ملخص المحتوى في الصفحة رقم 1
Radio / Cassette
Trier
RCR 126
Operating instructions
BA Trier RCR 126 d® 1 13.05.2002, 11:49 Uhr
ملخص المحتوى في الصفحة رقم 2
1 2 3 4 5 6 7 8 9 12 13 10 11 14 19 18 17 16 15 3 BA Trier RCR 126 d® 3 13.05.2002, 11:49 Uhr PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH
ملخص المحتوى في الصفحة رقم 3
Contents Short instructions ........................ 17 Scanning stations with Radio-Scan ...... 24 Selecting the seek tuning sensitivity ..... 24 Important notes ............................ 20 Switching from stereo to mono (FM) ..... 24 Precautions ........................................... 20 Receiving traffic programme Traffic safety ......................................... 20 stations with RDS-EON ................ 25 Installation/Connection .......................... 20 Traffic announceme
ملخص المحتوى في الصفحة رقم 4
Short instructions 1 On Off 2 LD GEO – Volume Loudness - When listening at a low To adjust the balance (left/right) and level, the Loudness function creates a fader (front/rear) with the rocker switch. more natural sound by boosting the low frequency range. To switch the Loudness on/off: Press LD. For more information, read chapter This unit can also be switched on and “DSC programming”. off with the KeyCard B. Fader front Also, when being connected correctly, Fader rear Balance left you may t
ملخص المحتوى في الصفحة رقم 5
4 DSC (Direct Software Control) 7 lo/dx : Display Use the DSC function to customise To alter the automatic seek tuning sen- Radio operation: certain programmable, basic settings to sitivity. suit your personal needs and prefe- If “lo” is displayed, the radio will only rences. See chapter “DSC pro- pick up strong, local stations (low sensi- gramming” for more information. tivity). NDR1 NDS - Station abbreviation or If “lo” does not light up, the radio will frequency also pick up weaker, distant s
ملخص المحتوى في الصفحة رقم 6
; PROG button/Fast winding > 1, 2, 3, 4, 5, 6 - preset buttons A FM You can store six stations on each FM To select one of the FM memory banks To switch to the other side of the memory bank (I, II, T). I and II. cassette tape: To store a station: Press button during To change the memory bank: Press both buttons simultaneously. radio operation and hold down until the Press button until the desired level is The display shows TR1-PLAY or TR2-PLAY. radio resumes play. indicated in the display. To re
ملخص المحتوى في الصفحة رقم 7
Important notes Precautions C Rocker switch Installation/Connection Seek tuning Before starting to use your new car radio, If you would like to install this equipment please read the information on “Traffic safe- yourself or add any new components, please ty” and “KeyCard theft-protection System” read the enclosed installation and connec- carefully. tion instructions carefully. Do not connect the loudspeaker outputs to ground! Traffic safety Up Use only the accessory and replacement As the drive
ملخص المحتوى في الصفحة رقم 8
KeyCard theft-protection system This car radio is supplied with one KeyCard After approximately 10 seconds, the display • Press the KeyCard in, which releases as standard. will show “TURN OFF”. Now turn off the set. the card and puts it in the proper positi- However, the unit can also be operated with When inserting a card of a different kind (like on for being removed. a second card. for example a credit card), the display will • Remove the first KeyCard and insert If you have lost or damaged y
ملخص المحتوى في الصفحة رقم 9
Radio operation with RDS (Radio Data System) Optical indication for extra The Radio Data System offers you more stored frequencies, the unit is automatically security convenience when listening to FM radio sta- searching for an alternative frequency. tions. “SEARCH” will disappear from the display When the car is stationary, the KeyCard More and more radio stations have begun to when the alternative frequency has been tongue can be switched to flash for extra anti- broadcast RDS information alon
ملخص المحتوى في الصفحة رقم 10
• Press the REG button briefly. When holding the right or left part of the Changing the memory bank rocker switch pressed down, the frequency When active, “REG ON” will be briefly dis- You can shift between the memory banks I, II, scan is speeded up. played each time the radio is switched on. and T to store and recall preset stations. The selected memory bank is indicated in the Scrolling through the broad- Automatic tuning / display. casting network (only FM) • Press FM or TS until the desired
ملخص المحتوى في الصفحة رقم 11
Automatically storing the stron- • Press PS. Selecting the seek tuning sensi- gest stations with Travelstore The radio will briefly play all the stored tivity stations one after another. You can automatically store the six most You can alter the automatic seek tuning The system will sample the stations of one of powerful FM stations of your current recepti- sensitivity. the memory banks I, II, or T, depending on on area sorted according to their signal If “lo” is displayed, the radio will only p
ملخص المحتوى في الصفحة رقم 12
Receiving traffic programme stations with RDS-EON Many FM broadcasters offer traffic messa- Traffic announcement priority b) Switch off the priority for traffic an- ges for their service area at regular intervals. on/off nouncements: All traffic programme stations transmit a spe- • Press TA. If the priority for traffic announcement pro- cial carrier signal alongside their program- “TA” will disappear from the display. grammes is activated, “TA” will light up in the mes, which is decoded by your
ملخص المحتوى في الصفحة رقم 13
Tape operation Inserting a tape Fast Forward/Rewind PROG selector (To change the tape direction during • Turn on the set. Fast Forward cassette playback) • Press FF. • Insert a tape. At the end of a tape side, the mecha- • Press FR and FF simultaneously. nism changes directions automatically At the end of a tape side, the mechanism Insert the tape with side A or 1 showing up, the to play the other side. open side facing to the right. changes directions automatically to play the Stopping Fast For
ملخص المحتوى في الصفحة رقم 14
DSC programming DSC (Direct Software Control) allows you to TA VOL To adjust the traffic an- LOUD Loudness - When listening customise certain programmable, basic set- nouncement volume from at a low level, the Loud- tings to suit your personal needs and prefe- between 1 to 9. The mes- ness function creates a rences and then store them. sage will then come more natural sound by The basic settings for this audio equipment through at this volume. boosting the low frequency were made at the factory.
ملخص المحتوى في الصفحة رقم 15
Appendix LEARN KC To “define” a second Key- Specifications Care notes Card for use with the set. Mechanism/cassette tapes Amplifier Please read the information Output power: 4 x 20 W RMS power To avoid possible problems, you should not under “KeyCard theft-pro- acc. to DIN 45324 use cassette tapes longer than 60 or 90 tection system”. (14,4V), minutes (C60/C90). Store your tapes in a 4 x 30 W max. power cool place away from dirt, dust and tempera- To quit the DSC programming mode and tures excee
ملخص المحتوى في الصفحة رقم 16
Blaupunkt-Werke GmbH Bosch Gruppe 8/96 K7/VKD 8 622 400 772 BA Trier RCR 126 d® 16 13.05.2002, 11:50 Uhr
