ملخص المحتوى في الصفحة رقم 1
ملخص المحتوى في الصفحة رقم 2
FCC Warning The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with radio communications. However, there is no guarantee that radio interfe
ملخص المحتوى في الصفحة رقم 3
Table of Contents English Español FCC Warning .................................................... 2 Advertencias FCC ........................................ 36 Owner’s Record ................................................ 2 Registro del Propietario ................................ 36 Features ............................................................ 4 Características..............................................37 Precautions ....................................................... 4 Preca
ملخص المحتوى في الصفحة رقم 4
ENGLISH Features Congratulations on your purchase of this Blaupunkt Cassette Receiver. Its Codem III-US FM/AM Tuner and Autoreverse Cassette Tape Player mechanism provide the ultimate in radio sound reproduction. Its high-power amplifier and 4-Channel preamp output provide you with tremendous system configuration flexibility. Its ability to control the Blaupunkt CDC-A05 and CDC-A071 CD Changers lets you easily incorporate CD sound into your car’s sound system. • Audio Features: • Codem III-US Tu
ملخص المحتوى في الصفحة رقم 5
E Detachable Face N Detaching & Attaching the Face: The face of this unit can be detached and taken with you to prevent it from being stolen. G Detaching the Face: L Press the REL (Release) Button and detach the face by gently pulling it off as illustrated. I Note: Do not pull it straight out from the chassis. Be sure not to drop the face when detaching it S from the chassis. H Attaching the Face: Apply the right hand side of the face to the chassis by sliding (part B) of the face to (part A) at
ملخص المحتوى في الصفحة رقم 6
Electrical Connections and Installation @/#&*>@! To avoid the aggravation of costly mistakes and serious damage that could make you feel this way, please carefully read all of the instructions before you begin. Carefully follow all instructions. You’ll be glad you did! GENERAL RECOMMENDATIONS • If you’re not confident that you can install the unit correctly, have it installed by a qualified Blaupunkt installation technician. • Use this unit only with negative ground 12 Volt (11-16 Volt) direct
ملخص المحتوى في الصفحة رقم 7
• You can connect the 2 RCA preamp outputs to multiple external amplifiers and power multiple speakers or speaker systems through the amplifiers. (Blaupunkt amplifiers and speakers available separately). To add front preamp output, purchase Blaupunkt part 8 634 494 218, which is included in the CDC-A05 and CDC-A071 changer’s harnesses. • You can use a either or both of these two methods. Connecting the Speaker Leads To prevent short circuits or serious damage to the unit and/or speakers: • Conne
ملخص المحتوى في الصفحة رقم 8
Installation Recommendations • Carefully choose the mounting location so that the unit won’t interfere with normal driving. • Avoid mounting locations where the unit would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would subject to dust, dirt or excessive vibration. • The illustration below shows a typical installation, however, you may need to adjust the installation, depending on the unit. If you have questions or need additional insta
ملخص المحتوى في الصفحة رقم 9
Mounting the Unit in a Japanese Car You may have difficulty mounting this unit in some Japanese cars that have ISO mounting features (side-bracket mounting systems). In this case, consult your Blaupunkt dealer. 1 Run a blade along the slits on the back of the front trim ring, unscrew the two side screws, and separate it from the unit. Save the trim ring and related hardware in case you ever want to install the unit in another vehicle. 2 Use the vehicle’s own mounting hardware to attach the unit.
ملخص المحتوى في الصفحة رقم 10
Maintenance Removing the Unit Use the Release Keys as shown below. Keep them in a safe place in case you need them in the future. Fuse Replacement When replacing the fuse, be sure to use one with the correct amperage, which will be stated on the fuse case. Never use a fuse that has a stated amperage exceeding the one supplied for this unit, as this could cause malfunction and serious damage to the unit. 10
ملخص المحتوى في الصفحة رقم 11
Specifications Audio Power Specifications Power Output and Total Harmonic Distortion: 13 watts per channel minimum continuous average output into 4 ohms, 4 channels driven, from 30-15,000 Hz with no more than 1% total harmonic distortion. Other Specifications Tuner FM Tuning Range: 87.5 - 107.9 MHz Intermediate Frequency: 10.7 MHz FM Mono Sensitivity: 13 dBf Seek lo sensitivity: 51 dBf Seek sensitivity 31 dBf Selectivity: 80 dB at 400kHz Signal-to-Noise Ratio: 65 dB (stereo), 70 dB (mono) Harmon
ملخص المحتوى في الصفحة رقم 12
Location of Controls 1. REL (Release) Button Balance Right 2. PWR (Power) Button Fade to Rear 3. Source (and Radio Band) Select 14. /\ Button 4. Cassette Eject Seek and Manual Tuning 5. Mute/ Audio Button/ Clock Adjust:00 CD Track Up 6. SCA (Scan) TS (Travel Store) Audible CD Cue 7. LD (Loudness)/ SENS (Tuning Sensitivity) Clock Hours 8. Cassette Insertion Slot 15. V Button 9. CLK/Display Change Seek and Manual Tuning 10/11. Tape Program Change (reverse) CD Track Down 10. Fast Rewind Audible C
ملخص المحتوى في الصفحة رقم 13
Ignition-Off Clock Recall Any button press while ignition off displays time for about 8 seconds. Ignition-On Unit lights up and clock is displayed. Release for Detachable Faceplate Push REL to detach face. Already-inserted cassette remains in unit. Current settings and source mode are stored. If power was not switched off before face removed, unit will automatically power- on when face is reattached. Power (PWR) On/Off When ignition on, press PWR or insert a disc to turn unit on. Last-used sourc
ملخص المحتوى في الصفحة رقم 14
Bass -Adjust from +7 to -7 at 2 dB/step using + to increase bass, - to decrease. Treble - Adjust from +7 to -7 at 2 dB/step using + to increase treble,- to decrease. Balance - Adjust balance from 9 (all the way left) using + to -9 (all the way right) using –. Fader - Adjust fader from 9 (sound only from the front) using + to -9 (sound only from the rear) using –. Loudness (LD) Press LD to increase sound of low and high frequencies. LOUD icon appears. To cancel, press LD again. Radio Operation La
ملخص المحتوى في الصفحة رقم 15
Δ seconds to store current frequency. Audio is muted during storage, preset number appears, and beep acknowledges storage. Preset Station Selection Press desired Preset Button. Travel Store This feature allows you to automatically store stations onto all 5 preset buttons and is especially useful when traveling outside your normal listening area. In any FM Bank, press SCA/TS for 2 seconds to activate FM Travel Store. (In AM Bank, press it for 2 seconds to activate AM Travel Store.) TS appears. Be
ملخص المحتوى في الصفحة رقم 16
Changer Control (When optional changer is connected.) Your receiver is ready to control a Blaupunkt CD changer with the Disc Management System, such as the CDC-A05 or CDC-A071 changers. See your Blaupunkt dealer for more information. Activating Changer Press SRC as many times as necessary to access Changer Mode, which is indicated in display by Track Number/Disc Number display. Display Options See page 13 for display options. In changer mode, the first press of DISP Button during temporary displ
ملخص المحتوى في الصفحة رقم 17
Track Scan Press SCA to start Track Scan. Track Number blinks during scanning operation. Unit stops at each track for 10 seconds. After scanning all tracks on disc, unit advances to next disc. Unit continuously scans until user stops scan by pressing SCA, another playback control or SRC. Track Scan deactivates any previously-active MIX or RPT modes. Disc Scan Press and hold SCA for more than 2 seconds to start Disc Scan. Disc Numbers blink during scanning operation. Unit stops at first track on
ملخص المحتوى في الصفحة رقم 18
German Headquarters: Blaupunkt-Werke GmbH Postfach 77 77 77 D-31132 Hildesheim Germany Robert Bosch Corporation Sales Group — Blaupunkt Division 2800 South 25th Avenue, Broadview, Illinois 60153 1-800-950-BLAU Robert Bosch, SA., DE, C. V. Dr. Lucio 270 Cols. Doctores, Mexico 06720 Made in Malaysia Fabrique en Malasie Hecho en Malasia Fabricado en Malaysia Copyright 1997 by the Robert Bosch Corporation No portion of this work may be reproduced in any form without the written consent of the Robert