ملخص المحتوى في الصفحة رقم 1
COMPACT COMPONENT SYSTEM
CA-HXZ77D
CA-HXZ55D
DIGITAL
INSTRUCTIONS
GVT0119-001C
[US, UN, UG, UX]
Cover_HX-Z77D&55D[U]fff.p65 1 03.11.18, 8:36 PM
English
ملخص المحتوى في الصفحة رقم 2
Warnings, Cautions and Others Caution— button! Disconnect the mains plug to shut the power off completely. The button in any position does not disconnect the mains line. The power can be remote controlled. G-1 safety_HX-Z77&55[U]6.p65 1 03.8.18, 10:42 AM
ملخص المحتوى في الصفحة رقم 3
CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2. Do not expose this appliance to rain or moisture. CAUTION • Do not block the ventilation openings or holes. (If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.) • Do not place any naked flame sources, such as lighted candles, on the apparatus. • When discarding batteries, environmental problems must be considered and local r
ملخص المحتوى في الصفحة رقم 4
Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1 Front: No obstructions and open spacing. 2 Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below. 3 Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. Front view Side view 15 cm 15 cm 1 cm 1 cm 15 cm 15 cm 15 cm CA-HXZ77D CA-HXZ55D 10 cm G-3 safet
ملخص المحتوى في الصفحة رقم 5
IMPORTANT FOR LASER PRODUCTS 1. CLASS 1 LASER PRODUCT 2. CAUTION: Do not open the top cover. There are no user serviceable parts inside the Unit; leave all servicing to qualified service personnel. 3. CAUTION: Visible and invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam. 4. REPRODUCTION OF LABEL: CAUTION LABEL, PLACED INSIDE THE UNIT. G-4 safety_HX-Z77&55[U]6.p65 4 03.8.18, 10:42 AM
ملخص المحتوى في الصفحة رقم 6
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging the unit from the wall outlet, always pull on the plug, not the AC power cord. This manual is organized as follows: • The manual mainly explains operations using the buttons on the remote control. Yo
ملخص المحتوى في الصفحة رقم 7
Contents Location of the Buttons and Controls ....................... 3 Advanced Disc Operations ....................................... 35 Main Unit ................................................................... 3 About the On-screen Bar .......................................... 36 Remote Control .......................................................... 5 Operation through the On-screen Bar ...................... 37 Selecting a View Angle ............................................ 40 G
ملخص المحتوى في الصفحة رقم 8
G N I N U T D N E T E U E M D S O U Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Main Unit Front Panel STANDBY DISC1 DISC2 DISC3 DISC4 DISC5 1 u CD-R/RW PLAYBACK 2 3 COMPACT COMPONENT SYSTEM 4 EXTENDED DIGITAL SUPER BASS 5 i 6 MIC LEVEL MAX MIN CLOCK /TIMER 7 o SET DISC 1 READY DISC 2 READY DISC 3 READY DISC 4 READY DISC 5 READY /DISPLAY 1 ; PROGRESSIVE 2CH STEREO DOLBY DIGITAL DTS SURROUND DOLBY PRO LOGIC CANCEL MIC /DEMO 8 a
ملخص المحتوى في الصفحة رقم 9
Continued Display Window 12345 67 8 9 pw q ertyiu o ; See pages in parentheses for details. Front Panel 1 (standby/on) button and STANDBY lamp g • TUNING + / – buttons (22) (15, 22, 55, 56) •¡ / 1 (forward search/reverse search) buttons (17, 24, 31) 2 Disc trays •7 (stop) button • DISC1 – DISC5 • BEEP button (10, 16) 3 Remote sensor h SOUND MODE button (16) 4 Display window j DVD LEVEL button (31) 5 DISC ready lamps (28) k 0 EJECT button for cassette deck (24, 47, 48) • DISC 1 READY – DISC 5 REA
ملخص المحتوى في الصفحة رقم 10
G N I N U T R D E N E T B E U E M M D S O U U Location of the Buttons and Controls (continued) Remote Control See pages in parentheses for details. Remote Control 1 Disc number buttons* (29, 30, 33, 44, 48) • DISC1 – DISC5 2 Number buttons (22, 30 – 33, 38, 44, 52, 64, 65) 3 CANCEL button* (34, 52) DISC1 DISC2 DISC3 4 • ZOOM button (42) o • ECHO button* (50, 51) 1 DISC4 DISC5 5 PROGRESSIVE button (17) ; 2 6 • AUDIO button (41, 51, 52) • KARAOKE button* (50 – 52) a 3 7 TOP MENU button (32) s 8 •
ملخص المحتوى في الصفحة رقم 11
Getting Started Continued Supplied Accessories Connecting Antennas Make sure that you have all the following items. FM antenna The number in parentheses indicates the quantity of each piece supplied. FM antenna (supplied) • AM loop antenna (1) • FM antenna (1) • Remote control (1) • Batteries (2) • Composite video cord (1) • AC plug adaptor (1) If anything is missing, consult your dealer immediately. Putting the Batteries into the Remote Control 1 Attach the FM antenna to the FM 75 Ω Insert the
ملخص المحتوى في الصفحة رقم 12
Getting Started (continued) AM antenna Connecting Speakers IMPORTANT: Use only speakers with the same speaker 1 impedance as indicated by the speaker terminals on the rear of the unit. 2 3 4 1 ANTENNA 23 4 Vinyl-covered wire AM AM EXT (not supplied) LOOP FM 75 COAXIAL 5 Speaker Speaker cords cords (black/ (black/ Speaker cords blue) blue) (black/red) AM loop antenna (supplied) From right From left front main front main From front speaker speaker subwoofer terminal terminal terminal 1 If the cord
ملخص المحتوى في الصفحة رقم 13
To connect a center speaker and surround speakers Connecting a TV By connecting a center speaker to the CENTER SPEAKER jack and surround speakers to the SURROUND SPEAKERS jacks, you can Connect your TV and this unit using the composite video cord enjoy multi-channel Surround modes. (See pages 18 to 20.) (supplied), an S-video cord (not supplied) or Component video cord (not supplied). • You can also connect a JVC’s TV through the AV COMPU LINK control system. (See page 67.) Center speaker NTSC/P
ملخص المحتوى في الصفحة رقم 14
Getting Started (continued) To select the color system Connecting Other Equipment You need to select the color system setting of this unit to match to your TV. You can connect other equipment such as a digital decoder to reproduce multi-channel sounds or audio equipment which can be Set the NTSC/PAL switch on the rear while in standby mode used as a playback device. correctly by referring to the table below. When you connect and use such equipment, refer also to its manual. • DO NOT connect othe
ملخص المحتوى في الصفحة رقم 15
To cancel only beep sounds during the demonstration, press Adjusting the Voltage Selector BEEP ON/OFF or press and hold BEEP (7) for more than 2 seconds on the front panel. The BEEP ON indicator goes off from the Before plugging in the unit, set the correct voltage for your area with display. the voltage selector on the rear of the unit. On the remote control On the front panel • “0:00” flashes on the display until you set the built-in clock. After VIDEO OUT COMPONENT S-VIDEO VIDEO PR PB Y NTSC
ملخص المحتوى في الصفحة رقم 16
Getting Started (continued) 7 Press ENTER. For the following procedure, use the remote control. The language for the choice menu changes to To select the on-screen language for the choice menu the one you chose. —Step 1: • Other indications shown on the TV while you operate the unit will also be shown in 1 Turn on the TV and select the correct input mode the language you chose. on the TV. Go to “To select the monitor type—Step 2” below. 2 Press DISC 3, then 7. The unit turns on and the opening s
ملخص المحتوى في الصفحة رقم 17
To adjust the speaker distance—Step 3: 6 Press cursor ∞ / 5 repeatedly to You need to adjust the each speaker’s distance from where you select (highlight) the desired speaker usually take seat (listening position) to get the best surround effect. distance. For each speaker (FRONT SPEAKER, CENTER Center speaker Front SPEAKER, SURROUND SPEAKER), set the distance subwoofer from the listening point within the range of 0.3 m to 9.0 m in 0.3 m intervals. DISTANCE FRONT SPEAKER 3.0m 3.0m 3.0m CENTER S
ملخص المحتوى في الصفحة رقم 18
Getting Started (continued) 5 Press SET/DISPLAY to finish setting the clock. Setting the Clock “CLOCK OK” appears on the display, then the built-in clock You can set the clock when the unit is either turned on or off (on starts. standby). To check the clock time while playing a source Press and hold SET/DISPLAY. • Each time you press and hold the button, the source indication and the clock time alternate on the display. To adjust the clock again If you have set the clock before, press CLOCK/TIM
ملخص المحتوى في الصفحة رقم 19
Basic Operations The buttons emphasized in the illustration below are used and explained in the following section (pages 15 to 17). Remote Control DISC1 DISC2 DISC3 DISC4 DISC5 ECHO RESERVE RM-SHXZ55DU REMOTE CONTROL Front Panel 14 14-17HX-Z77&55[U]6.p65 14 03.8.18, 10:42 AM English
ملخص المحتوى في الصفحة رقم 20
Basic Operations (continued) Adjusting the Volume Turning On the Power You can adjust the volume level only while the unit is turned on. Press STANDBY/ON (or on the front panel). • The volume level has no effect on recording. The STANDBY lamp goes off. Press VOLUME + / – (or turn VOLUME + / – “POWER ON” appears on the display. control on the front panel). • You can adjust the volume level within the range of MIN (silent), 1 to 30, MAX (maximum). • As you adjust the volume, the display changes
