JL Audio Stealthbox SB-F-ZX3/10W3 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

®
Stealthbox
INSTALLATION GUIDE
➔
➔
for the
➔
START
SB-F-ZX3/10W3
HERE
(2000-Up ZX3 2-door & 2001-Up ZX5
4-door hatchback)
➔ ➔ ➔
➔
STEP 1: Remove the four Phillips head STEP 2: Remove the plastic safety belt STEP 3: Remove the two plastic Phillips head
screws, panel button and cargo light from retractor cover. Look up under the plastic screws indicated by the arrows.These are
driver’s side rear cargo area. cover for a Phillips head screw. Remove this located in the driver’s rear hatch plastic t

ملخص المحتوى في الصفحة رقم 2

Cont. From Page 1 ➔ ➔ ➔ STEP 7: Pull plastic mounting stud out from STEP 8: Enlarge this hole to 1/2 in. (12.7 mm). ® the rear side metal panel were the MOLEX CAUTION: Always check for obstructions wiring plug was removed in Step 4. before drilling. ALWAYS WEAR EYE PROTECTION WHEN DRILLING. A C B E D ➔ F G H STEP 9: Using a measuring tape and masking STEP 10: After panel has been cut, it should A) 2.5 in. (63.5mm) E) 1.25 in. (31.75mm) tape, define the area to be cut as shown by resemble this. B

ملخص المحتوى في الصفحة رقم 3

STEP 14: From outside of the car, slide hand between the pulled fabric wheel well (Step Cont. From 6) and the car’s body. Feel for the threaded Page 3 mounting stud. STEP 15: Place fender washer, lock washer ➔ ➔➔ and 3/8 in. nut onto threaded mounting stud.➔ Tighten firmly using a 9/16 in. deep socket. STEP 16: After securely mounting the Stealthbox, push fabric wheel well back into place. Reinstall TORX head bolt and Phillips head screw that was removed in Step 5. CONGRATULATIONS! STEP 11: Rein