Metra Electronics 99-9305 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION INSTRUCTIONS FOR PART 99-9305
APPLICATIONS
BMW X3
2004-2010
(NON-NAV MODELS)
99-9305
KIT FEATURES
• ISO DIN Head Unit Provision
KIT COMPONENTS
A) Radio Housing • B) ISO Brackets • C) (4) Phillips Screws • D) (4) Phillips ISO Screws
L
D
C
R
B WIRING AND ANTENNA CONNECTIONS
(Sold Separately)
A
• 40-EU10 - European antenna adapter
• 70-9003 - European wire harness
TOOLS REQUIRED:
Flat Blade Screwdriver • Phillips Screwdriver • Drill
1-800-221-0932 www.m

ملخص المحتوى في الصفحة رقم 2

99-9305 TABLE OF CONTENTS Dash Disassembly 2004-2010 BMW X3........................................................................... 1 Kit Assembly ..................................................................................... 2 Final Assembly ................................................................................. 3

ملخص المحتوى في الصفحة رقم 3

DASH DISASSEMBLY 99-9305 BMW X3 2004-2010 (NON-NAV MODELS) A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove the hazard/door lock switch. (Figure A) Unclip and remove the a/c vents 3 above the radio. ( Figure B) 4 Remove (2) Phillips screws on top of the radio/climate control panel fac- B ing down. (Figure C) 5 Unclip and remove the radio/climate control panel. (Figure D) 6 Remove (2) Phillips screws securing the radio. (Figure D) D C 1

ملخص المحتوى في الصفحة رقم 4

99-9305 KIT ASSEMBLY ISO DIN HEAD UNIT PROVISION A 1 Secure the corresponding bracket to the aftermarket radio using the hardware supplied with the radio. (Figure A) NOTE: If the ISO screws supplied with the aftermarket radio are too big, use the supplied (4) Phillips ISO screws. 2 Using a drill screw the radio/bracket B assembly into the dash using the supplied (4) Phillips screws. (Figure B) 3 Position the radio housing over the radio face and secure using the fac- tory hardware. (Figure C) C

ملخص المحتوى في الصفحة رقم 5

99-9305 FINAL ASSEMBLY FINAL ASSEMBLY Locate the factory wiring harness in the dash and make the connection as shown. 1 Metra recomends using the proper mating adapter and making the connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) Re-connect the negative battery terminal and test the unit for proper operation. 2 3 Reassemble radio and dash assemblies in reverse order of disassembly. FINAL WIRING CONNECTIONS Make wiring

ملخص المحتوى في الصفحة رقم 6

99-9305 NOTES 4

ملخص المحتوى في الصفحة رقم 7

99-9305 NOTES 5

ملخص المحتوى في الصفحة رقم 8

99-9305 INSTRUCTIONS 1-800-221-0932 www.metraonline.com © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-9305 REV. 04/26/09