Winegard DE-4646 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

®
WINEGARD
Digital Elevation Sensor
Electronic Calibrated Model for RM and RD models
Model DE-4600/4646
U.S. Patent 5,945,945
DE-4600/4646 Only
Sensor w/Cable (2) 2160216
THIS UNIT HAS
2763236, DE-4600 #10-32 Hex Nut
2763235, DE-4646
BEEN CALIBRATED
AT THE FACTORY.
(2) 2160280
(2) 2160172
1/4-20 x 2" Hex Bolt
No further calibration
#10-32 x 1/2"
(2) 2160039
Screw
is necessary.
1/4" Flat Washer
(If for some reason, this unit’s
3720503
calibration fails, See Steps 4 through
Mounting Plate
8 in thi

ملخص المحتوى في الصفحة رقم 2

Step 3. Figure 4. To install Sensor with your Backup RM model, remove dish from backup frame. Frame Place Sensor inside backup frame, Figure 4. Sensor Cable must exit from bottom of Sensor. Case Route under pins, refer to Figure 4. Be sure Sensor case is placed so mounting screws are Cable completely in slots. Fasten Sensor case to frame, being careful not to overtighten screws. Secure Sensor cable to coax with wire ties. Go to Step 9. Figure 4 Antenna Use a level to If at any time after ensure

ملخص المحتوى في الصفحة رقم 3

Red White (+) Pos. 12VDC* (-) Neg. Ground* Green Black * CAUTION: DO NOT connect a 9 volt battery if using +12 VDC. 9 volt battery is recommended. #6 x 1/2" #6 x 5/8" Phillips Screw Phillips Screw (optional) SM-1000 Surface Mount Box DE-4600 only (optional), DE-4600 only Wallplate Display Unit CAUTION: If using +12 VDC, it must be FILTERED! If using non-filtered +12 VDC, the product will be damaged and Warranty voided. Figure 7 Step 7. Figure 7. If using the SM-1000 surface mount box, feed cable

ملخص المحتوى في الصفحة رقم 4

Figure 8 WIRING * CAUTION: DO NOT connect to +12 VDC Step 9. Use the 9 volt battery (9 volt if using a 9 volt battery. Use of 9 volt recommended for best performance) or battery recommended. hook up the +12 VDC. Pressing the Slide battery button should display 24 (+ or - 1 degree) into place when antenna is in vertical position. and cinch the cable tie Display automatically turns off after moderately approximately 1 minute. tight. Clip off excess tie. Step 10. Figure 8. It is recommended if usin