NETGEAR 7300 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

3. CONNECT DEVICES TO THE SWITCH
PC with Static IP Address

• Use Category 5 (Cat5) cable to connect between network ports at speeds of
When the PC is in this mode, the switch must also be assigned a static IP address. To
100Mbps or less.
7000 Series Managed Switch (7200, 7300, 7300S)
assign a static IP Address, access the switch from the serial console port as follows:
• Use Category 5e (Cat5e) for 1000Mbps networking speed.
1. CONNECT A CONSOLE TO THE SWITCH
Fiber SFP modules are shipped s

ملخص المحتوى في الصفحة رقم 2

2. FIND THE SWITCH IP ADDRESS ASSIGNED BY THE DHCP SERVER User:admin Password: (FSM7328S) >ezconfig After locating the switch IP address: NETGEAR EZ Configuration Utility a. Perform steps 1 through 3 of the procedure “PC with Static IP Address”. -------------------------------- Hello and Welcome! b. Type the show network command and press Enter. A screen will display This utility will walk you thru assigning the IP address for the switch management CPU. It will allow you to save the changes at