Atdec TH-3070-CTL دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

TH-3070-CTL
Installation Instructions
TH-3070-CTS
Ceiling Tilt Short Mount / Ceiling Tilt Long Mount
Component Checklist
HARDWARE
M6x16mm/30mm/45mm
M4x12mm Ceiling Cover Bracket Locking Clamp Cover M10
M8x16mm/30mm/50mm
M10 Coach M6/M8/M10
Screw (x2)
Plate (x2) Middle Washer
Bolt (x4) Washer (x4 each)
Display Mounting
Screws (x4 each)
Nylon
Mounting M6/M8
Cable Mounting M8x15mm Clamp Cover M10x30 2mm/2.5mm/3mm
Anchor (x4) Spacer (x4 each)
Bracket (x2) Clip (x2) Cover Screw (x2) Bottom Screw
5m

ملخص المحتوى في الصفحة رقم 2

Step 6. Set the Height of the Pole 6A 6B 6C 6D Height Adjustment CTL: 1050-1900mm CTS: 550-900mm Whilst supporting the lower half of Pole Tighten the Socket Cap Screws If necessary, centralise the Pole Joint (x2) to set the height using the by tightening the Set Screws (x2) to suit Assembly loosen the Socket Cap Screws Slide Pole Assembly to the (x2) using the supplied 5mm Allen Key. desired height. supplied 5mm Allen Key. using the 2.5mm Allen Key. Step 7. Install the Ceiling Cover Step 8.

ملخص المحتوى في الصفحة رقم 3

Step 10. Install the Head Clamp Front Cover Step 11. Attach Mounting Brackets to the Display The mounting brackets support hole configurations from 200-800mm in width to 200-500mm in height. Display Mounting Screw (x4) TOP Washer (x4) Mounting Bracket (x2) PUSH Spacer (x4) (optional, use only for Back of Display recessed mounting holes.) Step 12. Attach the Display to the Horizontal Rail Step 13. Tilt Adjustment 10° Tighten M10 Bolts by 1. Hook the Display to the Horizontal Rail. 20° using th