ملخص المحتوى في الصفحة رقم 1
HD5212
Installation and Operation Manual
DO[
{j8
t!lm Radio·
--
ملخص المحتوى في الصفحة رقم 2
HD5212 ~ TABLE OF CONTENTS Introduction 1 Preparation 2 Wiring 3 Installation 4 Front Panel Release 7 Operation 8 Tuner Operation 11 Satellite Radio Operation 13 CD Player Operation 15 MP3/WMA Operation 17 iPod Operation 21 Remote Control 23 Care and Maintenance 24 Troubleshooting 25 Specifications 26
ملخص المحتوى في الصفحة رقم 3
HD5212 ~ &, Introduction Congratulations on your purchase of the Jensen HD5212 Mobile Receiver. It's a good idea to read all of the instructions before beginning the installation. We recommend having your Jensen HD5212 installed by a reputable installation shop. Features Built in HD Radio™ Tuner* Made for iPod XM and Sirius Satellite Radio Ready Supports MP31 WMA files via CD- R/RW, SD card, or USB 24 Station Presets (18 FMI 6 AM) Electronic Detachable Faceplate Rear Pre-amp Line Output 2MB ESP
ملخص المحتوى في الصفحة رقم 4
~ HD5212 Preparation Tools and Supplies NOTE: If the HD5212 is to be installed in a car equipped with an on The following tools and supplies are needed to install the radio. board drive or navigation computer, do not disconnect the battery Torx type, flathead and Philips screwdrivers cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid Wire cutters and strippers causing a short circuit. Tools to remove exist
ملخص المحتوى في الصفحة رقم 5
HD5212 ~ Wiring t-L-------------- ._._..--_ .....-----------=l 1SA t ~I Antenna Connector SIRIUS XM XML XMR Ground (BLACK) TERK XMDJEN100 cables sold separately. Power Antenna (BLUE) Connect to ground TERK XMD1000 Direct Tuner and antenna sold separately. Connect to power antenna terminal or clean, SiriusConnect SC-C1 tuner sold separately. or amplifier. If not used, unpainted part of chassis. tape bare end of wire. ~--~@.. ~ Memory/Battery (YELLOW) * Connect to battery or 12 volt Amplifier Wiri
ملخص المحتوى في الصفحة رقم 6
~ HD5212 Installation This unit is designed for installation in cars, trucks and vans with an existing 5. Place the radio in front of the dashboard opening so the wiring can be radio opening. In many cases, a special installation kit will be required to brought through the mounting sleeve. mount the radio into the dashboard. These kits are available at electronics supply stores and car stereo specialty shops. Always check the kit application before purchasing to make sure the kit works with your
ملخص المحتوى في الصفحة رقم 7
HD5212 ~ 9. Attach one end of the perforated support strap (supplied) to the screw ISO INSTALLATION stud on the rear of the chassis using the hex nut provided. Fasten the other end of the perforated strap to a secure part of the dashboard either above or below the radio using the tapping screw and washer provided. Bend the strap, as necessary, to position it. CAUTION: The rear of the radio must be supported with the strap to prevent damage to the dashboard from the weight of the radio or imprope
ملخص المحتوى في الصفحة رقم 8
~ HD5212 Removing the Radio y~~.:.~ To remove the radio after installation, ,,:....._.-:.y,~. remove the trim ring by pulling outward on one side and then the other. Insert the removal keys straight back, with the notches facing up, until they lock. With o the removal keys engaged, pull the radio straight out. If removal keys are REMOVAL KEYS inserted at an angle, they will not lock properly to release the unit. Connecting the Satellite Radio Receiver (optional) Before you can listen to satellit
ملخص المحتوى في الصفحة رقم 9
HD5212 ~ Front Panel Release Do not expose the front panel to high temperatures or direct sunlight. The'" (open) button (9) releases the mechanism that holds the front panel Keep all volatile agents (e.g. benzene, thinner, or insecticides) from to the chassis. touching the front panel Detaching the Front Panel Do not attempt to disassemble the front panel. To detach the front panel: 1. Press and hold the power button (1) to turn the unit off. 2. Press the open button (9) and allow the front pane
ملخص المحتوى في الصفحة رقم 10
~ HD5212 Operation Press the rotary encoder repeatedly to step through the following audio: Power VOLUME, BASS, TREBLE, BALANCE, and FADER. The unit automatically Press the (!) (power) button (1) or any other button on the front of the radio exits audio control mode after five seconds of inactivity. (except release) to turn the unit on. Press and hold the power button to turn the unit off. Liquid Crystal Display (LCD) The liquid crystal display (LCD) panel (8) displays the frequency, time and ac
ملخص المحتوى في الصفحة رقم 11
HD5212 ~ Setting the Clock Menu Operation If not already showing, press the DISP button (7) to display the clock. With Press and hold the rotary encoder (4) to access the system menu. the clock displayed, press and hold the DISP button and the time will flash Repeatedly press the rotary encoder button to access menu options in the on the display. Press the TUNE/CH » button (10) to adjust the hours or the following order: TUNEICH « button (11) to adjust the minutes. When in "HOURS 12" BEEP ON/OFF
ملخص المحتوى في الصفحة رقم 12
~ HD5212 Reset Button The RESET button is located behind the front panel and should be activated for the following reasons: initial installation of the unit when all wiring is completed function buttons do not operate error symbol on the display Use a ball point pen or thin metal object to press the RESET button. This may be necessary should the unit display an error code. 10
ملخص المحتوى في الصفحة رقم 13
HD5212 ~ Tuner Operation Press the SRC button (2) to switch to HD RADIO mode. TUNE/CH « buttons to move the radio frequency number up or down one step. About HD Radio™ Technology Auto Seek Tuning HD Radio technology allows CD-quality digital broadcasting of your local Press the TUNE/CH »(10) or TUNE/CH « (11) button to automatically AM and FM radio stations. HD Radio broadcasts can include multiple seek the next station. channels on the same frequency, which is called multicasting. With Mono/Ste
ملخص المحتوى في الصفحة رقم 14
~ HD5212 NOTE: HD Radio multicast channels can be stored as preset stations. Recall a Station Select a band (if needed). Press a preset button (13-18) to select the corresponding stored station. Preset Scan Scans stations stored in all FM or AM bands. Select a band (if needed), and then press the PS button (21). The unit will pause for 5 seconds at each preset station. Press the PS button again to stop scanning when the desired station is reached. Broadcast Information During HD Radio broadcasti
ملخص المحتوى في الصفحة رقم 15
HD5212 ~ Satellite Radio Operation Selecting a Station Listeners can subscribe to XM® Radio on the Web by visiting Press the TUNE/CH » or TUNE/CH « button (10 and 11) to change to www.xmradio.com. or by calling (800) 967-2346. Customers should another station. Press and hold the TUNE/CH » or TUNE/CH « button for have their Radio ID ready (see "Displaying the Identification (ID) Code"). Customers can receive a limited number of free-to-air more than one second to fast forward or fast reverse thro
ملخص المحتوى في الصفحة رقم 16
~ HD5212 6. Press the BAND/ENTER button to enter the second number and move to the third position. NOTE: Use the TUNEICH» or TUNElCH« button (10 and 11) to move between the first and third positions. 7. Turn the rotary encoder again to select the third digit of the channel you want to tune to (0 - 9). 8. Press the BAND/ENTER button to enter the third number and access the channel. Category Mode To select stations in a specific category, perform the following steps. 1. Press the SELECT button (5)
ملخص المحتوى في الصفحة رقم 17
HD5212 ~ CD Player Operation cop mode can only be accessed when a disc is inserted. If a disc is will appear on the display. Press and hold the TUNE/CH » (10) or TUNE/ CH « (11) button for more than one second to fast forward or fast reverse already in place, press the SRC button (2) to access COP mode and begin playback automatically. through the disc. CD play starts when the button is released. Insert CD Intro Scan (SCN) Press the open button (9) During disc play, press 2/SCN (14) to play the
ملخص المحتوى في الصفحة رقم 18
~ HD5212 ejecting and reloading the disc into the player. While the disc is out of the unit, make sure it is clean and undamaged, and then load it correctly. If this does not solve the problem, pressing the reset button may help, but will erase the time and preset memory. If the suggested measures do not solve the problem, contact an authorized warranty station near you or contact customer service at 1-800-323-4815 for further assistance. Electronic Shock Protection (ESP) This unit is equipped w
ملخص المحتوى في الصفحة رقم 19
HD5212 ~ MP3/WMA Operation MP3 and WMA (Windows Media Audio) music files are digital audio files MP3IWMA Encoder and CD Writer Settings that are compressed to allow more files on a single CD. This unit can play Use the following settings when compressing audio data in MP3 data with MP3/WMA directly from files contained on a CD-R/RW, SO card or USB the MP3 encoder. device using the buttons on the receiver (or optional remote control) as Transfer bit rate: 32 - 320 kbps described below. Many types
ملخص المحتوى في الصفحة رقم 20
~ HD5212 File Playing Order Installing a USB Device When selected for play, files and folders (Folder Search, File Search or Gently lift the rubber USB slot cover (22) from the top and pull it down. Folder Select) are accessed in the order they were written by the CO writer. Insert your USB thumb drive into the USB slot on the front of the radio. The . As a result, the order in which they are expected to be played may not unit will automatically search for MP3 and WMA files on the device and mat
