ملخص المحتوى في الصفحة رقم 1
3-868-315-11 (1)
FM/AM
Cassette Car
Stereo
US
Operating Instructions
Owner’s Record
The model and serial numbers are located on the bottom of the unit.
Record the serial number in the space provided below.
Refer to these numbers whenever you call upon your Sony dealer regarding this
product.
Model No. XR-1100 Serial No.
For installation and connections, see the supplied installation/connections
manual.
XR-1100
2000 Sony Corporation
ملخص المحتوى في الصفحة رقم 2
Warning Welcome! This equipment has been tested and found to Thank you for purchasing the Sony Cassette comply with the limits for a Class B digital Car Stereo. This unit lets you enjoy a variety of device, pursuant to Part 15 of the FCC Rules. features. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed Features and used in accordance w
ملخص المحتوى في الصفحة رقم 3
Notes on cassettes Precautions Cassette care • Do not touch the tape surface of a cassette, as • If your car was parked in direct sunlight any dirt or dust will contaminate the heads. resulting in a considerable rise in • Keep cassettes away from equipment with temperature inside the car, allow the unit to built-in magnets such as speakers and cool off before operating it. amplifiers, as erasure or distortion on the • If no power is being supplied to the unit, recorded tape could occur. check th
ملخص المحتوى في الصفحة رقم 4
Cassettes longer than 90 minutes The use of cassettes longer than 90 minutes is Table of Contents not recommended except for long continuous play. The tapes used for these cassettes are Location of controls ................................................. 5 very thin and tend to be stretched easily. Frequent playing and stopping of these tapes Getting Started may cause them to be pulled into the cassette Setting the clock .................................................. 6 deck mechanism. Cass
ملخص المحتوى في الصفحة رقم 5
Location of controls DIR A MEM D-BASS TUNER SEEK SOUND DSPL MANU OFF ATA LOCAL 1 2 3456 XR-1100 US Refer to the pages for further details. 7 D-BASS button 9 8 OFF button 1 SOUND (control mode select) button 9 During radio reception: 6, 9, 10 Preset number buttons 9 2 TUNER/A MEM (radio on • band select/ During tape playback: automatic memory) button 8, 9 ATA 1 (Automatic Tuner Activation) 3 (volume/bass/treble/balance/ fader control) buttons 6, 9 button 7 4Z (eject) button 7 q; SEEK/MANU
ملخص المحتوى في الصفحة رقم 6
DSPL 4 Press the button momentarily. Getting Started The clock activates. Note Setting the clock The clock cannot be set unless the power is turned on. Set the clock after you turn on the radio, or The clock has a 12-hour digital indication. during tape playback. For example, setting it to 10:08 1 Display the time. DSPL (Press the button during unit operation.) DSPL 2 Press the button for more than two seconds. The hour digit blinks. US Set the hour digits. to go forward to go back SOUND 3 P
ملخص المحتوى في الصفحة رقم 7
Getting Started/Cassette Player Fast-winding the tape Cassette Player Direction To advance To rewind indicator* Listening to a tape N After inserting the cassette, playback will start automatically. n To resume playback, press the other fast- winding button partially until the locked button is released. To change the tape direction, * The n or N indicator will flash while fast- press both the m and the M buttons at the winding the tape. same time. DIR US Radio reception during Indication of tap
ملخص المحتوى في الصفحة رقم 8
Tuning in by adjusting the Radio frequency — Manual tuning 1 Select the desired band. A MEM Searching for stations TUNER FM1 t FM2 t AM t FM1 automatically — Automatic tuning 2 Press and hold either side of the SEEK/ MANU button. 1 Select the desired band. Release the button when the desired station A MEM is received. TUNER FM1 t FM2 t AM t FM1 For higher frequencies SEEK MANU For lower 2 Press either side of the SEEK/MANU frequencies button momentarily to search for the next station (automatic
ملخص المحتوى في الصفحة رقم 9
Radio/Other Functions Memorizing only the Other Functions desired stations 1 Select the desired band. A MEM Adjusting the sound TUNER FM1 t FM2 t AM t FM1 characteristics 2 Tune in the station which you wish to 1 Select the item you want to adjust by store on the preset number button. SOUND pressing the button repeatedly. BAS (bass) t TRE (treble) t BAL 3 Press and hold the desired preset ATA (balance) t FAD (fader) t VOL (volume) number button ( 1 to 6 ) for about t BAS (bass) two seconds unti
ملخص المحتوى في الصفحة رقم 10
Additional Attenuating the beep Information tone 5 Press the button while pressing SOUND the button. To reactivate the beep tone, press these buttons Maintenance once more. Fuse replacement When replacing the fuse, be sure to use one matching the amperage rating stated on the fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest Sony dealer. Fuse (10 A) US W
ملخص المحتوى في الصفحة رقم 11
Other Functions/Additional Information 2 Insert a flathead screwdriver between the bracket and mounting spring. Gently Dismounting the unit pry the spring toward the unit while pulling the unit out a little. Repeat on 1 Insert the supplied tool between the unit the opposite side and remove the unit. and the frame, and rotate 90° to release the hidden mounting spring. Repeat on the opposite side and remove the frame. 13 10 mm ( /32 in.) US 3 4 mm ( /16 in.) 90° 11
ملخص المحتوى في الصفحة رقم 12
Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION 17 watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than 1% total harmonic distortion. Cassette player section General Tape track 4-track 2-channel stereo Output lead Power antenna relay Wow and flutter 0.13 % (WRMS) control lead Frequency response 30 – 18,000 Hz Tone controls Bass ±8 dB at 100 Hz Signal-to- noise ratio 58 dB Treble ±8 dB at 10 k
ملخص المحتوى في الصفحة رقم 13
Additional Information Troubleshooting guide The following checklist will assist in the correction of most problems which you may encounter with your unit. Before going through the checklist below, refer to the connection and operating procedures. General Problem Cause/Solution No sound • Adjust the volume with the button. • Set the fader control to the center position for 2-speaker systems. Tape playback Problem Cause/Solution The sound is distorted. Contamination of the tape head. t Clean the
ملخص المحتوى في الصفحة رقم 14
ملخص المحتوى في الصفحة رقم 15
ملخص المحتوى في الصفحة رقم 16
Sony Corporation Printed in Malaysia
