ملخص المحتوى في الصفحة رقم 1
6H128-08 and 6H129-08
SmartSwitch 6000 Modules
User’s Guide
FAST ENET FAST ENET
6H128-08 6H129-08
RESET RESET
COM COM
CPU CPU
1 1
2 2
3 3
4 4
5 5
6 6
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9032364-02
ملخص المحتوى في الصفحة رقم 2
ملخص المحتوى في الصفحة رقم 3
Only qualified personnel should install the 6H128-08 and the 6H129-08. NOTICE Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made. The hardware, firmware, or software described in this manual is subject to change without notice. IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE
ملخص المحتوى في الصفحة رقم 4
Notice INDUSTRY CANADA NOTICE This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.
ملخص المحتوى في الصفحة رقم 5
Notice CABLETRON SOFTWARE PROGRAM LICENSE 1. LICENSE. You have the right to use only the one (1) copy of the Program provided in this package subject to the terms and conditions of this License Agreement. You may not copy, reproduce or transmit any part of the Program except as permitted by the Copyright Act of the United States or as authorized in writing by Cabletron. 2. OTHER RESTRICTIONS. You may not reverse engineer, decompile, or disassemble the Program. 3. APPLICABLE LAW. This
ملخص المحتوى في الصفحة رقم 6
Notice SAFETY INFORMATION CLASS 1 LASER TRANSCEIVERS THE FE-100F3 FAST ETHERNET INTERFACE MODULE USES CLASS 1 LASER TRANSCEIVERS. READ THE FOLLOWING SAFETY INFORMATION BEFORE INSTALLING OR OPERATING THESE MODULES. The Class 1 laser transceivers use an optical feedback loop to maintain Class 1 operation limits. This control loop eliminates the need for maintenance checks or adjustments. The output is factory set, and does not allow any user adjustment. Class 1 Laser transceiver
ملخص المحتوى في الصفحة رقم 7
Notice DECLARATION OF CONFORMITY Application of Council Directive(s): 89/336/EEC 73/23/EEC Manufacturer’s Name: Cabletron Systems, Inc. Manufacturer’s Address: 35 Industrial Way PO Box 5005 Rochester, NH 03867 European Representative Name: Mr. J. Solari European Representative Address: Cabletron Systems Limited Nexus House, Newbury Business Park London Road, Newbury Berkshire RG13 2PZ, England Conformance to Directive(s)/Product Standards: EC Directive 89/336/EEC EC Dir
ملخص المحتوى في الصفحة رقم 8
Notice vi 6H128-08 and 6H129-08 User’s Guide
ملخص المحتوى في الصفحة رقم 9
CONTENTS CHAPTER 1 INTRODUCTION 1.1 Using This Guide......................................................................... 1-1 1.2 Structure of This Guide................................................................ 1-1 1.3 6H12X-08 Overview .................................................................... 1-3 1.3.1 Connectivity .................................................................... 1-3 1.3.2 Full Duplex Switched Ethernet (FDSE)........................... 1-3 1.3
ملخص المحتوى في الصفحة رقم 10
Contents CHAPTER 4 TROUBLESHOOTING 4.1 Using LANVIEW...........................................................................4-1 4.2 FE-100TX LED.............................................................................4-5 4.3 Troubleshooting Checklist............................................................4-6 4.4 Using the RESET Button .............................................................4-7 CHAPTER 5 LOCAL MANAGEMENT 5.1 Overview .........................................
ملخص المحتوى في الصفحة رقم 11
Contents 5.15 General Configuration Screen................................................... 5-40 5.15.1 Setting the IP Address .................................................. 5-44 5.15.2 Setting the Subnet Mask............................................... 5-46 5.15.3 Setting the Default Gateway ......................................... 5-46 5.15.4 Setting the TFTP Gateway IP Address......................... 5-47 5.15.5 Setting the Module Date ...........................................
ملخص المحتوى في الصفحة رقم 12
Contents 5.26 Switch Statistics Screen.............................................................5-86 5.26.1 Using the Clear Counters Command ............................5-87 5.27 Interface Statistics Screen .........................................................5-88 5.27.1 Displaying Interface Statistics .......................................5-91 5.27.2 Using the Clear Counters Command ............................5-91 5.28 RMON Statistics Screen ..................................
ملخص المحتوى في الصفحة رقم 13
CHAPTER 1 INTRODUCTION Welcome to the Cabletron Systems 6H128-08 and 6H129-08 SmartSwitch 6000 Modules User’s Guide. This guide describes the 6H128-08 and 6H129-08 interface modules and provides information concerning network requirements, installation, troubleshooting, and the use of Local Management for these modules. 1.1 USING THIS GUIDE Read through this guide completely to understand the features, capabilities, and Local Management functions of the 6H128-08 and 6H129-
ملخص المحتوى في الصفحة رقم 14
Chapter 1: Introduction Chapter 3, Installation, provides instructions on how to install the module in the chassis and connect segments to the device. Chapter 4, Troubleshooting, details the 6H12X-08 LANVIEW LEDs that enable quick diagnosis of network/operational problems. Chapter 5, Local Management, describes how to access Local Management and use the Local Management screens to manage the 6H12X-08 and 6C105 chassis. Appendix A, Specifications, contains information on funct
ملخص المحتوى في الصفحة رقم 15
6H12X-08 Overview 1.3 6H12X-08 OVERVIEW The 6H12X-08 (the 6H128-08 is shown in Figure 1-1) is a Fast Ethernet interface module for the Cabletron Systems 6C105 chassis. The module has six switched fiber optic ports and two optional ports for Fast Ethernet Interface Modules. The 6H128-08 has six multimode fiber optic 100BASE-FX switched ports using SC connectors, while the 6H129-08 has six single mode fiber optic 100BASE-FX switched ports also using SC connectors. The 6H12X-08 supports
ملخص المحتوى في الصفحة رقم 16
Chapter 1: Introduction FAST ENET 6H128-08 RESET Reset Button COM COM Port CPU CPU LED 1 2 3 Port Status LEDs 4 5 6 1 2 3 Network Ports 1-6 4 5 6 7 Optional Fast Ethernet Module Ports 7 and 8 8 23640101 Figure 1-1 The 6H12X-08 1-4 6H128-08 and 6H129-08 User’s Guide
ملخص المحتوى في الصفحة رقم 17
6H12X-08 Overview 1.3.3 Runtime IP Address Discovery This feature enables the 6H12X-08 to automatically accept an IP address from a BootP server on the network into NVRAM without requiring a user to enter an IP address through Local Management. When the 6H12X-08 is connected to the network and powered up, Runtime IP Address Discovery (RAD) checks the 6H12X-08 for an IP address. If one has not been assigned (6H12X-08 IP address set to 0.0.0.0), RAD checks to see if any of the 6H12X-08
ملخص المحتوى في الصفحة رقم 18
Chapter 1: Introduction 1.3.5 Remote Monitoring (RMON) The 6H12X-08 supports all Ethernet RMON groups, which include Statistics, Alarms, Events and History. These groups are enabled on all ports by default. Cabletron Systems RMON Actions is a vendor specific extension of RMON and provides the ability to set an “Action” on any SNMP MIB variable. The Action can be triggered by any RMON Event and/or Alarm. The Action can be, for example, to turn a MIB-2 interface off if a broadcas
ملخص المحتوى في الصفحة رقم 19
Local Management Features 1.3.9 LANVIEW Diagnostic LEDs The various conditions of the LANVIEW diagnostic LEDs serve as important troubleshooting aids. They provide an easy way to observe the transmit and receive status of individual ports and overall network operations such as system status, switching configuration, and Fast Ethernet channel usage. Chapter 4 provides details about the 6H12X-08 LANVIEW LEDs. 1.4 LOCAL MANAGEMENT FEATURES Local Management provides the tools that al
ملخص المحتوى في الصفحة رقم 20
Chapter 1: Introduction 1.4.4 SmartTrunk SmartTrunk, also referred to as SmartTrunking, is Cabletron Systems’ terminology for load balancing or load sharing. SmartTrunk technology provides an easy-to-implement mechanism to group, or aggregate, multiple physical links together to scale the backbone bandwidth beyond the limitations of a single link. All links are user-configurable so administrators can scale the backbone bandwidth by adding SmartTrunk links. The SmartTrunk ben
