Xantech 48095D دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION

QUICK-START
A typical system will use an IR receiver, several emitters, and a power supply
MODEL
all connected to a connecting block.

48095D 1. Connect the IR receiver to the “IR RCVR” port on the connecting
block. The ‘red’ connector is installed to the ‘red’ plug.
Dinky Link™ Surface Mount
Note: In some extended distances, additional 3-conductor may be required and can
be connected to the terminals on the connecting block.
Plasma Proof IR Receiver
2. Connect the

ملخص المحتوى في الصفحة رقم 2

Input connections must be made as illustrated. To extend the emitter wires to PLACEMENT a more distant location, you may splice in 2-conductor wire, in the wire The IR receiver should be located so that it is not directly facing a light gauges mentioned before, as needed. source such as lamps or displays (standard, LCD, and Plasma). When mounted near a display, it should be flush to the display and away from light LOCAL SYSTEM APPLICATION reflections that may occur. Another application