Omnitron Systems Technology iConverter GX/X دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

The GX/X can be used as a standard two-port fiber GX/X MODEL NUMBER REFERENCE CHART PORT STRUCTURE
converter. It can also use its two additional 10/100 backplane
Using a 4-port switch design, the GX/X features two
iConverter GX/X
ports to connect to adjacent modules and accommodate
front-plane 1000Mbps fiber ports (Port 1 is the top port,
® flexible network configurations like In-Band management Port 1 Port 2
Connector Types and Port 2 is the lower port nearest the thumb screw).
iConverter GX/X

ملخص المحتوى في الصفحة رقم 2

DIP-SWITCH SETTINGS Any other DIP-Switch configuration will disable mode automatically. If the device connected to Port 1 MOUNTING AND CABLE ATTACHMENT cannot provide the proper signal to indicate its own Symmetrical Fault Detection mode. Front Panel DIP-Switch Settings The iConverter modules are hot-swappable and can mode of operation, then the DIP-Switch should be set NOTE: Converters in SFD mode must be deployed in pairs. be installed into any chassis in the iConverter family. to the “MAN”