Extron electronic sMGP 464 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

MGP Series Setup Guide
The MGP Series are multi-window video signal processors that can display
multiple video sources on a single screen in picture-in-picture or picture-by-
picture format. The processors can switch among inputs as well as picture
controls and presets. The available models are listed below. The MGP 464
models display up to four windows; the MGP 462xi models display one or two.
• MGP 464/MGP 462xi — Standard models with BNC input connectors that accept RGB, component vid

ملخص المحتوى في الصفحة رقم 2

MGP Series Setup Guide (cont'd) DVI Background input — DVI for live background video only (available on all models). DVI BACKGROUND The two or four MGP windows are displayed in front of this DVI image. When a DVI background is used, the MGP output is locked to the input rate of the DVI background. This input is not scaled. Analog is not available on this DVI-I connector. N This input connector can be used only to receive the background image. The input is not scaled or processed. To pro

ملخص المحتوى في الصفحة رقم 3

MGP 464 and MGP 464W Setup Guide (cont'd) Executive Mode (Non-WindoWall Models Only) To prevent accidental changes to settings, executive mode locks all panel controls except Freeze, input selection, Preset Recall/Save, and the RS-232/422 and Ethernet ports. To enable/disable executive mode, press the Window/Image Size and Window/Image Position buttons simultaneously, and hold them down for 2 seconds. Setting Up the MGP Using the Front Panel (Non-WindoWall) After you have installed and conn

ملخص المحتوى في الصفحة رقم 4

MGP Series Setup Guide (cont'd) Adjusting the picture controls, continued 8. Use the Input Configuration menu to make any desired advanced adjustments, including Horizontal and Vertical Start, Pixel Phase, Total Pixels, Active Pixels, and Active Lines; or, ™ Perform Auto-Image . Auto-Image is a quick way to size an input to fit the current window size. To perform Auto-Image on an input, a. Press the button for the input that you want to auto size. b. Press the Menu button once to select