ملخص المحتوى في الصفحة رقم 1
Subwoofer
MODEL
HCCA102
HCCA104
HCCA122
HCCA124
HCCA152
HCCA154
OWNER'S MANUAL
ملخص المحتوى في الصفحة رقم 2
CONTENTS English ....................................................................... 1 Français ..............................................................33 Español ..............................................................45 Deutsch ..............................................................57 Italiano ..............................................................69 Português ............................................................81 INTRODUCTION..............................
ملخص المحتوى في الصفحة رقم 3
INTRODUCTION Thank you for your purchase of the Orion HCCA subwoofers. These woofers represent a combination of incredible performance and value. The HCCA series subwoofers feature a massive 4” voice coil and triple stacked magnet assembly to maximize excursion and output. Capable of maintaining their balance at exceptionally high output levels. These high-performance woofers are built with dual 2 or 4 ohm voice coils, to get the most out of your amplifier. They are available in standard 10
ملخص المحتوى في الصفحة رقم 4
INSTALLATION The performance of these HCCA subwoofers is directly proportional to the quality of installation. Care taken during the installation process will be rewarded with years of satisfying performance. If you are unsure about your installation capabilities, please refer to your local Authorized Orion Dealer for technical assistance. Orion dealers are trained professionals dedicated to extracting the maximum performance out of your Orion system. If you decide to install this speaker s
ملخص المحتوى في الصفحة رقم 5
1 Polypropylene dust cap - moisture and UV resistant. 2 Tall, wide, balanced, NBR Foam (high density expanded polyester foam) surround for linear controlled long excursion using a Tri Radius symmetrical edge design optimized on non-linear FEA. 3 Paper cone - moisture and UV resistant. 4 Custom Cast Aluminum frame. 5 Spider ring attachment screws. Part of re-cone feature (8 hex screws) 6 aluminum voice coil former (10” uses 3” voice coil former, 12 & 15 use a 4” voice coil former) 7 Venting i
ملخص المحتوى في الصفحة رقم 6
RE-CONE KIT A re-cone kit is available for these speakers and can be obtained from your dealer. The part number for each model is listed below. Model/part # Description HCCA102ck ORION HCCA 10” 2 OHM Re-Cone Kit HCCA104ck ORION HCCA 10” 4 OHM Re-Cone Kit HCCA122ck ORION HCCA 12” 2 OHM Re-Cone Kit HCCA124ck ORION HCCA 12” 4 OHM Re-Cone Kit HCCA152ck ORION HCCA 15” 2 OHM Re-Cone Kit HCCA154ck ORION HCCA 15” 4 OHM Re-Cone Kit WIRING CONFIGURATIONS The following illustrations provide guidelines on
ملخص المحتوى في الصفحة رقم 7
Series—One Speaker (dual 2 ohm voice coils) One dual 2 ohm voice coil woofer with voice coils in connected in series results in a 4 ohm load to the amplifier. -- ++ Figure 2 Figura 2 Abbildung 2 + + - - 1. Connect the woofer in series by connecting the negative (-) of one terminal to the positive (+) terminal of the other coil. 2. Wire the positive (+) terminal of the first coil to the positive (+) terminal on the amplifier. Wire the negative (-) terminal of the second coil to the negative (-
ملخص المحتوى في الصفحة رقم 8
Parallel—One Speaker (dual 2 ohm voice coils) One dual 2 ohm voice coil woofer with voice coils in parallel results in a 1 ohm load to the amplifier. -- ++ + Figure 3 Figura 3 Abbildung 3 + - 1. Connect the speaker in parallel by connecting the two positive (+) terminals together and the two negative (-) terminals together. 2. Wire the positive (+) terminals of the woofer to the positive (+) terminal on the amplifier. Wire the negative (-) terminals of the woofer to the negative (-) terminal
ملخص المحتوى في الصفحة رقم 9
Parallel—One Speaker (dual 4 ohm voice coils) One dual 4 ohm voice coil woofer with voice coils in parallel results in a 2 ohm load to the amplifier. -- ++ Figure 4 Figura 4 Abbildung 4 + - 1. Connect the speaker in parallel by connecting the two positive (+) terminals together and the two negative (-) terminals together. 2. Wire both positive (+) terminals of the woofer to the positive (+) terminal on the amplifier. Wire both negative (-) terminals of the woofer to the negative (-) terminal
ملخص المحتوى في الصفحة رقم 10
Parallel—Two Speakers (dual 4 ohm voice coils) Two dual 4 ohm voice coil woofers with voice coils in parallel and the two woofers in parallel results in a 1 ohm load to the amplifier. -- -- - + + + + + Figure 5 - Figura 5 Abbildung 5 1. Connect the speaker in parallel by connecting the four positive (+) terminals together and the four negative (-) terminals together. 2. Wire the positive (+) terminals of the woofers to the positive (+) terminal on the amplifier. Wire the negative (-) terminal
ملخص المحتوى في الصفحة رقم 11
Series-Parallel—Two Speakers (dual 2 ohm voice coils) Note: Verify and ensure that the woofer wiring is connected as shown with the negative connection from the first woofer coil connected to the positive connection of the second woofer coil. Two dual 2 ohm voice coil woofers with voice coils in series and then parallel the two series woofers results in a 2 ohm load to the amplifier. -- -- + + + + + Figure 6 - Figura 6 Abbildung 6 1. Connect each woofer in series by connecting the negative (-
ملخص المحتوى في الصفحة رقم 12
Series-Parallel—Three Speakers (dual 4 ohm voice coils) Note: Verify and ensure that the woofer wiring is connected as shown with the negative connection from the first woofer coil connected to the positive connection of the second woofer coil. Three dual 4 ohm voice coil woofer with voice coils of each woofer wired in series and then parallel the three woofers for a resulting 2.67 ohms.load to the amplifier. -- -- -- + + + + + + Figure 7 Figura 7 Abbildung 7 + - 1. Connect each woofer in ser
ملخص المحتوى في الصفحة رقم 13
Series-Parallel—Four Speakers (dual 4 ohm voice coils) Note: Verify and ensure that the woofer wiring is connected as shown with the negative connection from the first woofer coil connected to the positive connection of the second woofer coil. Four dual 4 ohm voice coil woofers should be wired with the voice coils on each woofer in series and then parallel the four woofers for a resulting 2 ohm load to the amplifier. -- -- -- -- + + + + + + + + + Figure 8 - Figura 8 Abbildung 8 1. Connect ea
ملخص المحتوى في الصفحة رقم 14
Series-Parallel—Four Speakers (dual 2 ohm voice coils) Note: Verify and ensure that the woofer wiring is connected as shown with the negative connection from the first woofer coil connected to the positive connection of the second woofer coil. Four dual 2 ohm voice coil woofers should be wired with the voice coils on each woofer in series and then parallel the four woofers for a resulting 1 ohm load to the amplifier. -- -- -- -- + + + + + + + + + Figure 9 - Figura 9 Abbildung 9 1. Connect ea
ملخص المحتوى في الصفحة رقم 15
2 Amplifiers—One Speaker (dual 2 ohm voice coils) One dual 2 ohm voice coil woofer with each voice coil connected to an individual amplifier, resulting in a 2 ohm load to each amplifier. -- ++ + + - + Figure 10 Figura 10 - Abbildung 10 1. Connect one of the speaker’s voice coils to the first amplifier by connecting the positive (+) terminal and the negative (-) terminal from the speaker to the respective positive (+) terminal and the negative (-) terminal from the first amplifier. 2. Connect
ملخص المحتوى في الصفحة رقم 16
2 Amplifiers—One Speaker (dual 4 ohm voice coils) One dual 4 ohm voice coil woofer with each voice coil connected to an individual amplifier, resulting in a 4 ohm load to each amplifier. -- ++ + + - + Figure 11 Figura 11 - Abbildung 11 1. Connect one of the speaker’s voice coils to the first amplifier by connecting the positive (+) terminal and the negative (-) terminal from the speaker to the respective positive (+) terminal and the negative (-) terminal from the first amplifier. 2. Connect
ملخص المحتوى في الصفحة رقم 17
SPECIFICATIONS Model/Part Number HCCA102 HCCA104 HCCA122 Size 10” 10” 12” Thiele/Small Parameters Fs (free-air resonance, Hz) 42.51 44.3 32.3 Vas (equivalent compliance, cu. ft.) 0.31029 0.31699 0.89274 Vas (equivalent compliance, liters) 8.79 8.98 25.29 Qms (Q, mechanical) 7.16 5.99 5.08 Qes (Q, electrical) **** 0.48 0.52 0.5 Qts (total driver Q) **** 0.45 0.48 0.45 Re (DC resistance, ohms) **** 3.9 7.4 4 Z (nominal impedance, ohms) 2 x 2 4 x 4 2 x 2 Le (inductance, mh) **** 1.93 2.93 2.61 Effi
ملخص المحتوى في الصفحة رقم 18
SPECIFICATIONS Model/Part Number HCCA124 HCCA152 HCCA154 Size 12” 15” 15” Thiele/Small Parameters Fs (free-air resonance, Hz) 33.2 28.13 30.02 Vas (equivalent compliance, cu. ft.) 0.93157 2.95746 2.82259 Vas (equivalent compliance, liters) 26.39 83.78 79.96 Qms (Q, mechanical) 4.16 5.17 4.38 Qes (Q, electrical) **** 0.54 0.55 0.61 Qts (total driver Q) **** 0.48 0.5 0.54 Re (DC resistance, ohms) **** 7.4 4 7.3 Z (nominal impedance, ohms) 4 x 4 2 x 2 4 x 4 Le (inductance, mh) **** 3.67 2.59 3.68 E
ملخص المحتوى في الصفحة رقم 19
ENCLOSURE DETAILS 1. Parameters listed are for conventional applications only, for further help please call Tech Audio Support 2. 1” MDF is recommended. 3. Recommended enclosures are NET Box Volumes, speaker and port displacement are calculated into the volume of the enclosure, you will not need to add these volumes to calculate GROSS volume for the enclosure. NOTES: * Due to the high power capabilities and long excursion of these woofers, the system. Qes = EB
ملخص المحتوى في الصفحة رقم 20
EXPLANATION OF ENCLOSURE SPECIFICATIONS There are many different factors that help determine the best style of enclosure for you or your vehicle. Listed below are some factors that should be considered. The size of the enclosure is directly proportional to the efficiency and power handling of that speaker. A woofer in a smaller enclosure will handle more power than the same woofer in a larger enclosure. The exact opposite is true for efficiency, a larger enclosure will play lower frequencies
