ملخص المحتوى في الصفحة رقم 1
ملخص المحتوى في الصفحة رقم 2
ملخص المحتوى في الصفحة رقم 3
MPX6411 TABLE OF CONTENTS TABLE DES MATIÈRES Introduction ..............................................................................................1 Introduction ............................................................................................37 Preparation ..............................................................................................2 Préparation ............................................................................................38 Wiring ................
ملخص المحتوى في الصفحة رقم 4
MPX6411 ii
ملخص المحتوى في الصفحة رقم 5
MPX6411 General INTRODUCTION • PTM - Personal Text Message Congratulations on your purchase of the Jensen MPX6411 Mobile Receiver. It’s a good idea to • Allows up to 32 character personal message read all of the instructions before beginning the installation. We recommend having your • User friendly setup menu Jensen MPX6411 installed by a reputable installation shop. • LCD contrast control • LCD dimmer control Features •Clock XM READY • Selectable display priority • Requires Terk XMD1000 Tune
ملخص المحتوى في الصفحة رقم 6
MPX6411 PREPARATION Tools and Supplies The following tools and supplies are needed to install the radio. • Torx type, flathead and Philips screwdrivers • Wire cutters and strippers • Tools to remove existing radio (screwdriver, socket wrench set or other tools) • Electrical tape • Crimping tool • Volt meter/test light • Crimp connections • 18 gauge wire for power connections • 16-18 gauge speaker wire SPEAKER REQUIREMENTS: Only connect speakers rated in the load impedance of 4 ohms. Speakers wi
ملخص المحتوى في الصفحة رقم 7
MPX6411 WIRING Wiring with a Wiring Adapter (Purchased Separately) Connect Wires You can make all these connections without even being in the vehicle. 1. Splice or crimp wires. 2. Attach wiring adapter to the car wiring harness. Wiring Diagram / Color Codes 1. Power Antenna (dark blue wire) - Connect to the power antenna or a amplifier. If not used, tape the bare end of wire. 2. Ground (black wire) - Connect to the ground terminal or a clean, unpainted part of the chassis. 3. Memory
ملخص المحتوى في الصفحة رقم 8
MPX6411 Fuses INSTALLATION When replacing a fuse, make sure the new fuse is the correct type and amperage. Using an This unit is designed for installation in cars, trucks and vans with an existing radio opening. In incorrect fuse could damage the radio. The MPX6411 uses one 15 amp fuse located below the many cases, a special installation kit will be required to mount the radio to the dashboard. wiring connector (15 amp fast blow ATO). These kits are available at electronics supply stores and
ملخص المحتوى في الصفحة رقم 9
MPX6411 5. Place the radio in front of the dashboard opening so the wiring can be brought through the 2. Install the radio/mounting plate assembly to the sub-dashboard according to the mounting sleeve. instructions in the installation kit. 3. Attach the support strap to the radio and dashboard as described in the Universal Installation instructions. 4. Replace the dashboard trim panel. ISO Installation This unit has threaded holes in the chassis side panels which may be used with the original
ملخص المحتوى في الصفحة رقم 10
T T T T C C C C L L L L E E E E E E E E S S S S H H H H S S S S PU PU PU PU MPX6411 Balance OPERATION To adjust the balance from “L12” (full left) to ”R12” (full right), press the volume control until Power “BAL” appears in the display. Rotate the control clockwise or counter-clockwise to adjust the Press the power button (1) or any other button on the front of the radio (except Eject) to turn balance between the left and right speakers. “C00” represents a center balance. the unit on. Press
ملخص المحتوى في الصفحة رقم 11
MPX6411 Display Options NOTE: The XM Scroll option only appears when an XM box is connected. Press DISPLAY/MENU (7) to navigate through the following options: • Tuner: FREQ > Spectrum > PTM Message Clock Format • CDP/MP-3/WMA: Elapsed Time > Spectrum > PTM Message This option allows selection of a 12 hour or 24 hour clock format. “CLK FORMAT 12H” is the • XM mode: Category Name > Artist Name > Song Title > Spectrum > PTM Message > default setting. Rotate the volume control to change to the 24
ملخص المحتوى في الصفحة رقم 12
MPX6411 character, press in on the volume control to move to the next space and select the next Theft Deterrent LED character. To leave a blank space, press the volume control again. A light-emitting diode (LED) is located on the chassis behind the front panel and will flash when Greeting Note the panel is removed. The flashing light serves as a visual warning to the would-be thief that When the unit is powered on, one of three greetings is displayed based on the time of day: the unit has be
ملخص المحتوى في الصفحة رقم 13
MPX6411 Automatically Store / Preset Scan TUNER OPERATION Automatically Store The MPX6411 comes equipped with a World Tuner, allowing you to receive channels in USA, Automatically select six strong stations and store them in the current band. Select a band (if EUROPE, LATIN, & OIRT (Russia). See “Frequency Spacing” on page 7 to learn how to needed). Press AS/PS (21) for more than three seconds. The new stations replace any change the World Tuner options. stations already stored in that band
ملخص المحتوى في الصفحة رقم 14
MPX6411 Preset Scan ® XM RADIO OPERATION 1. Press AS/PS (21) for < 3 seconds. The unit pauses for 5 seconds at each preset station ® for all three bands (XM-1, XM-2, and XM-3). Listeners can subscribe to XM Radio on the Web by visiting www.xmradio.com, or by 2. Press AS/PS again to stop scanning when the desired station is reached. calling (800) 967-2346. Customers should have their Radio ID ready (see “Displaying the Identification (ID) Code”). Customers can receive a limited number of free-
ملخص المحتوى في الصفحة رقم 15
MPX6411 Random (RDM) CD PLAYER OPERATION Press RDM (15) during disc play to play all tracks on a CD in random, shuffled order. Press Insert and Eject CD RDM again to stop random play. Press the eject button (22) and let the motorized front panel swing-down to display the CD slot. Display CD Text Insert a CD label side up. After inserting a CD, the front panel will close automatically. To stop CD play and eject the CD, press the eject button. After ejecting the CD, the unit will close Press A
ملخص المحتوى في الصفحة رقم 16
MPX6411 Entering ID3 Tag MP3/WMA OPERATION This unit supports ID3 tag versions 1.0 and 1.1. MP3 and WMA (Windows Media Audio) music files are digital audio files that are compressed For the character codes, refer to the table to the to allow more files on a single CD. This unit can play MP3/WMA directly from files contained on right. The unit also supports CD-TEXT encoded a CD-R/RW using the buttons on the receiver (or optional remote) as described below. Many discs for Album, Track and Ar
ملخص المحتوى في الصفحة رقم 17
MPX6411 For example, a medium with the following folder/file hierarchy is subject to Folder Search, File Intro Scan (SCN) Search or Folder Select as shown below. During disc play, press SCN (13) to play the first 10 seconds of each track on the disc. When the desired track is reached, press SCN again to end the scan and play the selected track. Press SCN for more than three seconds to play the first 10 seconds of each track in the current folder. When the desired track is reached, press SCN
ملخص المحتوى في الصفحة رقم 18
MPX6411 CD Changer Error Codes CD CHANGER OPERATION If problems arise during CD changer operation, the following error codes may appear in the Please call Jensen technical support at 1-800-323-4815 for a complete list of CD changers display: compatible with this unit. The following Jensen CD Changers are compatible with this unit: ER-1: No magazine loaded in the CD changer. ER-2: Problem in the disc loading function. JCH10RF and CH1001. ER-3: Error in the disc loading function. ER-4: Error i
ملخص المحتوى في الصفحة رقم 19
MPX6411 REMOTE CONTROL CARE AND MAINTENANCE The remote control will allow you to control the basic functions of the MPX6411. CD Player The remote control sensor is at the top left of the IX-BASS (18) button. The following guidelines will help you extend the life of your CD player: 1. When cleaning the vehicle interior, do not get water or cleaning fluids on the unit. 2. The CD player will not operate properly in extreme hot/cold or under damp conditions. In case of such conditions, wait until
ملخص المحتوى في الصفحة رقم 20
MPX6411 TROUBLESHOOTING SPECIFICATIONS Problem Cause Corrective Action Does not operate No power to yellow wire; Check connection with test light; (display does not no power to red wire check vehicle fuse with test light. light) Inline fuse blown Replace fuse. No power to unit Inline fuse blown Check/replace fuse. No speakers oper- Speaker harness not con- Connect speaker harness; check ate (display lights nected speaker wires. normally) Not all speakers Incorrect splices or con- Check all spl
