Extron electronic VEGA AUDIO SW6 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Specifications
VGA connector pin-9 - If your equipment/application requires that the pin-9 signal of the selected input be
passed to output connector pin-9, it will be necessary to add (solder) jumpers (JMP1 = Input 1, JMP2 = Input
2, etc.) onto the inside of the rear panel (see Figure 5-A). Each jumper consists of 2 etch/solder pads
separated by approximately 1/16th inch gap. Connect (solder a wire across) the 2 pads for the desired input/
jumper (example: for Input 1, connect the JMP1 solder p

ملخص المحتوى في الصفحة رقم 2

Installation and Operation The SW6 VGA Audio is a 6 input - 1 output audio/video switcher housed in a rack mountable, 1U high, full Using the Captive Screw Audio Connectors width metal enclosure with internal, universal 100-240 VAC 50/60 Hz power supply. The switcher front and The SW6 VGA Audio switcher has a single row of 3.5 mm audio receptacles along the bottom right side of the rear panels are shown in Figure 1-A followed by descriptions of controls and connectors. rear panel (see items I &

ملخص المحتوى في الصفحة رقم 3

RS-232 Command/Response Table Audio Level RS-232 COMMAND/RESPONSE TABLE Audio Level Control ASCII to HEX Conversion Table ABBREVIATIONS & DEFINITIONS: The Audio Level Setting (Gain) for each input can be viewed, • = CR/LF, · = SPACE, A = AUDIO, AUTO = AUTOSWITCH, changed and saved in memory using the switcher front panel C = CHANNEL-AUDIO & VIDEO, F = MODE, V = VIDEO, buttons or with RS-232 commands. The setting range is M = MAXIMUM INPUTS, QVER = SOFTWARE VERSION –15 dB to +9 dB. To view or c