ملخص المحتوى في الصفحة رقم 1
User Guide
Twisted Pair
MTPX Plus Series
MTP Twisted Pair Matrix Switchers
68-1383-01 Rev. E
08 11
ملخص المحتوى في الصفحة رقم 2
Safety Instructions • English Warning Power sources • This equipment should be operated only from the power source indicated on the product. This This symbol is intended to alert the user of important operating and equipment is intended to be used with a main power system with a grounded (neutral) conductor. The third maintenance (servicing) instructions in the literature provided with the (grounding) pin is a safety feature, do not attempt to bypass or disable it. equipment. Power disconnec
ملخص المحتوى في الصفحة رقم 3
FCC Class A Notice This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference. 1. This device must accept any interference received, including interference that may cause undesired operation. The Class A limits are designed to provide reasonable protection against harmful interference when the equipment is operated in
ملخص المحتوى في الصفحة رقم 4
Conventions Used in this Guide In this user guide, the following are used: NOTE: A note draws attention to important information. TIP: A tip provides a suggestion to make working with the application easier. CAUTION: A caution indicates a potential hazard to equipment or data. WARNING: A warning warns of things or actions that might cause injury, death, or other severe consequences. Commands are written in the fonts shown here: ^AR Merge Scene,,Op1 scene 1,1 ^B 51 ^W^C [01] R 0004 00300 00400
ملخص المحتوى في الصفحة رقم 5
Contents Defining the Audio/RS-232 Wire Pair .......... 62 Introduction ............................................ 1 Selecting the Rear Panel Remote Port About this Manual ........................................... 1 Protocol and Baud Rate ............................. 63 About the Matrix Switchers .............................. 1 Rear Panel Operations .................................... 64 TP Cable Advantages ................................... 4 Performing a Hard Reset (Reset 1) .........
ملخص المحتوى في الصفحة رقم 6
Using Emulation Mode ............................. 119 Ethernet Connection............................ 146 Using the Help System ............................. 120 Ethernet Link ............................................... 146 Optimizing the Video ................................... 121 Ethernet Connection ................................ 146 MTP Transmitter Pre-Peak Selection .......... 121 Default IP Address .................................... 146 MTPX Level/Peaking Setting ................
ملخص المحتوى في الصفحة رقم 7
Introduction • About this Manual • About the Matrix Switchers • TP Cable Advantages • Features About this Manual This manual contains installation, configuration, and operating information for the Extron® MTPX Plus MTP Twisted Pair Matrix Switchers. About the Matrix Switchers The MTPX Plus matrix switchers distribute signals that are compatible with the Extron MTP and VTT/VTR product lines. The matrix switcher routes a twisted pair (TP) or video input signal to any combination of TP or video
ملخص المحتوى في الصفحة رقم 8
Rack Mounted PC Control TCP/IP System Network Extron MTP U R RSA SEQ Universal Receiver RS 232 Audio S-video RGBHV Flat Panel Display Extron MTP U R A Universal Receiver Audio S-video Extron MTPX Plus 3232 Twisted Pair Matrix Switcher RGBHV Extron Extron SI 28 Projector HPA 502 Surface-mount Audio Power Extron Speakers Ampli er MTP T SV A Extron Transmitter MTP T 15HD A Extron Transmitter MTP T 15HD A D Transmitter PC PC DVD Figure 1. Typical MTPX Plus Twisted Pair Matrix Switcher Applicatio
ملخص المحتوى في الصفحة رقم 9
The switcher can be operated remotely by any of the following when that device is connected to either MTPX Plus serial port: • A control system • A PC • An Extron MKP 2000 remote control panel • An Extron MKP 3000 remote control panel For some outputs (most matrix sizes) or all outputs (MTPX Plus 128), bidirectional pass- through RS-232 signals from a dedicated source (rather than from the selected input) can be directly inserted into the signal set routed to the TP output. You can even route
ملخص المحتوى في الصفحة رقم 10
TP Cable Advantages Twisted pair cable is much smaller, lighter, more flexible, and less expensive than coaxial cable. These TP products make cable runs simpler and less cumbersome. Termination of the cable with RJ-45 connectors is simple, quick, and economical. CAUTION: Do not connect this device to a computer data or telecommunications network. Transmission distances The maximum distances are determined by the frequency and resolution of the video signal being routed and by which MTPX Plus
ملخص المحتوى في الصفحة رقم 11
Table 1. Recommended maximum TP transmission distances at 60 Hz, 1 MTP transmitter to switcher when the display is on the MTPX Plus local (VGA) output AUDIO MTP T 15HD A PRE-PEAK MTP Transmitter POWER 12V ON .5A MAX 1 INPUT MONITOR OFF OUTPUT LOCAL INPUTS INPUTS 12 34 56 78 910111213141516 LISTED ® US 1T23 I.T.E. INPUT 13 2 SELECT LOCAL 45 6 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 RJ-45 RS-232 OUTPUT INSERTION LOCAL OUTPUTS OUTPUTS 1 2 3 4 5 6 7 8 12 34 56 78 910111213141516 T
ملخص المحتوى في الصفحة رقم 12
Table 2. Recommended maximum TP transmission distances at 60 Hz, — transmitter to receiver using MTPX Plus TP inputs and outputs MTP Transmitter AUDIO MTP T 15HD A PRE-PEAK POWER MTP Receiver 12V ON .5A MAX 3 OUTPUTS MTP U R A INPUT MONITOR OFF OUTPUT POWER LOCAL INPUTS INPUTS VID MONO AUDIO 12 34 56 78 910111213141516 LISTED 0.5A MA 12V X L R ® US 1T23 I.T.E. RGB Y/C INPUT 13 2 INPUT SELECT LOCAL 45 6 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 RJ-45 RS-232 OUTPUT INSERTION
ملخص المحتوى في الصفحة رقم 13
Table 3. Recommended maximum TP transmission distances at 60 Hz, — VTT transmitter to VTR receiver using MTPX TP inputs and outputs VTT Transmitter TX POWER VIDEO INPUT 3 VTR Receiver LOCAL INPUTS INPUTS RX 12 34 56 78 910111213141516 LISTED ® US 1T23 POWER I.T.E. VIDEO OUTPUT INPUT 13 2 SELECT LOCAL 45 6 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 RJ-45 RS-232 OUTPUT INSERTION LOCAL OUTPUTS OUTPUTS 1 2 3 4 5 6 7 8 12 34 56 78 910111213141516 Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx
ملخص المحتوى في الصفحة رقم 14
Skew equalization Skew exists between wire pairs when the physical length of one wire pair is different from another. Skew affects the displayed image when the differential length between wire pairs exceeds 2 feet. This causes the timing of the red, green, and blue video signals to appear out of alignment (horizontal registration errors). The signals transmitted on the shortest pair are shifted to the left if you are viewing white lines on a black background. A white vertical line on a blac
ملخص المحتوى في الصفحة رقم 15
Switching flexibility — The switcher provides individually buffered, independent, matrix switched outputs with audio follow and audio breakaway. • Tie any input to any or all outputs. • Quick multiple tie — Multiple inputs can be switched to multiple outputs simultaneously. This allows all displays (outputs) to change from source to source at the same time. • Audio follow — Audio can be switched with its corresponding video input via front panel control or via serial port remote control. • A
ملخص المحتوى في الصفحة رقم 16
Rack mounting — The 1U high (MTPX Plus 128), 2U high (other matrix sizes 1616 and smaller), or 3U high (matrix sizes 1632 and larger) enclosure is rack mountable in any conventional 19-inch wide wide rack. The 2U and 3U enclosures are mountable without extra hardware. The 1U enclosure is rack mountable using the provided mounting kit. Three front panel security lockout modes (Executive modes) — If a matrix switcher is installed in an open area, where operation by unauthorized personnel may b
ملخص المحتوى في الصفحة رقم 17
RESET Installation This sections details the installation of the MTPX Plus Matrix Switchers, including: • Mounting the Switcher • Rear Panel Cabling and Settings • Front Panel Configuration Port Mounting the Switcher CAUTION: Installation and service must be performed by authorized personnel only. Detailed mounting instructions can be found in the “Reference Information“ section at the end of this guide. The MTPX Plus switchers are housed in a 1U high (MTPX Plus 128), 2U high (other matrix siz
ملخص المحتوى في الصفحة رقم 18
Figure 4 shows the rear panel of the MTPX Plus 3232. 2 7 1 LOCAL INPUTS INPUTS 12 34 56 78 910111213141516 LISTED ® US 1T23 I.T.E. INPUTS INPUT 13 2 SELECT LOCAL 44 45 6 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 RJ-45 RS-232 OUTPUT INSERTION LOCAL OUTPUTS OUTPUTS 1 2 3 4 5 6 7 8 12 34 56 78 910111213141516 Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx 1 5 6 9 10 11 12 13 14 15 16 Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx 2 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 3.2A MAX 3.
ملخص المحتوى في الصفحة رقم 19
Figure 5 shows the recommended termination of TP cables in accordance with the TIA/EIA T568A or TIA/EIA T568B wiring standards. You can use either standard with CAT 5, 5e, or 6 cable, but use the same standard on both ends of the cable. Pins:12345678 T568A T568B Video input (via transmitter or local input) Secondary input Pin Wire color Wire color RGB Composite S-video Stereo audio RS-232 1 White-green White-orange Red+/V. sync+ Reserved Chroma (C)+ 2 Green Orange Red–/V. sync– Reserved Chroma
ملخص المحتوى في الصفحة رقم 20
LR LR c Audio Inputs (local audio) connectors — Connect balanced or unbalanced stereo audio inputs to these 3.5 mm, 5-pole captive screw connectors. Connectors are included with each switcher, but you must supply the audio cable. See figure 7 to wire a connector for the appropriate input type and impedance level. Use the supplied tie-wrap to strap the audio cable to the extended tail of the connector. High impedance is generally over 800 ohms. Tip Tip Sleeve Ring Sleeve (s) Tip Tip Sleev
