ملخص المحتوى في الصفحة رقم 1
Customer Service
1-800-290-6650
128-8333
1 of 30
Released: Jan-28-08
ملخص المحتوى في الصفحة رقم 2
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE DOES NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. 2 128-8333 2 of 30
ملخص المحتوى في الصفحة رقم 3
CAUTION SAFETY INFORMATION Your wireless hand-held portable transceiver contains a low power transmitter. When the PTT button is pushed (or the VOX mode is enabled) it sends out radio frequency (RF) signals. The device is authorized to operate at a duty factor not to exceed 50%. In August 1996, the Federal Communications Commissions (FCC) adopted RF exposure guidelines with safety levels for hand-held wireless devices. Important: To maintain compliance with the FCC' s RF exposure guidelines hol
ملخص المحتوى في الصفحة رقم 4
WARNINGS: Battery Care Never attempt to charge alkaline or dry cell batteries, as batteries may burst causing personal injury and damage to the product. If rechargeable batteries are used, such as Nickel Metal Hydride (Ni-MH), use only the supplied Audiovox-approved rechargeable batteries. Use of the Audiovox charger (also supplied) with other brands of batteries is not recommended, as battery charging times will vary with different brands. Refer to the Manufacturer’s instructions for charging
ملخص المحتوى في الصفحة رقم 5
Model GMRS1882CH (FCC License Required) 5 6 18 4 15 7 16 3 3 10 (REF) 8 11 9 2 12 13 1 14 (REF) 1 17 1. Battery Door 10. Up Channel/Volume Button 2. Monitor/Backlight Button 11. Down Channel/Volume Button 3. Detachable Carry Clip 12. MODE/Weather Button 4. Push-To-Talk (PTT) Button 13. Power On/Off & Scan 5. Antenna Button 6. External Speaker(SPK)/Micro- 14. VOX Button phone (MIC)/Charge (CHG) Jack 15. White Flashlight LED 7. Built-in Speaker 16. Flashlight Enable Button 8. Liquid Crystal Displa
ملخص المحتوى في الصفحة رقم 6
Model GMRS1882CH DISPLAY 1 8 2 9 3 10 11 4 5 12 13 6 7 14 1. Beep Tone Indicator: Icon appears when beep button confirmation tone is selected; icon disappears when tone is off. 2. Key Lock Indicator: Icon appears when the keypad is locked. This function disables keys such as channel up/down, SCAN and MODE. 3. Monitor Indicator: Icon appears when the Monitor (M) button is pressed and the channel monitor function is activated. 4. Signal Strength Indicator: Icon appears when a signal is being
ملخص المحتوى في الصفحة رقم 7
12. Weather Mode Indicator: Icon will be on steady when in the weather band mode. When in the GMRS/FRS mode, the icon will blink when the alert is active. 13.Dual Watch Mode Indicator: Indicator appears when dual watch mode is active. 14.Voice Activated Transmission (VOX) Indicator: This function allows hands free conversation. The indicator appears when the VOX mode is activated. Equipment and Accessories Supplied 1. Radio (2) GMRS1882CH 2. Owner’s Manual 128-8333 3. Desktop Charger GMRS18DS
ملخص المحتوى في الصفحة رقم 8
2. udiovox echa geable i M atte ies echa eable i M A R r N - H B r - (R rg N - H Batteries There are three methods of powering the GMRS1882CH: 1. Alkaline Batteries. WARNING: Do not attempt to recharge Alkaline batteries. batteries and Charging Adapte r included). Use only Audiovox approved rechargeable batteries and charging equipment when charging batteries internal to the unit. NOTE: To extend battery life, avoid overcharging the batteries 3. Various Brands of Rechargeable Batteries - Us
ملخص المحتوى في الصفحة رقم 9
The following guidelines will improve performance and provide longer operating times for the GMRS1882CH: 1. Do not mix old and new batteries. 2. The use of alkaline-type batteries is recommended to provide the longest operating time. 3. Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries. 4. If the unit is not to be used for an extended period of time, remove the batteries. Old or leaking batteries can cause damage to the unit and will void the warranty. CHARGING STAND PWR JACK
ملخص المحتوى في الصفحة رقم 10
GMRS1882CH OPERATION MODE GMRS/FRS BAND WEATHER BAND CHANNEL Weather CHANNEL SELECT SELECT CTCSS SELECT Weather ALERT On/Off POWER (GMRS Channels SELECT Only) NOTE: 1. To switch between GMRS/FRS VOX LEVEL and Weather Band modes, SELECT press and hold the MODE/WB DUAL button for 2 seconds. Refer to WATCH the appropriate section of this BUTTON manual for detailed operating BEEP instructions for each mode. ROGER 2. To enter the VOX mode, press BEEP and hold the VOX button for 1 CALL second. SELECT
ملخص المحتوى في الصفحة رقم 11
volume. The display will indicate the current volume level between 0 and 7 5 by the small number in the icon ( UL ). Monitor/Keylock Button (2) This button is used to check activity on the current frequency before transmitting. Check activity by pressing the Monitor (M) Button longer than 2 seconds; the icon will apppear on the display and you will hear static if frequency is clear. Do not transmit if you hear conversation. Hold down the Monitor Button again longer than 2 seconds and th
ملخص المحتوى في الصفحة رقم 12
Down Channel/Volume Button (11) In the standby mode, pressing this button will decrease the listening volume. When in function edit mode this button will be used to adjust the unit’s settings. MODE/WB Button (12) This button is used to select the various feature settings in the GMRS/FRS or scanner modes.H o lding the MODE/WB button longer than 2 secon ds will toggle between the GMRS/FRS andweather band modes. External Microphone (MIC)/Speaker (SPK)/(CHG) Jack (6) This jack accepts the supplied
ملخص المحتوى في الصفحة رقم 13
CTCSS tone frequency of at least two parties are the same. - The CTCSS small segment display will appear next to the main frequency channel on the display if the CTCSS tone frequency function is enabled. Channel Selection In order to communicate with other GMRS units, both transmitting and receiving party must be on the same frequency.The GMRS1882CH has 22 channels (frequencies) indicated by the large digits on the LCD display panel. Channels 1 through 7 are the shared GMRS/FRS channels. Channe
ملخص المحتوى في الصفحة رقم 14
are 38 CTCSS sub-channels for each main channel. A different subcode may be selected for each of the 22 channels. To change the CTCSS sub-channel: - From GMRS/FRS standby mode, press the MODE Button twice; a flashing oF or sub-channel number is displayed. If oF is displayed, press the Up or Down button to enable the CTCSS mode. - Then press the Up or Down button to select the desired sub-channel for use (01-38). - Press the PTT button momentarily to confirm selection. The CTCSS mode can be t
ملخص المحتوى في الصفحة رقم 15
VOX Sensitivity Level Selection This selection enables you to set the sensitivity level to compensate for ambient noise in your immediate area. A VOX sensitivity of 3 is the most sensitive, and should be used in a relatively quiet surrounding. A VOX sensitivity of 1 is the least sensitive and should be used in a noisy sur- rounding. To set the VOX sensitivity level: - Press the MODE button 4 times (3 times for FRS) until the VOX icon appears on the display accompanied by the flashing VOX icon an
ملخص المحتوى في الصفحة رقم 16
the PTT button momentarily to confirm selection of the dual watch channel. The display will now alternate between the primary channel and the dual watch channel just selected. NOTE:Pressing the PTT button during dual watch mode will trans- mit on the primary channel and suspend dual watch opera- tion for 5 seconds. Dual watch mode will then resume. - Momentarily press the SCAN (s) button to exit the dual watch mode. Key Tone This feature allows the transceiver to sound a confirmation tone whenev
ملخص المحتوى في الصفحة رقم 17
Call Ringer Selection Mode The transceiver provides 10 user-selectable call ringer melodies to alert you to an incoming call. To select your favorite call ringer melody: - From GMRS/FRS standby mode, press the MODE Button 8 times (7 times for FRS). CA will appear on the display, together with a flashing number between 1 and 10, and an appropriate call ring. - Press the Up or Down Button to preview and hear the 10 available call melodies. - Press the PTT button momentarily to confirm selection.
ملخص المحتوى في الصفحة رقم 18
Auto Key Lock Selection Mode This feature prevents accidental channel change to the preferred settings of the unit. The Auto Key Lock function temporarily disables the MODE, Up/ Down and SCAN Buttons. To access the Auto Key Lock selection menu: - From GMRS/FRS standby mode, momentarily press the Monitor (M) button to enable the Auto Key lock function; the unit will beep once and the lock ( ) icon appears on the display. - The Power, PTT, and Monitor Buttons are not effected. - To unlock the A
ملخص المحتوى في الصفحة رقم 19
channel, the unit must be in the weather channel mode. Press and hold the MODE/WB button for at least 2 seconds; the weather alert icon ( ) will appear, together with a channel number in the band. Momentarily press the MODE/WB button (12) once; the channel number flashes. To change the channel: - Press the Up Button (10) briefly to move to the next higher main channel number. - Press the Down Button (11) briefly to move to the next lower main channel number. NOTE: When the weather band opera
ملخص المحتوى في الصفحة رقم 20
Battery Alert When the battery icon is empty ( ) and flashing on the display, re- charge unit or install fresh batteries. The transceiver will turn off in approximately two minutes when the low battery indicator appears at the lower left of the screen. In addition the empty battery ( ) icon will flash. The battery status is displayed in the top right corner of the LCD with 1,2 or 3 bars (1 bar = low charge, 3 bars = full charge). Battery Charge Status and Charging Instructions Initial
