ملخص المحتوى في الصفحة رقم 1
16xx/96xx Amplified Speech Handset
Installation and Use
16-602703
Issue 1
July 2008
ملخص المحتوى في الصفحة رقم 2
© 2008 Avaya Inc. All Rights Reserved. Notice While reasonable efforts were made to ensure that the information in this document was complete and accurate at the time of printing, Avaya Inc. can assume no liability for any errors. Changes and corrections to the information in this document may be incorporated in future releases. For full legal page information, please see the complete document, Avaya Legal Page for Hardware Documentation, Document number 03-600759. To locate this documen
ملخص المحتوى في الصفحة رقم 3
Table of Contents Introducing the 16xx / 96xx Amplified Speech Handset ............................................................................2 Installing and Replacing Batteries .............................................................................................................3 Setting the Mode........................................................................................................................................3 Using the Handset ...........................
ملخص المحتوى في الصفحة رقم 4
Introducing the 16xx / 96xx Amplified Speech Handset Avaya offers one Amplified Speech handset for the 16xx IP telephones, and one for the 96xx IP telephones. Both handsets operate in two modes. • Mode 1: Push-to-Amplify Receive Volume In this mode, while the ‘Push to Amplify’ button is pressed, the receive volume is at the level that has been set by the volume selection button. While the ‘Push to Amplify’ button is not pressed, the receive volume is at the minimum handset volume level
ملخص المحتوى في الصفحة رقم 5
Installing and Replacing Batteries The Avaya 16xx/96xx Amplified Speech Handset ships with 2 AAA-size alkaline batteries. When installing and/or replacing batteries follow the instructions below. 1. Verify that you have two new AAA-size batteries and unplug the handset from the cord. 2. Remove the battery cover by using your fingernail, press down on the top of the battery compartment cover and pull out away from handset. 3. Insert the right-side battery, positive end facing do
ملخص المحتوى في الصفحة رقم 6
To change from Mode 1 to Mode 2: 1. Remove the battery cover. 2. Move the slide switch to the right for Mode 2. 3. Replace the battery cover. Using the Handset When using the Amplified Speech handset additional volume can be achieved by adjusting the telephone volume and the handset volume. It is recommended that the Telephone Volume be set at the middle volume setting. The best audio quality can be achieved with this setting. The handset has three buttons, as shown below:
ملخص المحتوى في الصفحة رقم 7
The handset receive volume changes (in steps) each time you press the ‘Volume Up’ or ‘Volume Down’ buttons. There are six volume settings. A maximum volume tone will sound when the loudest volume is reached. A minimum tone will sound when the softest volume is reached. To ‘Push to Amplify’: 1. Set slide switch to Mode 1. 2. Use the Volume Up or Volume Down buttons to adjust volume to the desired level. 3. Push the ‘Push to Amplify’ button only when you want to amplify. To ‘A
ملخص المحتوى في الصفحة رقم 8
Low Battery Indicator You will hear a hi/low warning tone when the batteries need to be replaced. The warning tone will repeat at approximately two-minute intervals, unless the handset is in a battery conservation state. When the ‘Low Battery Indicator’ sounds replace the batteries as described above. No Battery / Dead Battery Operation If the batteries in the Specialty Handset are not installed or if they are dead, the handset will operate as a non-amplified handset. You can sti
