ملخص المحتوى في الصفحة رقم 1
CT-X418 w
STEREO CAR CASSEITE RECEIVER
RADIO-CASSEllE ESTEREOFONICOPARA AUTOMOVIL
OWNER’S RECORD
For your convenience, record the model number and
serial number (you will find them on the right side of
yourset) inthespace provided below. Please referto
the,m when you contact your AIWA dealer in case of
difficulty.
Model No. ICT-X418
Serial No. ~
ملخص المحتوى في الصفحة رقم 2
NOTE Welcome This equipment has been tested and found to Thank you for your purchasing thisAIWA product. comply with the limits for a Class B digital device, To optimize the performance of this unit, please pursuant to Parf 150fthe FCC Rules. These read through this manual carefully. limits are designed to provide reasonable protection against harmful interference in a In addition to this operating instructions manual, residential installation, be sure to refer to the separate installation and T
ملخص المحتوى في الصفحة رقم 3
TABLEOFCONTENTS FRONT PANEL ................................................................................................................................... 3 DETACHING AND ATTACHING THE FRONT PANEL ..... ....................................................... .... ... 4 SETTING THE BEEP TONE ............................................................................................................... 5 SETTING THE CLOCK .......................................................................
ملخص المحتوى في الصفحة رقم 4
FRONTPANEL Displaywindow @ DISP (display) button @H-BASS button @LO (locai/DX) button @ PWR (power onloff) button @ SEL (select) button @CD IN button @Band indicator @ +/- (sudio control) button @Main display section @ EJECT & button @H BASS indicetor @ Csssette compartment @ST (stereo) indicator @ DIRECTION+/* button @ICRP (CD changer ready position) @BAND button @ CRP (CD changer ready position) button indicator @LO (local) indicator @~ (release) button @AM/PM indicator @ITUNE VIA buttons @Aud
ملخص المحتوى في الصفحة رقم 5
Attachingthe front panel DETACHING AND / ATTACHING THEFRONT PANEL 2 1 You can detach the front panel from the unit and SecurityLamp carry it with you when you leave your car When the front panel is detached, you can find an unattended. LED lamp on the front side of the unit. This lamp When you carry the front panel out of your car, is designed to deter theft, and continues to flash use the supplied earring case. when the car’s ignition is turned off with the front Before detaching the front pane
ملخص المحتوى في الصفحة رقم 6
SETTING THECLOCK SETTING THEBEEP TONE The unit is preset at the factory to beep each time 1 3 you press any button on the front panel except OPEN. You can stop beeping by following the procedure below. 2;4 1 Press PWR. 2 Press and hold down DISP for more than 1.5 seconds until the clock ~ With the unit off, prees 1 and 4 at the indication flashes. same time. ● If you do not proceed with step 3 within 5 The “BEEP indication appears. seconds, the clock indication disappears. Each time you press th
ملخص المحتوى في الصفحة رقم 7
PWR TUNE T/A RADIOOPERATION 1 32 l-o LO(local/DX)button You can use Local mode when you wish to tune in only strong stations during seek tuning. In Radio mode, press LO to select Local mode. The 4 “LO indicator lights up. ● Press LO to deactivate Local mode and switch 2 Press PWR to turn the unit on. to DX (distance) mode. The radio frequency appears. ● The “ST” (stereo) indicator lights up when the 2 Press BAND to select the band from tuned-in station is broadcasting in stereo and among FM1, FM
ملخص المحتوى في الصفحة رقم 8
PRESETTING STATIONS 1 T 3 1 Press BAND to select tha band from among FMI, FM2, FM3 and AM. 2 Tune in the station that you wish to 1 Press BAND to select a desired band praset with TUNE T or TUNE A. from among FMI, FM2, FM3 and AM. 3 Preae one of the Dreeet station buttons 1 to 6 for approximately 1.5 seconds. The number of the pressed preset station Pm3 button appears next to the frequency indication. 2 Press and hold A.ME for more than 1.5 seconds to activate the automatic praseting function. T
ملخص المحتوى في الصفحة رقم 9
TAPEPLAYBACK 1 21 2 1 fnsert a cassette to start playback. ~ Press BAND to select a desired band Playback starts in the direction that the unit from among FM1, FM2, FM3 and AM. played back previously. z Pressthedesired preset station button. The number of the pressed preset station button is displayed next to the frequency indication. 2 Adjust the volume with +/-. Active tuning receptioncontrol (ATRC) This unit automatically suppresses FM noise Pressthe following buttonsto operetetape caused by
ملخص المحتوى في الصفحة رقم 10
TAPE PLAYBACK SOUND ADJUSTMENTS Autoreversefunction 12 When the end of the tape is reached during playback or fast tape transport, the direction of the tape is automatically reversed, and playback starts again. Tapedirection indications Playback Fast- forward or rewind MUTE 1 Press SEL to select the mode that you wish to adjust from: VOL (volume), BAS (baes), TRE (treble), BAL (balance) and \\ I /, Lower side FAD (fader). -4- 4 The following indications appear in cyclic ‘/ i \’ order. -- ..,-- B
ملخص المحتوى في الصفحة رقم 11
MUTEbutton Press this button to temporarily lower the volume. CRP(CDchangerready Press it again to restore the previous volume, position) You can enjoy CD changer play in combination You can enjoy music with strong bass sound. with your RF-CD-changer system with easy operation. H-BASS 1 24 Press H-BASS to obtain powerful bass. The “H BASS indicator lights up. Each time you press H-BASS, this function turns on or off. ‘7 1 Press PWR to turn the unit on, The radio frequency indication appears. 2 P
ملخص المحتوى في الصفحة رقم 12
CRP(CDchangerreadyflosition) CONNECTING A PORTABLE CDPLAYER OROTHER EQUIPMENT This unit is equipped with the line-level input (CD IN) jack enabling high quality of the sound. 31 Y Press PWR to turn the unit on. If a cassette is inserted, remove it to prevent possible damage to the unit. z Press CRP to switch the unit to CRP mode. 2 4 The “CRP indicator lights up. 1 If a cassette is inserted, remove it to s Play aCDwith yourCDchangersystem. prevent possible damage to the unit. A Adjust the volume
ملخص المحتوى في الصفحة رقم 13
MAINTENANCE SPECIFICATIONS Cleaningthe front panei RADiOSECTION When the front panel is soiled, wipe the surface (FM) of the panel with a dry and soft cloth. Frequency Range: 87.5 MHz–1 08 MHz (100-kHz steps) Cieaningthe tape head 87.5 MHz–1 08 MHz Use a cleaning cassette to clean the playback (50-kHz steps) head and capstans approximately once a month. Ussble Sensitivity 12.7dBf 50 dB Quieting Stmsitivity If the playback head is dirty, the high tones may 17.2 dBf not be reproduced properly. IF
ملخص المحتوى في الصفحة رقم 14
ملخص المحتوى في الصفحة رقم 15
ملخص المحتوى في الصفحة رقم 16
88-KTD-901 -01 9801 O9BTM-OX AIWA CO.,LTD.
