في الصفحة رقم 7
Table of Contents Configuring a Wired Ethernet Connection....................................................................... 64 Step1: Configure the Panel’s Wired IP Settings.............................................................. 64 IP Settings section - Configuring a DHCP Address over Ethernet......................................... 64 IP Settings section - Configuring a Static IP Address over Ethernet...................................... 65 Step 2: Choose a Master Connection Mode
ملخص المحتوى في الصفحة رقم 8
Table of Contents Calibration Page................................................................................................................... 105 Secondary Connection Page ............................................................................................... 105 System Connection Page..................................................................................................... 109 Programming ................................................................................
ملخص المحتوى في الصفحة رقم 9
Introduction Introduction The NXT/D-CV7 7" Modero Widescreen Color Video Touch Panels (FIG. 1) are the industry’s first widescreen mini-touch panels and are available only through AMX. NXD-CV7 (front view) NXT-CV7 (front view) (FG2258-02) (FG2258-01) FIG. 1 Sample 7" Video Touch Panels These Color Video (CV) panels display NTSC/PAL/SECAM video formats within variable sized windows. They include a built-in microphone, speakers, audio/headphone connector, and six NetLinx programmable push
ملخص المحتوى في الصفحة رقم 10
Introduction Key features common to both panels include: CV7 panels are based on the latest display technology and support AMX's 4th generation (G4) graphics which provide higher brightness, richer colors, and deeper contrast. The new G4 graphics technology is supported by the latest AMX TPDesign4 Touch Panel Design program (version 2.5 or higher). CV7 panels display eye-catching images and full-motion video on a large 16:9 image format, while providing a wide 100-degree top-to-bottom vie
ملخص المحتوى في الصفحة رقم 11
Introduction CV7 Specifications The following table outlines the specifications for the 7" Widescreen Modero panels. Specifications for 7" Widescreen Video Touch Panels Dimensions (HWD): NXA-RK7: metal rack-mount with black matte finish: (4 RU - rack units high) 6.97" x 19.0" x 0.50" (17.70 cm x 48.26 cm x 1.27 cm) NXT-CV7 (Fully raised): 6.86" x 7.96" x 6.93" (17.40 cm x 20.20 cm x 17.60 cm) NXT-CV7 (Fully lowered): 3.70" x 7.96" x 6.93" (9.40 cm x 20.20 cm x 17.60 cm) NXD-CV7 (wit
ملخص المحتوى في الصفحة رقم 12
Introduction Specifications for 7" Widescreen Video Touch Panels (Cont.) Front Panel Components: Light sensor: Photosensitive light detector for automatic adjustment of the panel brightness (a dim room results in a dimmer LCD display, and a bright room results in a brighter LCD display). Note: The light sensor can be adjusted via the Sensor Setup page (page 101). Motion sensor (PIR): Proximity Infrared Detector to wake the panel when the panel is approached. Activation range: + 45° (left
ملخص المحتوى في الصفحة رقم 13
Introduction Specifications for 7" Widescreen Video Touch Panels (Cont.) Rear Panel Components (Side panel location on NXD-Wall Mount panels) (Cont.): Audio/Video connector: RJ-45 connector for communication of differential audio/video signals to/from the touch panel (panel type dependant). This connector receives Composite video, Stereo (left/right) audio, and microphone audio. Video is received via the NXA-AVB/ETHERNET Breakout Box. Configuring video windows for playback is done usin
ملخص المحتوى في الصفحة رقم 14
Introduction Specifications for 7" Widescreen Video Touch Panels (Cont.) Optional Accessories:: NXT-BP (FG2255-10) - Battery pack for Table Top panels. NXT-CHG Kit (FG2250-50K) - 1 battery charger and 2 NXT-BP batteries PSN2.8: Power Supply (FG423-17) with 3.5 mm mini-Phoenix connector PSN4.4: Power Supply (FG423-45) with 3.5 mm mini-Phoenix connector PSN6.5: Power Supply (FG423-41) with 3.5 mm mini-Phoenix connector Upgrade Compact Flash (factory programmed with firmware): NXA-CFSP12
ملخص المحتوى في الصفحة رقم 15
CV7 Touch Panel Accessories CV7 Touch Panel Accessories The following section outlines and describes the CV7 accessories (both the included and optional). NXA-AVB/ETHERNET Breakout Box (FG2254-10) The NXA-AVB/ETHERNET Breakout Box (FIG. 4) is included as part of the CV7 Kit configuration (panel and box) but can be purchased as a separate accessory. This box facilitates the installation and distribution of video, data, and audio to Modero touch panels located up to 200 feet (60.96 m) from the
ملخص المحتوى في الصفحة رقم 16
CV7 Touch Panel Accessories NXA-AVB/ETHERNET Specifications (Cont.) Rear Components: 6-pin 3.5 mm Phoenix connector for in-bound (left/right channel) audio 4-pin 3.5 mm Phoenix connector for out-bound (from microphone) audio BNC connector (female) for Composite or Chroma (for video-capable panels only) BNC connector (female) for luminance (for video-capable panels only) RJ-45 connector for Ethernet input from the control system 2-pin 3.5 mm Phoenix connector for in-bound power Incl
ملخص المحتوى في الصفحة رقم 17
NXA-AVB/ETHERNET Breakout Box CV7 Touch Panel Accessories Direct Ethernet Audio (CAT5) connect (CAT5) between the PSN power NXA-AVB/ETHERNET supply Breakout Box NXD/T Non-video capable Touch Panels FIG. 6 Sample wiring configuration using CA Modero panels The breakout box unit can be mounted on either a horizontal flat surface or into an equipment rack (by removing the front screws and attaching it to an optional AC-RK). The PSN power supply being used on the NXA-AVB/ETHERNET is dependant on t
ملخص المحتوى في الصفحة رقم 18
CV7 Touch Panel Accessories MIC OUT: 4-pin mini-Phoenix connector, divided into GND, OUT-, and OUT+ terminal connectors. An example of this cable is to strip the terminal ends of a 3.5mm mini-jack and insert them into their respective locations on the Mic Out port. This signal can be fed as a Line Level In to either an amplifier or an AMX VOL card. Either a balanced (+, -, and GND) or unbalanced (+ and GND) audio signal can be connected to this output. Video In BNCs: Feeds either Compos
ملخص المحتوى في الصفحة رقم 19
CV7 Touch Panel Accessories Wiring the NXA-AVB/ETHERNET for Balanced Audio Professional audio equipment will often use balanced audio inputs and outputs, usually on 3-pin "XLR" connectors. A balanced audio signal consists of a pair of wires carrying the audio signal in anti-phase with each other (if one wire carries a positive voltage, the other carries an equal and opposite negative voltage). The advantage of balanced audio over unbalanced audio is its ability to reject external interferenc
ملخص المحتوى في الصفحة رقم 20
CV7 Touch Panel Accessories Product Specifications Modero Table Top Cable Specifications Dimensions (HWD): Length: 10 feet (3.048 m) Connectors: Ethernet RJ-45 connector (White) routes Ethernet signals between the touch panel and the NXA-AVB/ETHERNET Breakout Box. Audio/Video RJ-45 connector (Black) routes differential audio/video signals between the touch panel and the box. 2-pin 3.5 mm mini-Phoenix power connector to route power from the external breakout box to the target panel