Meyer Sound HIGH DEFINITION AUDIO MONITOR HD-1 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

High Definition
HD-1 Audio Monitor
Operating Instructions
The HD-1 High Definition
Audio Monitor* is a self-contained,
precision loudspeaker for near-
field sound reproduction.
Aligned to closely approximate
a true point source radiator, the
HD-1 features exceptionally broad
directivity characteristics. Its time
delay response is tightly controlled,
with minimal deviation from linear
phase across the full frequency
range of its operation. Each unit is
individually factory-calibrated to
ensure un

ملخص المحتوى في الصفحة رقم 2

Setup & Operation Voltage selection and fuse rating chart High IEC mains connector Definition PUSH Audio HD-1 Monitor and power switch Dome tweeter Input connector Voltage selector switch Input sensitivity switch Calibration port (factory use only) Cone low fre- quency driver Impact indicator Indicator LED Locations of HD-1 Loudspeaker Components, Connectors and Controls Power Earth ground Placement  Set the voltage selector switch The HD-1 is designed for “near before you connect and operate

ملخص المحتوى في الصفحة رقم 3

Sensitivity Switch Input Connection Operation  For professional balanced The HD-1 presents a 10 kohm In normal operation, the front- equipment, use the +4 dBu input impedance at a three-pin panel LED will glow green. setting. XLR-type receptacle wired as  For semiprofessional and At high listening levels, the LED follows: consumer unbalanced equip- may flash red on program peaks. ment, use the -10 dBV setting. Pin 1 Audio common This indicates the onset of over- Pin 2 Signal low (-) load, wher

ملخص المحتوى في الصفحة رقم 4

Obtaining Service The HD-1 Monitor is protected To obtain service: 4) You will be given an RA (Return by Meyer Sound’s Limited One- Authorization) number for job 1) Contact your dealer or call Year Warranty. For complete tracking. Refer to this number Meyer Sound. information regarding terms and on shipping materials and in all 2) If you are calling Meyer Sound, conditions, refer to the printed correspondence concerning the have the serial number(s) of the warranty statement that is packed repa