ملخص المحتوى في الصفحة رقم 1
DX-U20_9[U]c_s.book Page 1 Wednesday, March 4, 2009 1:21 PM
COMPACT COMPONENT SYSTEM
CA-DXU20
CA-DXU9
CA-DXU20
CA-DXU9
SUPER VIDEO
INSTRUCTIONS
GVT0270-001A
[US, UN, UG, UX, A, UW]
ملخص المحتوى في الصفحة رقم 2
DX-U20_9[U]c_s.book Page 1 Wednesday, March 4, 2009 1:21 PM Warnings, Cautions and Others CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2. Do not expose this appliance to rain or moisture. CAUTION The button in any position does not disconnect the mains line. Disconnect the mains plug to shut the power off completely (the STANDBY lamp goes off). The MAINS plug or an appliance coupler is used as the disconnect device, the disconnect d
ملخص المحتوى في الصفحة رقم 3
DX-U20_9[U]c_s.book Page 2 Wednesday, March 4, 2009 1:21 PM Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1. Front: No obstructions and open spacing. 2. Sides/Top/Back: No obstructions should be placed in the areas shown by the dimensions below. 3. Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. Front view Side view Wall or ob
ملخص المحتوى في الصفحة رقم 4
DX-U20_9[U].book Page 1 Wednesday, March 4, 2009 10:59 AM Introduction About color system Playable Disc/File Types INFO This System accommodates both NTSC and PAL system and can play back discs/files recorded in either system. To change the color system, see page 6. DIGITAL VIDEO Note on Region Code DVD players and DVD Video have their own Region Code COMPACT numbers. This System can play back only DVD Video with SUPER VIDEO DIGITAL AUDIO an appropriate Region Code number. � For details, s
ملخص المحتوى في الصفحة رقم 5
DX-U20_9[U].book Page 2 Wednesday, March 4, 2009 10:59 AM Precautions Contents Connections ................................................................................... 3 Installation Connecting a USB Mass Storage Class Device.......................... 6 � Install the System in a location with adequate ventilation to Preparing the Remote Control .................................................... 6 prevent internal heat build-up in the System. Canceling the Demonstration .............
ملخص المحتوى في الصفحة رقم 6
DX-U20_9[U].book Page 3 Wednesday, March 4, 2009 10:59 AM Connections Do not connect the AC power cord until all other Supplied accessories connections have been made. � FM antenna (x1) � AM loop antenna (x1) � Composite video cord (x1) � Connect VIDEO OUT directly to the video input of your � Remote control (x1) TV. Connecting VIDEO OUT to a TV via a VCR may � Batteries (x2) interfere with your viewing when playing back a copy- � AC plug adapter (x1) protected source. Connecting VIDEO OUT
ملخص المحتوى في الصفحة رقم 7
OPTICAL DIGITAL OUTPUT DX-U20_9[U].book Page 4 Wednesday, March 4, 2009 10:59 AM 1 TV/monitor 4 AM/FM antenna To assemble the AM loop antenna Composite video cord (supplied) S-Video cord (not supplied) Green Red Blue To connect AM/FM antenna Component video cord (not supplied) � If the antenna cord is covered with vinyl on the tip, twist and pull the vinyl off to remove. � To select progressive scanning mode (see page 6), use COMPONENT jacks. AM loop antenna (supplied) • Connect the VIDEO
ملخص المحتوى في الصفحة رقم 8
DX-U20_9[U].book Page 5 Wednesday, March 4, 2009 10:59 AM � The front and center speakers and subwoofer(s) are 5 Speakers magnetically shielded to avoid color distortions on TVs. To connect the speaker cords However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the speakers. – When placing the speakers near a TV set, turn off the TV’s main power switch or unplug it before installing the speakers. 1Push 2Insert 3Release The
ملخص المحتوى في الصفحة رقم 9
DX-U20_9[U].book Page 6 Wednesday, March 4, 2009 10:59 AM 6 Voltage selector (not applicable for Canceling the Demonstration Main Unit ONLY Australian models) Use a screwdriver to rotate the 2 sec. voltage selector so that the voltage mark is pointing to the same voltage DEMO OFF as where you are plugging in the unit. DEMO START (See also the back cover page.) To start the demonstration, select DEMO START. Voltage mark 7 Power cord Changing the Color System and Plug the AC power cord to a
ملخص المحتوى في الصفحة رقم 10
DX-U20_9[U].book Page 7 Wednesday, March 4, 2009 10:59 AM Display Indication The indications on the display tell you a lot of things while you are operating the System. Before operating the System, be familiar with when and how the indicator illuminates on the display. 13 2 45 6 7 8 9p qw e r t y 1 Audio signal indicators 9 Play mode indicators � L/R/C/LS/RS/LFE: lights to indicate the incoming audio � PROGRAM: lights when Program Play is activated. channel signals. � RANDOM: lights when Rand
ملخص المحتوى في الصفحة رقم 11
DX-U20_9[U].book Page 8 Wednesday, March 4, 2009 10:59 AM Daily Operations—Playback 1 Turn on the power. In this manual, the operations using the remote control The STANDBY lamp on the main unit goes off. are mainly explained; however, you can use the buttons � Without pressing AUDIO, the System also turns and controls on the main unit if they have the same (or on by pressing one of the source selecting buttons in similar) name and marks. the next step. 2 Select the source. REVERSE MODE
ملخص المحتوى في الصفحة رقم 12
DX-U20_9[U].book Page 9 Wednesday, March 4, 2009 10:59 AM To tune in to a station Adjusting the Volume While FM or AM is selected... The volume level can be adjusted in 32 steps (VOLUME 1 sec. MIN, VOLUME 1 – VOLUME 30, and VOLUME MAX). SLOW Remote control: Main unit: AUDIO Frequency starts changing on the display. VOL When a station (frequency) with sufficient signal strength is tuned in, the frequency search stops. � When you repeatedly press the button, the frequency Remote changes step
ملخص المحتوى في الصفحة رقم 13
DX-U20_9[U].book Page 10 Wednesday, March 4, 2009 10:59 AM 4 Store the station. To connect a USB mass storage class device � To connect a USB mass storage class device, see page 6. ENTER /SET � Always set volume level to the minimum level when connecting or disconnecting the USB mass storage class device. � To disconnect the USB mass storage class device safely, turn off the System before disconnecting the device. To tune in to a preset station 1 Select the band (FM or AM). To play back di
ملخص المحتوى في الصفحة رقم 14
DX-U20_9[U].book Page 11 Wednesday, March 4, 2009 10:59 AM To return to normal playback, press DVD/CD 3 or To select a disc USB MEMORY 3. DISC 1 DISC 2 DISC 3 � For DivX files, each time you press the cursor 3 or 2, you can skip to a scene of 30 seconds or 5 minutes away DISC 4 DISC 5 depending on the DivX file. Playback starts. Remote ONLY To select a title/group While playing... MARK ABC DEF 12 3 GROUP/ Remote GHI JKL MNO ONLY TITLE To select an item directly 45 6 You can select a title/
ملخص المحتوى في الصفحة رقم 15
DX-U20_9[U].book Page 12 Wednesday, March 4, 2009 10:59 AM 7 For SVCD/VCD with PBC To start playback: To stop: While playing a disc with PBC, “PBC” appears on the display instead of the playing time. TAPE-A TAPE-B When disc menu appears on the TV screen, select an item on the menu. Playback of the selected item starts. � To select a number, see “How to MARK ABC DEF 12 3 select a number” on page 8. GHI JKL MNO To rewind or fast-forward tape: 45 6 SLOW PQRS TUV WXYZ 78 9 10 0 10 To change th
ملخص المحتوى في الصفحة رقم 16
DX-U20_9[U].book Page 13 Wednesday, March 4, 2009 10:59 AM Daily Operations—Sound & Other Adjustments Adjusting the Speaker Output Level Remote Control Remote ONLY INFO You can adjust the speaker output level from –6 (dB) to AUDIO +6 (dB). Initial setting: +4 (dB). TV � You can also use the setup menu to adjust the speaker AUDIO output level (see page 45). � This function is not available when the surround mode is TV set to “STEREO” or Mic Mixing is activated. 1 Select the speaker you want
ملخص المحتوى في الصفحة رقم 17
DX-U20_9[U].book Page 14 Wednesday, March 4, 2009 10:59 AM Applying an Optimal Bass Sound Effect Creating Your Own Sound Modes Remote ONLY —VARIO BASS —User Mode INFO You can adjust bass sound characteristics to create a sound You can adjust the preset Sound Modes to create your own suitable for the playback source of your preference. Sound Modes which suit your taste. The changed settings can be stored as the USER1, USER2 and USER3 Modes. AUTO OFF LITE.n.EASY VARIO BASS (Initial setting) (
ملخص المحتوى في الصفحة رقم 18
DX-U20_9[U].book Page 15 Wednesday, March 4, 2009 10:59 AM � While Surround Mode is activated, indicator Selecting the Surround Modes INFO lights up. • For “DVD/CD” and “USB” (multi-channel software): 1 * Selectable Surround Mode varies depending on the SURROUND 1 MODE * AUTO DOLBY D/DTS/PPCM/LPCM software. 2 STEREO * MOVIE (Dolby Pro Logic II Movie) and MUSIC (Dolby Pro Logic II Music) cannot be used for DivX file. 1 Initial setting: DOLBY D/DTS/PPCM/LPCM* • For “DVD/CD” and “USB” (stere
ملخص المحتوى في الصفحة رقم 19
DX-U20_9[U].book Page 16 Wednesday, March 4, 2009 10:59 AM To adjust the picture tone Remote ONLY Setting the Clock INFO 1 Select “USER1” or “USER2.” Without setting the built-in clock, you cannot use any timers � Follow steps 1 and 2 on page 15. except the Sleep Timer. 2 Select a parameter you want to adjust. � To exit from the clock setting, press CLOCK/TIMER as required. � To correct a misentry during the process, press CANCEL. ENTER You can return to the previous step. /SET 1 Activate
ملخص المحتوى في الصفحة رقم 20
DX-U20_9[U].book Page 17 Wednesday, March 4, 2009 10:59 AM Unique Video Disc/File Operations Remote Selecting the Audio Track ONLY INFO Remote Control For DVD Video/DivX: While playing back a chapter/file containing audio languages, you can select the language to listen to. AUDIO For DVD-VR/SVCD/VCD: While playing back a chapter/ TV track, you can select the audio channel to play. AUDIO � You can also select the audio track using the on-screen bar (see page 24). USB MEMORY 3 TV AUDIO/MPX D
