Henny Penny HEC-123 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Model HEC-103/104/123/124
SECTION 3. OPERATION
3-1. INTRODUCTION This section provides explanations of all controls, along
with operating procedures and daily maintenance. Read the
Introduction, Installation and Operation Sections before
operating the unit.
To access the controls, the bottom, front panel must be
removed by pulling out on one corner of the panel and
unsnapping it from the clips.
3-2. OPERATING CONTROLS Refer to control diagrams on next page.
Figure Item Description

ملخص المحتوى في الصفحة رقم 2

Model HEC-103/104/123/124 3-2. OPERATING CONTROLS (Continued) 21 4 3 5 HEC-103 & HEC-104 2 1 4 3 5 HEC-123 & HEC-124 705 3-2

ملخص المحتوى في الصفحة رقم 3

Model HEC-103/104/123/124 3-3. START UP Before using the heated express cabinet, thoroughly clean the unit as described in the Cleaning Procedures Section of this manual. 1. Turn the power switch to the ON position. 2. If the heat values for the shelves have not been set, pull out on one corner of the bottom front panel, and unsnap it from the unit, to access the controls. 3. Press and hold and use to set the heat value of the base (or bottom) shelf. It can be set from “OFF” to a max

ملخص المحتوى في الصفحة رقم 4

Model HEC-103/104/123/124 3-4. OPERATION WITH 1. Place the hot, prepackaged product on each of the shelves. PRODUCT To assure quality product, stacking prepackaged product is not recommended. 2. Serve the product first that has been in the cabinet the longest. 3-5. CLEANING 1. Turn power switch to OFF. PROCEDURES 2. Disconnect the electrical supply to the cabinet. To avoid burns, allow the unit to cool before cleaning. 3. Remove all product from the cabinet. 4. Wipe down

ملخص المحتوى في الصفحة رقم 5

Model HEC-103/104/123/124 3-6. SPECIAL PROGRAM This mode includes the lock/unlock feature, control initialization, and MODE testing of the outputs and displays. 1. Turn power switch off. 2. Press and hold both while turning on the power switch. 3. “SP” shows in display, followed by “P=L” or P=U”. 4. Press to either lock (“P=L”) or unlock (“P=U”) the controls. Locking the controls will not allow anyone to change the heat values of the shelves until the controls are unlocke