ملخص المحتوى في الصفحة رقم 1
Setup Guide
MTPX Series
Mini Twisted Pair Matrix Switchers
Extron Electronics, USA Extron Electronics, Europe Extron Electronics, Asia Extron Electronics, Japan
1230 South Lewis Street Beeldschermweg 6C 135 Joo Seng Rd. #04-01 Kyodo Building, 16 Ichibancho 68-1561-01 Rev. A
Anaheim, CA 92805 3821 AH Amersfoort, The Netherlands PM Industrial Bldg., Singapore 368363 Chiyoda-ku, Tokyo 102-0082
06 08
800.633.9876 714.491.1500 +800.3987.6673 +31.33.453.4040 +800.7339.8766 +65.6383.4400 Japan
ملخص المحتوى في الصفحة رقم 2
Precautions Safety Instructions � English Warning Extron’s Warranty Power sources � This equipment should be operated only from the power source This symbol is intended to alert the user of important indicated on the product. This equipment is intended to be used with a main power operating and maintenance (servicing) instructions in system with a grounded (neutral) conductor. The third (grounding) pin is a safety Extron Electronics warrants this product against defects in materials and wo
ملخص المحتوى في الصفحة رقم 3
警告 安全须知 • 中文 电源 • 该设备只能使用产品上标明的电源。 设备 这个符号提示用户该设备用户手册中 必须使用有地线的供电系统供电。 第三条线 有重要的操作和维护说明。 （地线）是安全设施，不能不用或跳过。 拔掉电源 • 为安全地从设备拔掉电源，请拔掉所有设备后 这个符号警告用户该设备机壳内有暴 或桌面电源的电源线，或任何接到市电系统的电源线。 电源线保护 • 妥善布线， 避免被踩踏，或重物挤压。 露的危险电压，有触电危险。 维护 • 所有维修必须由认证的维修人员进行。 设备内部 注意 没有用户可以更换的零件。为避免出现触电危险不要自 阅读说明书 • 用户使用该设备前必须阅读并理 己试图打开设备盖子维修该设备。 解所有安全和使用说明。 通风孔 • 有些设备机壳上有通风槽或孔，它们是用来防止 保存说明书 • 用户应保存安全说明书以备将来使 机内敏感元件过热。 不要用任何东西挡住通风孔。 用。 锂电池 • 不正确的更换电池会有爆炸的危险。 必须使用 遵守警告 • 用户应遵守产品和用户指南上的所有安 与厂家推荐的相同或相近型号的电池。 按照生产厂的 全和操作说明。 建议处理废弃电
ملخص المحتوى في الصفحة رقم 4
Table of Contents Chapter One • Introduction ................................................... 1-1 Chapter One • Introduction ................................................... 1-1 About this Manual .................................................................... 1-2 About the MTPX Switchers .................................................... 1-2 Twisted Pair (TP) Cable Transmission Distance ................ 1-4 Chapter Two • Installation ...........................................
ملخص المحتوى في الصفحة رقم 5
Table of Contents, cont’d MTPX Twisted Pair Matrix Switcher Chapter One 1 Introduction About this Manual About the MTPX Switchers Twisted Pair (TP) Cable Transmision Distance All trademarks mentioned in this manual are the properties of their respective owners. 68-1561-01 Rev. A 06 08 ii MTPX • Table of Contents Refer also to the MTPX User’s Manual at www.extron.com.
ملخص المحتوى في الصفحة رقم 6
Introduction The receiver-to-transmitter serial communications and N About this Manual remote power capabilities available with certain MTP This setup guide allows you to easily and quickly set up models are not supported by this matrix switcher. and configure your Extron MTPX Twisted Pair (TP) Matrix The MTPX matrix switcher is available in the following matrix Switcher. Step by step instructions show you how to connect sizes: the hardware, and then use the physical controls and the M
ملخص المحتوى في الصفحة رقم 7
Introduction, cont’d The transmitters, receivers, and matrix switcher are N Twisted Pair (TP) Cable Transmission Distance designed for and perform best with Extron Enhanced Do not connect this device to a computer data or C Skew-Free A/V cable terminated in accordance with telecommunications network. the TIA/EIA T 568 A wiring standard. CAT 5, 5e, The maximum distance is determined by the frequency and and 6 cables are acceptable, but less preferable. We also recommend the use of pret
ملخص المحتوى في الصفحة رقم 8
Introduction, cont’d MTPX Twisted Pair Matrix Switcher Chapter Two 2 Installation Rear Panel Front Panel 1-6 MTPX • Introduction Refer also to the MTPX User’s Manual at www.extron.com.
ملخص المحتوى في الصفحة رقم 9
L R Installation Inputs Rear Panel Turn off power to the input and output devices, and C 2 6 4 1 disconnect their power cords. LOCAL INPUTS LOCAL OUTPUT RGB RGB CONTROL 1 TP inputs — Connect up to 8, 16, or 32 (depending RGB LOCAL a RGB ON 2 3 1 2 3 on the matrix size) compatible TP inputs to the Inputs RJ - 45 INPUT SELECT IIN NP PU UT TS S O OU UT TP PU UT TS S AUDIO 1 2 3 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 RJ-45 connectors. 1 2 3 4 L R L R L R L R You must configure the switcher for the
ملخص المحتوى في الصفحة رقم 10
L R Installation, cont’d Outputs Remote control TP outputs — Connect up to 8, 16, or 32 (depending Remote port — If desired, connect a control system or computer e h to the rear panel Remote RS-232/RS-422 port. on the matrix size) compatible MTP receivers to the Outputs RJ-45 connectors. Pin RS-232 Function RS-422 Function 1 — Not used — Not used Local RGB (VGA) outputs — Connect one f 2 TX Transmit TX– Transmit (–) or two RGBHV video displays to the Local 1 3 RX Receive RX– Receive (–)
ملخص المحتوى في الصفحة رقم 11
Installation, cont’d MTPX Twisted Pair Matrix Switcher Chapter Three 3 Front Panel Operation Creating a Tie Saving or Recalling a Preset Setting the Front Panel Locks (Executive Modes) Defining the Audio/RS-232 Wire Pair (and Configuring the Remote Port) Viewing and Adjusting the Audio Level Viewing Ties (and Muting Outputs) 2-6 MTPX • Installation Refer also to the MTPX User’s Manual at www.extron.com.
ملخص المحتوى في الصفحة رقم 12
Front Panel Operation Creating a Tie Saving or Recalling a Preset 1. Press and release the Esc button to clear any input LED, 1. Save a preset — Press and hold the Preset button until the output LED, or control LEDs that may be lit. Preset LED flashes. 2. Press and release the Video and/or Audio I/O button(s) to select or deselect video and/or audio as desired. Save a Press and hold. preset Lit when selected Lit when selected 2 seconds Off when deselected Off when deselected PRESET PRESET Pr
ملخص المحتوى في الصفحة رقم 13
Front Panel Operation, cont’d Selecting Lock mode 2 or toggling between Setting the Front Panel Locks (Executive Modes) mode 2 and mode 1 The matrix switcher has three levels of front panel security lock that limit the operation of the switcher from the front panel. The If the switcher is in Lock mode 0 or mode 1, this procedure N three levels are: selects mode 2. • Lock mode 0 — The front panel is completely unlocked. If the switcher in in Lock mode 2, this procedure selects • Lock
ملخص المحتوى في الصفحة رقم 14
Front Panel Operation, cont’d 2. Release the Control buttons. Defining the Audio/RS-232 Wire Pair These settings are protected when front panel Lock mode 2 N (and Configuring the Remote Port) is selected. You can view the configurations in Lock mode 2 1. To enter Configuration mode, simultaneously press and but you cannot change them from the front panel; the hold the Enter, Preset, View, and Esc buttons. actions are ignored and the Enter, Video, and Audio LEDs Press and hold the Cont
ملخص المحتوى في الصفحة رقم 15
Front Panel Operation, cont’d Viewing and Adjusting the Audio Level Viewing Ties (and Muting Outputs) 1. Press the View button. Output LEDs light for outputs that Only the twisted pairs' input levels and only the local N have no ties established. outputs' volume can be adjusted. If the Audio LED blinks, audio is broken away (switched 1. Press and hold the Audio button until the Audio LED flashes. N separately from video). The Audio LED blinks. If an output LED blinks, that output is mut
ملخص المحتوى في الصفحة رقم 16
Front Panel Operation, cont’d MTPX Twisted Pair Matrix Switcher Chapter Four 4 Remote Control and Optimizing the Video ™ Selected SIS Commands Installing and Starting the Control Program Accessing the HTML Pages 3-10 MTPX • Front Panel Operation Refer also to the MTPX User’s Manual at www.extron.com.
ملخص المحتوى في الصفحة رقم 17
Remote Control and Optimizing the Video ™ Selected SIS Commands ™ The switchers have Simple Instruction Set (SIS ) commands that you can use for operation and configuration. You can run these commands from a PC connected to either of the switcher’s serial ports. See and , on page 2-5, for connection information. h j Host-to-switcher instructions The switcher accepts SIS (Simple Instruction Set) commands through either serial port. SIS commands consist of one or more characters per comma
ملخص المحتوى في الصفحة رقم 18
MTPX • Remote Control and Optimizing the Video 4-3 Refer also to the MTPX User’s Manual at www.extron.com. Command ASCII command Response Additional description (host to switcher) (switcher to host) Create ties • Commands can be enter ed back-to-back in a string, with no spaces. For example: 1*1!02*02&003*003%4*24$. N • The matrix switchers support 1-, 2-, and 3-digit numeric entries (1*1!, 02*02&, or 003*003%). N The & tie command for RGB and the % tie command for video can be used inte
ملخص المحتوى في الصفحة رقم 19
Remote Control and Optimizing the Video, cont’d 4-4 MTPX • Remote Control and Optimizing the Video MTPX • Remote Control and Optimizing the Video 4-5 Refer also to the MTPX User’s Manual at www.extron.com. Refer also to the MTPX User’s Manual at www.extron.com. Command ASCII command Response Additional description (host to switcher) (switcher to host) Audio/RS-232 TP input (wire pair 3 and 6) configuration Configure input as audio Define the audio/RS-232 input as audio, such X! X! ] *0\ Typ *0
ملخص المحتوى في الصفحة رقم 20
Remote Control and Optimizing the Video, cont’d 4-6 MTPX • Remote Control and Optimizing the Video MTPX • Remote Control and Optimizing the Video 4-7 Refer also to the MTPX User’s Manual at www.extron.com. Refer also to the MTPX User’s Manual at www.extron.com. Command ASCII command Response Additional description (host to switcher) (switcher to host) Audio or RS-232 mute commands Audio or RS-232 mute X@ X@ ] X@ *1Z Amt *1 Mute output audio (audio off). Audio or RS-232 unmute X@*0Z AmtX@*0] Un
