Jacuzzi OPTICATM 300 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

™
OPTICA 300
SHOWER MIXER/TRANSFER VALVE
INSTALLATION INSTRUCTIONS
FINISHING WALL
TILE (FINISH SURFACE)
SEALANT (SILICONE) ON BACKSIDE OF
FACEPLATE
FACEPLATE (SEALANT NOT PROVIDED)
2-3/8" DIA.
GASKET
TRIM SLEEVE OF TRANSFER VALVE
REAR VIEW
LEFT-HAND THREAD TO
SWEAT ADAPTOR (NOT PROVIDED)
4-15/16" MINIMUM
COPPER PIPE (NOT PROVIDED)
FEMALE THREAD TO SWEAT ADAPTOR
(NOT PROVIDED)
SEALANT (100% SILICONE) ON BACKSIDE OF
FACEPLATE (SEALANT NOT PROVIDED)
NOTE: WHEN INSTALLING BAND, RING, ROPE
OR FACE

ملخص المحتوى في الصفحة رقم 2

INSTALLATION INSTRUCTIONS 4. Rotate the cartridge (1) so the words “hot side” (2) appear on the left. Insert cartridge into valve body as WARNING: Failure to follow these instructions could shown. Make sure the cartridge tubes and o-rings (3) prevent the mixer/transfer valve from functioning are properly seated in holes at the base of the body. properly. Ensure the keys on the body are fully engaged with the 1. Shut OFF water supplies. slots in the body (4). 2. Install the body (1) so

ملخص المحتوى في الصفحة رقم 3

8. Slide bonnet nut (1) over the cartridge and thread WARNING: In some instances, setting the Rotational onto the body. Hand tighten securely. Limit Stop in the hottest position (full counterclock- wise) could result in scald injury. It is necessary to adjust the Rotational Limit Stop so that the water coming out of the valve will not scald the user when the handle of the valve is rotated to the hot side. Adjust rotational limit stop. After water has run a suffi cient length of time so t

ملخص المحتوى في الصفحة رقم 4

HELPFUL HINTS: 1. Before removing cartridge assembly for any maintenance, be sure to note the position of the stop on the cap. The cartridge assembly must always be put back in the same position. For normal installations, the stop on the cap will face the left. To be safe, after you have fi nished the installation turn ON valve to make sure cold water fl ow fi rst. 2. To remove cartridge from body, shut OFF water supplies and remove handle, trim sleeve and bonnet. Place handle on stem and

ملخص المحتوى في الصفحة رقم 5

WARNING: This is a guide to help you set the Rotational Limit Stop. This is only a guide and should be verifi ed by following the instructions on setting the rotational limit stop given in this installation and instruction sheet. MIX TEMPERATURE-VS-POSITION OF ROTATIONAL LIMIT STOP APPROXIMATE MIX TEMPERATURE (°F) WITH VARYING INLET TEMPERATURES Cold Hot Cold Hot Cold Hot Cold Hot Cold Hot Cold Hot Cold Hot Cold Hot Setting of limiter 50°F 160°F 50°F 120°F 70°F 120°F 50°F

ملخص المحتوى في الصفحة رقم 6

This page left blank. CAUTION Since plumbing fi ttings may contribute detectable amounts of lead to water, the following notice is required by Califor- nia law ( Proposition 65). "This product contains a chemical known to the State of California to cause birth defects or reproductive harm." In normal use, any lead exposure can be minimized by allowing the water to run free for several seconds before drinking. Proper Installation of the fi ll spout and compliance with local codes is the respons