Sanyo LNS-S02Z دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

LCD PROJECTOR LENS
MODEL NO. LNS-S02Z
LENS REPLACEMENT
AND INSTALLATION PROCEDURES
NOTES ON REPLACEMENT AND INSTALLATION
The procedures and the needed pars for lens installation depend on the type of
cabinet. Before installing or replacing the lens, make sure the type of cabinet and be
sure to refer to the Installation Manual corresponding with your projector.
When installing or replacing the lens, make sure the Lens Model No. matches with
your projector. Refer to the catalog, or contact your

ملخص المحتوى في الصفحة رقم 2

NOTES ON LENS INSTALLATION • Lens installation and replacement should be made by the qualified service personnel. • Be sure to install the lens following this procedure precisely. • The lens cover is on the lens for protection. Be sure to replace the lens cover before installation. • When installing or replacing the lens, be careful not to stain, scratch or damage the lens. LIST OF CONTENTS Following parts are included in the packing. • LENS 1 pc. • LENS MOUNTING SCREWS 2 pcs. (for spare) • DRI

ملخص المحتوى في الصفحة رقم 3

LENS REPLACEMENT AND INSTALLATION PROCEDURE Perform the steps 1 to 5 for lens replacement and installation. UPPER LENS COVER C REMOVE THE LENS COVER. (See figure-1) 1 1. Remove screws A (2 screws). 2. Pull down the lower lens cover while pushing the part D, then remove it. 3. Remove screws B (2 screws). B 4. Remove screws C (2 screws) and remove upper lens cover. D D Fig-1 A LOWER LENS COVER REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-2) 2 Remove 2 screws and pull down the plate. 4 (A

ملخص المحتوى في الصفحة رقم 4

❋ Figure shown inside of the cabinet. LENS MOTOR (D) (D) (D) (D) B A WIRE HOLDER LENS MOTOR LEAD CONNECTOR “ K16B” Fig-4 INSTALL THE LIGHT-BLOCK SHEET. (See figure-5) 4 Install the light-block sheet around the lens as Set the light-block sheet, so that the shown in the illustration. large rounder side is set over the lens. (Use the sheet included with the lens.) Set the light-block sheet, so that the large rounder side is set over the lens. Fig-5 LIGHT-BLOCK SHEET MOUNT THE LENS COVER. (See fig