JBL GTO8607C دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

GRAND
®
TOURING
SERIES
GTO507C
GTO607C
GTO6507C
GTO8607C
GTO6507SC
component
systems
owner’s
manual
THANK YOU
® ®
for purchasing a JBL Grand Touring Series
automotive loudspeaker component system. We’ve
organized this manual to make your installation as
simple and trouble-free as possible. Please read it
thoroughly before proceeding. Remember to keep
your sales receipt and this manual in a safe place
so both are available for future reference.

ملخص المحتوى في الصفحة رقم 2

INSTALLATION WARNINGS AND TIPS INSTALLATION ABOUT THESE INSTRUCTIONS REAR DECK PRECAUTION • Check clearances on both sides of a Figure 1. Mounting the woofer in a factory Installation of automotive stereo components In some cars, fuel tanks may be located planned mounting surface before drilling location without the grille (except GTO607C). can require extensive experience with a vari- directly beneath the rear deck. Before any holes or installing any screws. ety of mechanical and electrical pro

ملخص المحتوى في الصفحة رقم 3

INSTALLATION INTERMOUNT III* FLUSH-MOUNT TWEETER ANGLE Figure 7A. Surface-mounted behind MOUNTING RINGS Figure 5A. Mounting the tweeter using the Figure 6. Aim the tweeter at the listening grille panel. The GTO607C is packaged with two I-Mount flush-mounting kit. position by sliding the screw in the groove different speaker adapters. The adapters on the back of the tweeter cup and lock the 3 will allow the speakers to be installed into tweeter in place using the small retaining various factory 6

ملخص المحتوى في الصفحة رقم 4

J1 CONNECTIONS SPECIFICATIONS GTO507C GTO607C GTO6507C GTO8607C GTO6507SC Open the crossover housing by firmly Figure 8B. The 0dB setting is the squeezing the sides of the top half and reference setting. Move the jumper Type 5" (130mm) 6-1/2" (160mm) 165mm 6" x 8" (5" x 7") 165mm Shallow- Two-way Two-way Two-way Two-way mount two-way lifting it away from the bottom. Using to the +3dB setting if more tweeter component component component component component screws or a wire tie, mount the output