Xantech 48010D دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION

QUICK-START
A typical system will use an IR receiver, several emitters, and a power supply
MODEL
all connected to a connecting block.

48010D 1. Connect the IR receiver to the “IR RCVR” port on the connecting
block. The ‘red’ connector is installed to the ‘red’ plug.
Dinky Link™ Surface Mount
Note: In some extended distances, additional 3-conductor may be required and can
be connected to the terminals on the connecting block.
Standard IR Receiver
2. Connect the Emit

ملخص المحتوى في الصفحة رقم 2

While it is possible to make wired connections without the connecting block, PLACEMENT it is not recommended. The connecting block reduces installation time, helps The IR receiver should be located so that it is not directly facing a light to eliminate errors, allows easy troubleshooting and permits easy system source such as lamps or displays (standard, LCD, and Plasma). When upgrades later, if needed. mounted near a display, it should be flush to the display and away from light reflection