Extron electronic sDMP128 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

100-240V ~ --A MAX 1 2 3 4 9 10 1 2 3 4
DMP 128
1 2 3 4 5 G 6 7 8 9 10 G
MIC +48V
1 2 3 4
5 6 7 8 11 12 5 6 7 8 RS-232
RESET
5 6 7 8
50/60 Hz 11 12 13 14 15 G 16 17 18 19 20 G Tx Rx G LAN
EXP
Product Category
DMP 128 • Setup Guide
This guide provides basic instructions for an experienced technician to install
™
the DMP 128 ProDSP Digital Matrix Processor. For additional information
and specifications, see the DMP 128 product page at www.extron.com.
Disconnect Power and Mount the DMP 128
Disco

ملخص المحتوى في الصفحة رقم 2

DMP 128 • Setup Guide (Continued) 3 " (5 mm) MAX. Digital I/O connectors — Connect up to four 6-pole 3.5 mm captive screw connectors. Each 16 f connector provides five configurable digital input or output ports allowing connection of up to Do not tin the wires! twenty devices such as motion detectors, alarms, lights, LEDs, buttons, photo (light) sensors, and 1 temperature sensors. 2 3 Digital I/O ports can monitor or drive TTL level digital signals. The inputs are configured to 4 operat

ملخص المحتوى في الصفحة رقم 3

Product Category DSP Configurator Software Installation There are no hardware controls for the DMP 128. All configuration and control is done using DSP Configurator. Install ® ® DSP Configurator on a PC running Microsoft Windows 2000 or later. For full details about computer requirements, see the DSP 128 User Guide at www.extron.com. To Download the DSP Configurator Software from the Extron website: 1. On the Extron home page, click the Download tab. The Download page opens. 2. Under Softw

ملخص المحتوى في الصفحة رقم 4

Dante Network Audio Setup The following is the recommended procedure for configuring DMP 128 AT models on a Dante network. NOTE: A connection to both the Dante (AT) Ethernet switch and the DMP 128 LAN port is required to follow this setup procedure. If the control computer has only one Ethernet port, connect it to a rear panel AT port (item on page 2). Then j connect a short CAT 5 cable from the LAN port (item ç on page 2) to an unused AT port (item j on page 2). Alternately use an Ethernet