Transition Networks SGETF1025-100 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

COMPLIANCE INFORMATION
UL Listed
1000BASE-TX to 1000BASE-SX/LX
C-UL Listed (Canada)
CISPR/EN55022 Class A
EN55024
Media Converters
FCC Regulations
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant
SGETF10xx-100
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
USER’S GUIDE
uses, and can

ملخص المحتوى في الصفحة رقم 2

SGETF10xx IN THE NETWORK TECHNICAL SPECIFICATIONS Standards IEEE 802.3ab, IEEE 802.3 1998 Install two SGETF10xx series media converters in series to extend, over fiber, Data Rate 1000 Mb/s the distance between two 1000BASE-TX devices. Dimensions 3.4" x 0.86" x 5.0" (86mm x 22mm x 127mm) Weight 8 oz (approximate) Delay 300 nsec Power Consumption 6.5 Watts Power Supply Requirements Replace power supply with only the equivalent input rating (see below) and output rating (unregulated 9-24VDC, 5.5W)

ملخص المحتوى في الصفحة رقم 3

Install Cable CABLE SPECIFICATIONS COPPER Fiber Cable NOTE: The SGETF10xx series media converter auto-negotiation feature MULTIMODE allows the media converter to bring up the copper link in the highest Fiber Optic Cable Recommended: 62.5 / 125 µm multimode fiber mode possible for ALL the attached network devices. Optional: 100 / 140 µm multimode fiber 85 / 125 µm multimode fiber 1. Locate or build 1000BASE-TX-compliant cables with male RJ-45 50 / 125 µm multimode fiber connectors installed at

ملخص المحتوى في الصفحة رقم 4

OPERATION FAULT ISOLATION and CORRECTION If the media converter fails, isolate and correct the fault by determining the Using Status LEDs answers to the following questions and then taking the indicated action: Use the status LEDs to monitor media converter operation in the network. 1. Is the P(o)W(e)R LED on the media converter illuminated? P(o)W(e)R Steady LED indicates connection to NO external AC power. • Is the power cord properly installed in the media converter and at PWR RXF (Fiber rece