Peerless Industries ACC 309 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Model:
Installation and Assembly - Plasma Video Conference Shelf
ACC 309
A
PARTS LIST Parts List
PART # QTY. DESCRIPTION
A 200-1305 1 shelf
B 200-1306 2 shelf bracket
C
C 200-1307 2 wall bracket
D 200-1005 4 #14 x 2 1/4" wood screw
E 520-9250 6 M5 x .8 x 10mm phillips screw B
F 520-1006 4 M4 x .7 x 6mm phillips screw
E
D
F
Some parts may appear slightly different than illustrated.
Fasten two M5 screws (E) into second hole of wall bracket (C) leaving about 1/4" gap as shown below.
Note: To increa

ملخص المحتوى في الصفحة رقم 2

Use a stud finder and follow the directions that come with it to locate the center point of the stud. Never mount into drywall alone! Slide wall bracket (C) along stud behind plasma mount leaving about half an inch between center of bottom hole of wall bracket (C) and top of plasma. Using the wall bracket (C) as a guide, mark and drill the four 5/32" (4 mm) dia. mounting holes in the center of the stud, 2 1/2" deep. At this point, it is essential to use a level to level your wall bracket (C). I

ملخص المحتوى في الصفحة رقم 3

Attach shelf (A) to shelf brackets (B) using four M4 screws (F). Note: Do not fully tighten screw (F) to allow for adjust- ment. F A B Hook shelf bracket (B) to wall bracket (C) as shown below. Note At this point shelf brackets (B) may need to be adjusted to hook onto wall bracket (C). After shelf bracket (B) is in place lock into place using two M5 screw (E). Note: Use one per bracket (C) on the outside of bracket (C). B C E 3 of 3 ISSUED: 07-01-02 SHEET #: 200-9383-2 11-10-04 Visit the Peerl