ملخص المحتوى في الصفحة رقم 1
3-860-694-33 (1)
Personal Audio
System
EN
EN
Operating Instructions page 2
ES
ES
Manual de instrucciones página 2
ZS-D7
1998 by Sony Corporation
ملخص المحتوى في الصفحة رقم 2
Notice for customers in the United Warning Kingdom To prevent fire or shock hazard, do A moulded plug complying with BS 1363 is not expose the player to rain or fitted to this equipment for your safety and moisture. convenience. Should the fuse in the plug supplied need to To avoid electrical shock, do not open be replaced, same rating fuse approved by the cabinet. Refer servicing to ASTA or BSI to BS 1362, (i.e. marked with qualified personnel only. or mark) must be used. Information If the p
ملخص المحتوى في الصفحة رقم 3
Basic Operations Table of contents Basic Operations 4 Playing a CD 6 Listening to the radio 8 Playing a tape 10 Recording on a tape CD Player The Timer 13 Using the display 31 Setting the clock EN 14 Locating a specific track 32 Waking up to music 15 Playing tracks repeatedly 35 Falling asleep to music (Repeat Play) 36 Timer-recording radio programs 17 Playing a single track (Single Track Play) Setting Up 18 Playing tracks in random order 39 Choosing the power sources (Shuffle Play) 41 Connectin
ملخص المحتوى في الصفحة رقم 4
Basic Operations Playing a CD 21 Connect the supplied AC power cord (see page 39.) 1 Press 6 OPEN/CLOSE (direct power-on) and place the CD on the CD tray until it clicks into place. With the label side up 2 Press (. Display The CD tray closes and the player plays all the tracks once. Track number Playing time EN 4 Basic Operations
ملخص المحتوى في الصفحة رقم 5
Basic Operations Use these buttons for additional operations OPERATE VOLUME +, – p 6OPEN/CLOSE P Jog dial Tips To Do this • After inserting the CD, ... Adjust the volume Press VOLUME +, – “TOC READING ” appears in the display (VOL +, – on the remote). and the player starts to Stop playback Press p. read the total number of tracks on the CD and Pause playback Press P. the time information on Press again to resume play the CD. after pause. • Next time you want to listen to a CD, just press Go to t
ملخص المحتوى في الصفحة رقم 6
Listening to the radio 1 2 Connect the supplied AC power cord (see page 39.) Display 1 Press BAND until the band you want appears in the display (direct power-on). Indicates an FM 2 Hold down TUNING/SEARCH stereo broadcast. +/) or 0/– (TUNE + or – on the remote) until the frequency ST digits begin to change in the display. The player automatically scans the radio frequencies and stops when it finds a clear station. If you can't tune in a station, press TUNING/SEARCH +/) or 0/– (TUNE + or – on th
ملخص المحتوى في الصفحة رقم 7
Basic Operations Use these buttons for additional operations OPERATE MENU ENTER VOLUME +, – Tips To Press • If the FM broadcast is Adjust the volume VOLUME +,– noisy: (VOL +, – on the remote) On the remote: Press MODE until Turn on/off the radio OPERATE “MONO” appears in the display and the radio will play in monaural. To improve broadcast reception On the player: FM: 1 Press MENU. Reorient the antenna for ST FM. 2 Turn the jog dial until “MONO” flashes in the display and press ENTER. The radio
ملخص المحتوى في الصفحة رقم 8
Playing a tape 1,2 3 Connect the supplied AC power cord (see page 39.) 1 Press PUSH OPEN/CLOSE to open the tape compartment and insert a recorded tape. Use TYPE I (normal), TYPE II (high position) and TYPE IV (metal) tapes. With the side you want to play facing you 2 Press PUSH OPEN/CLOSE to close the compartment. Display 3 Press (. (On the remote, press TAPE (.) The player turns on (direct power-on) and starts playing. Tape counter EN 8 Basic Operations
ملخص المحتوى في الصفحة رقم 9
Basic Operations Use these buttons for additional operations OPERATE DIR MODE VOLUME +, – p 9 COUNTER RESET 0, ) PUSH OPEN/CLOSE Tips To Press • Press COUNTER RESET Adjust the volume VOLUME +, – to reset the counter to “000.” (VOL +, – on the remote) • Next time you want to Stop playback p listen to a tape, just press ( or 9 . The Play the reverse side 9 player turns on Fast-forward or rewind ) or 0 automatically and starts the tape playing the tape. Eject the cassette PUSH OPEN/CLOSE Turn on/of
ملخص المحتوى في الصفحة رقم 10
Recording on a tape 1 3 3 Connect the supplied AC power cord (see page 39.) To record on a MiniDisc or DAT recorder, connect the components (see pages 41 and 45.) 1 Press PUSH OPEN/CLOSE to open the tape compartment, and insert a blank tape. Use TYPE I (normal) tape only. Press PUSH OPEN/CLOSE again to close the compartment. With the side you want to record on facing you 2 Select the program source you want to record. Display To record from the CD player, insert a CD (see page 4) and press p on
ملخص المحتوى في الصفحة رقم 11
Basic Operations 3 Start recording. To record the whole CD REC Press DUB START CD m TAPE. When is displayed: If the tape is reversed with the recording of the track unfinished, the player will record the track again from its beginning on the reverse side. To record the radio ST REC (You can also record the CD according to the following . procedure. Play the CD after the tape starts recording.) ST REC Press r/P and then (. To record on the reverse side, press 9. (On the remote, while keeping r/P
ملخص المحتوى في الصفحة رقم 12
Recording on a tape (continued) Tips Use these buttons for additional operations • Adjusting the volume or the audio emphasis (see r/P p MENU ENTER page 48) will not affect OPERATE the recording level. • When is displayed, recording will be made on both sides of the tape. To record on one side, press DIR MODE to display . • If the MW/LW radio makes a whistling sound after you’ve pressed r/P in step 3, press MODE on the remote repeatedly to select the position that most decreases the noise. On
ملخص المحتوى في الصفحة رقم 13
The CD Player The CD Player Using the display DISPLAY You can check information about the CD using the display. Checking the total track number and playing time Press DISPLAY in stop mode. Total track Total playing number time Checking the remaining time Press DISPLAY while playing a CD. To display Press DISPLAY The current track number Once and the remaining time on the current track* Remaining time on the CD Twice and the number of tracks left The current track number Three times and playing t
ملخص المحتوى في الصفحة رقم 14
Locating a specific track You can quickly locate any track using the number buttons. You can also find a Number specific point in a track while playing a buttons CD. î =, + Note To locate Press You cannot locate a a specific track directly number button of the specific track if track. “SHUFFLE”, “REP SHUF” or a point while listening to = or + while playing “PROGRAM”* is lit in the sound and hold down until you the display. Turn off find the point. the indication by (On the player, use pressing
ملخص المحتوى في الصفحة رقم 15
The CD Player Playing tracks repeatedly (Repeat Play) Number You can play tracks repeatedly in buttons normal, shuffle or program play modes (see pages 17 - 19). MODE î p ( Note 1 Press p. When you repeat a “CD” appears in the display. single track or all the tracks, make sure 2 Proceed as follows. neither “SHUFFLE”, “REP SHUF”, To repeat Do this “PROGRAM”* nor a single track 1 Press MODE until “REP PGM”* is lit in “REPEAT 1” appears. the display. 2 Press the number buttons to select the track t
ملخص المحتوى في الصفحة رقم 16
Playing tracks repeatedly (Repeat Play) (continued) On the player To cancel Repeat Play 1 Press p on the CD Press MODE until “REPEAT” or “REP” disappears section. from the display. 2 Press MENU. 3 Turn the jog dial until “MODE” flashes in the display and press ENTER. 4 Turn the jog dial until the repeat function you want appears in the display and press ENTER. 5 Press ( on the CD section. EN 16 The CD Player
ملخص المحتوى في الصفحة رقم 17
The CD Player Playing a single track (Single Track Play) Number You can play a single track once, and buttons stop the player automatically. î MODE p On the player 1 Press p. 1 Press p on the CD “CD” appears in the display. section. 2 Press MENU. 2 Press MODE until “1 TRACK” appears in the 3 Turn the jog dial display. until “MODE” flashes in the display and press ENTER. 4 Turn the jog dial until “1 TRACK” 3 Press the number buttons to select the track you flashes in the display want to play. and
ملخص المحتوى في الصفحة رقم 18
Playing tracks in random order (Shuffle Play) You can play tracks in random order. î MODE p ( On the player 1 Press p. 1 Press p on the CD section. “CD” appears in the display. 2 Press MENU. 2 Press MODE until “SHUFFLE” appears in the 3 Turn the jog dial until display. “MODE” flashes in the display and press ENTER. 4 Turn the jog dial until 3 Press ( to start shuffle play. “SHUFFLE” flashes in the display and press ENTER. 5 Press ( on the CD To cancel Shuffle Play section. Press MODE until “SHUF
ملخص المحتوى في الصفحة رقم 19
The CD Player Creating your MENU ENTER p own program Jog dial ( (Program Play) You can arrange the playing order of up p to 20 tracks on a CD. 1 Press ( to start play. 2 Press MENU. 3 Turn the jog dial until “PROGRAM SET” appears in the display and press ENTER. Tips 4 Turn the jog dial (press the number buttons on the • If you made a mistake, remote) to select the track you want to program, press CANCEL and re- and press ENTER. enter the track number Track number by turning the jog dial and pres
ملخص المحتوى في الصفحة رقم 20
Creating your own program (Program Play) (continued) Tips To cancel Program Play • If the program play is Press MODE on the remote until “PROGRAM” finished, the program is disappears from the display. saved. You can play the same program again by pressing (. To check the order of tracks before play • If you open the CD As you turn the jog dial in stop mode, the track tray, the program is erased. number appears in the programmed order. • You can record your own program. Press DUB START CD To cha
