ملخص المحتوى في الصفحة رقم 1
Cover[B]_UX-S59.fm Page 1 Tuesday, March 15, 2005 12:10 PM
MICRO COMPONENT SYSTEM
UX-S59—Consists of CA-UXS59 and SP-UXS59
INSTRUCTIONS
LVT1358-001A
[B]
g
ملخص المحتوى في الصفحة رقم 2
Safety[B].fm Page 1 Wednesday, February 16, 2005 5:47 PM Warnings, Cautions and Others IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. If nonetheless the mains plug
ملخص المحتوى في الصفحة رقم 3
Safety[B]_UX-S59.fm Page 2 Tuesday, March 8, 2005 4:01 PM Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1. Front: No obstructions and open spacing. 2. Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below. 3. Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. 15 cm Front Side 15 cm 1
ملخص المحتوى في الصفحة رقم 4
Safety[B].fm Page 3 Wednesday, February 16, 2005 5:47 PM SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension
ملخص المحتوى في الصفحة رقم 5
1_UX-S59[B]TOC.fm Page 1 Friday, March 4, 2005 9:22 AM Contents Introduction........................................................ 2 Precautions.......................................................................... 2 How to Read This Manual.................................................. 2 Getting Started ................................................... 3 Step 1: Unpack.................................................................... 3 Step 2: Prepare the Remo
ملخص المحتوى في الصفحة رقم 6
2_Introduction.fm Page 2 Wednesday, February 16, 2005 5:45 PM Introduction • If you are not going to operate the System for an extended Precautions period of time, unplug the AC power cord from the wall outlet. Installation If anything goes wrong, unplug the AC power cord and • Install in a place which is level, dry and neither too hot nor consult your dealer. too cold—between 5°C and 35°C. • Install the System in a location with adequate ventilation to How to
ملخص المحتوى في الصفحة رقم 7
AM EXT AM LOOP GND ANTENNA 2_Introduction.fm Page 3 Wednesday, February 16, 2005 5:45 PM Getting Started Step 1: Unpack Step 1:Unpack the package and check the accessories. After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied. • FM antenna (1) • AM loop antenna (1) • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately. Step 2: Prepare the Remote Co
ملخص المحتوى في الصفحة رقم 8
AM AM EXT EXT AM LOOP GND GND ANTENNA 3_Connection.fm Page 4 Friday, February 25, 2005 1:24 PM Step 3: Hook Up If you need more detailed information, see page 6. Illustrations of the input/output terminals below are typical examples. When you connect other components, refer also to their manuals since the terminal names actually printed on the rear may vary. Turn the power off to all components before connections. For better FM/AM reception AM loop antenna Keep it connected. Outdoor
ملخص المحتوى في الصفحة رقم 9
AM LOOP AM EXT GND ANTENNA 3_Connection.fm Page 5 Monday, March 28, 2005 2:24 PM FM antenna (supplied) Extend it so that you can obtain the best reception. AM loop antenna (supplied) Turn it until the best reception is obtained. Black striped Non-striped 5
ملخص المحتوى في الصفحة رقم 10
3_Connection.fm Page 6 Wednesday, February 16, 2005 5:45 PM To connect the AM loop antenna To assemble and connect the AM loop antenna Make sure to connect the wire correctly: The white end to To assemble the AM loop antenna AM EXT, the black end to GND. 1 Hold 3 Release 2 Insert • If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl. • Make sure the antenna conductors do not touch any other
ملخص المحتوى في الصفحة رقم 11
3_Connection.fm Page 7 Tuesday, March 8, 2005 3:14 PM Before Operating the System The indications on the display teach you a lot of things while you are operating the System. Before operating the System, be familiar with when and how the indicator illuminates on the display. 1 Disc tray indicators • 1–5: Disc tray number 12 3 4 5 •: Tray indicator – Lights when the disc is detected. REC MP3 SOUND TURBO AHB PRO MONO ST GR. – Blinking while playing back a disc. – Goes off when t
ملخص المحتوى في الصفحة رقم 12
4_Basic.fm Page 8 Wednesday, March 23, 2005 9:08 AM Daily Operations—Playback 1 Turn on the power. The STANDBY lamp on the main unit turns off. • Without pressing STANDBY/ON , the System turns on by pressing one of the source selecting 1 Numeric buttons in the next step. buttons SET 2 Select the source. RDS DISPLAY 4/1, Playback automatically starts if the selected source is /DISPLAY 7,¡/¢ ready to start. PRESET UP, • If you press AUX, start playback source on the PRESET DO
ملخص المحتوى في الصفحة رقم 13
4_Basic.fm Page 9 Wednesday, February 16, 2005 5:45 PM Remote Listening to the Radio ONLY To preset the stations You can preset 30 FM and 15 AM stations. To select the band (FM or AM) 1 Tune in to a station you want to preset. FM AM 2 Activate the preset number entry mode. SET REC To tune in to a station • Finish the following process while the indication on the While FM or AM is selected... display is flashing. Remote control: Main unit: 3 Select a preset number fo
ملخص المحتوى في الصفحة رقم 14
4_Basic.fm Page 10 Tuesday, March 8, 2005 3:15 PM Remote ONLY To tune in to a preset station To select a disc to be played back CD 1 CD 2 CD 3 1 Select a band (FM or AM). CD 4 CD 5 FM AM To start: To pause: To stop: 2 Select a preset number for the station you store. • You can also use the 1 2 3 PRESET UP or PRESET DOWN. 4 5 6 To release, press again. 8 9 7 10 10 To select a track/group* Increases the track/group* numbers. Decreases the track/group* Playing B
ملخص المحتوى في الصفحة رقم 15
Hierarchy 4_Basic.fm Page 11 Tuesday, March 8, 2005 3:15 PM Playing Back Other Equipment For MP3 playback According to the MP3 playback mode, 4/1 / To connect other equipment ¡/¢ or number buttons work for the group By using an stereo mini plug cord (not supplied), you can selection or the track selection. connect equipment with analog audio output jacks such as an MD player, or a TV, etc. Examples: Stereo mini plug cord (not supplied) When the MP3 play back mode is “GROUP.” GR.
ملخص المحتوى في الصفحة رقم 16
4_Basic.fm Page 12 Wednesday, February 16, 2005 5:45 PM Daily Operations—Sound & Other Adjustments Adjusting the Volume Remote control You can adjust the volume level from level 0 (VOL-MIN) to level 31 (VOL-MAX). Remote control: Main unit: VOLUME SET CANCEL VOLUME RDS DISPLAY CLOCK/ /DISPLAY TIMER Remote ONLY To drop the volume in a moment 4/1, PRESET UP, 7,¡/¢ PRESET DOWN To restore the volume, press again, or FADE MUTING adjust the volume level. DIMMER FADE A.STANDBY
ملخص المحتوى في الصفحة رقم 17
4_Basic.fm Page 13 Wednesday, February 16, 2005 5:45 PM If there is a power failure Changing the Display Brightness—DIMMER The clock loses the setting and is reset to “0:00.” You need to set the clock again. You can dim the display window. DIMMER DIMMER-1 DIMMER-2 Turning Off the Power Remote DIM OFF ONLY Automatically (Canceled) To turn off the System after playback is over— DIMMER-1 Dims the display illumination. Auto Standby DIMMER-2 Erases the display illumination. A.STANDBY Remote
ملخص المحتوى في الصفحة رقم 18
5_AdvancedRadio.fm Page 14 Tuesday, March 8, 2005 3:16 PM Advanced Radio Operations To show the RDS information Remote control While listening to an FM station... PS Station names is displayed. “NO PS” will appear if no signal is sent. PTY The broadcast program type is displayed. “NO RDS DISPLAY /DISPLAY PTY” will appear if no signal is sent. TA/News/Info PTY RT Text messages the station sends is displayed. SELECT +/– “NO RT” will a
ملخص المحتوى في الصفحة رقم 19
5_AdvancedRadio.fm Page 15 Wednesday, March 23, 2005 9:13 AM 3 Start searching. How the Enhanced Other Networks function actually PTY works: SEARCH CASE 1 If a station is not broadcasting the program of your choice The System continues tuning in to the current station. « When a station broadcasting the program of your choice, Ex.: When “NEWS” is selected the System automatically switches to the station. TA/News/Info indicator starts flashing. The receiver searches
ملخص المحتوى في الصفحة رقم 20
6_AdvancedDisc.fm Page 16 Tuesday, March 1, 2005 5:41 PM Advanced Disc Operations Programming the Playing Order— Remote control Remote ONLY Program Play You can arrange the playing order of the tracks (up to 32) before you start playback. • You cannot enjoy MP3 discs for program play. • You can repeat all the programmed tracks by pressing REPEAT. Numeric CANCEL buttons 1 Before starting playback, press PROGRAM. PROGRAM REC 4/1,7, ¡/¢ PRGM CD 6 REPEAT 2 Select a
