ملخص المحتوى في الصفحة رقم 1
RX-V2700
RX-V2700_U-cv.fm Page 1 Thursday, August 24, 2006 3:36 PM
U
RX-V2700
AV Receiver
© 2006 All rights reserved.
YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A.
YAMAHA CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA
YAMAHA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR. 22-34, 25462 RELLINGEN BEI HAMBURG, GERMANY
YAMAHA ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 7
ملخص المحتوى في الصفحة رقم 2
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS 10 Ventilation – Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the CAUTION product and to protect it from overheating, and these RISK OF ELECTRIC SHOCK openings must not be blocked or covered. The openings DO NOT OPEN should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should not be placed in a built-in installation such as
ملخص المحتوى في الصفحة رقم 3
IMPORTANT SAFETY INSTRUCTIONS d) If the product does not operate normally by following 24 Outdoor Antenna Grounding – If an outside antenna or the operating instructions. Adjust only those controls cable system is connected to the product, be sure the antenna that are covered by the operating instructions as an or cable system is grounded so as to provide some improper adjustment of other controls may result in protection against voltage surges and built-up static charges. damage and will of
ملخص المحتوى في الصفحة رقم 4
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. 1 To assure the finest performance, please read this manual 16 Install this unit near the AC outlet and where the AC power carefully. Keep it in a safe place for future reference. plug can be reached easily. 2 Install this sound system in a well ventilated, cool, dry, clean 17 Be sure to read the “TROUBLESHOOTING” section on place – away from direct sunlight, heat sources, vibration, common operating
ملخص المحتوى في الصفحة رقم 5
TRADEMARK NOTICES Note on Source Code Distribution This product includes software code subject to the GNU General Public License (GPL) or the GNU Lesser General Public License Manufactured under license from Dolby Laboratories. (LGPL). The copy, distribution, or change of this software code is “Dolby”, “Pro Logic”, and the double-D symbol are trademarks licensed under the terms of the GPL or the LGPL. The source of Dolby Laboratories. code is available at the following website: http://www.gl
ملخص المحتوى في الصفحة رقم 6
CONTENTS USING AUDIO FEATURES............................... 52 INTRODUCTION Enjoying pure hi-fi sound........................................ 52 Adjusting the tonal quality ...................................... 52 FEATURES .............................................................4 Adjusting the speaker level...................................... 53 GETTING STARTED............................................5 Enjoying multi-channel sources Supplied accessories..............................
ملخص المحتوى في الصفحة رقم 7
BASIC ADDITIONAL ADVANCED OPERATION INFORMATION APPENDIX INTRODUCTION PREPARATION OPERATION CONTENTS REMOTE CONTROL FEATURES................. 118 Controlling this unit, a TV, or other components .......................................... 118 Setting remote control codes ................................. 120 Programming codes from other remote controls ... 122 Changing source names in the display window..... 123 Macro programming features ................................ 124 Clearing configura
ملخص المحتوى في الصفحة رقم 8
FEATURES FEATURES Built-in 7-channel power amplifier Network features ◆ Minimum RMS output power ◆ NETWORK port to connect a PC and YAMAHA MCX-2000 (20 Hz to 20 kHz, 0.04% THD, 8 Ω) or access the Internet Radio via a LAN Front: 140 W + 140 W ◆ DHCP automatic or manual network configuration Center: 140 W USB features Surround: 140 W + 140 W ◆ USB port to connect a USB memory device or a USB portable Surround back: 140 W + 140 W audio player Sound field programs Other features ◆ Proprietary YAMA
ملخص المحتوى في الصفحة رقم 9
INTRODUCTION GETTING STARTED GETTING STARTED Supplied accessories Check that you received all of the following parts. Remote control POWER POWER STANDBY POWER TV AV Zone 2/Zone 3 Batteries (6) NET/USB AUDIO SEL SLEEP remote control (AAA, LR03) PHONO TUNER CD MULTI CH IN V-AUX/DOCK CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR 2 DVD POWER TUNER CD CD-R STANDBY SELECT DTV CBL/SAT NET/USB AMP + + + VCR 1 V-AUX/DOCK DVR/VCR 2 DVD SOURCE TV VOL CH VOLUME TV – – – TV MUTE TV INPUT MUTE PRESET VOLUME PRESET
ملخص المحتوى في الصفحة رقم 10
CONTROLS AND FUNCTIONS CONTROLS AND FUNCTIONS Front panel This section describes only the amplifier controls and functions of this unit. See the following pages for details about other control and functions. AM/FM tuning .......................................... see page 56 XM satellite radio tuning .......................... see page 64 1 2 3 456 7 8 9 0 ABC PURE DIRECT VOLUME AUDIO TONE REC OUT/ PRESET/ MEMORY TUNING SELECT CONTROL ZONE2 A/B/C/D/E PRESET/TUNING TUNING FM/AM MAN'L/AUTO FM
ملخص المحتوى في الصفحة رقم 11
INTRODUCTION CONTROLS AND FUNCTIONS 8 MULTI ZONE buttons D PROGRAM selector Selects sound field programs (see page 46). ZONE 2 ON/OFF Adjusts the bass/treble balance in conjunction with Turns on Zone 2 only or sets it to the standby mode TONE CONTROL (see page 52). (see page 131). E OPTIMIZER MIC jack ZONE 3 ON/OFF Use to connect and input audio signals from the supplied Turns on Zone 3 only or sets it to the standby mode optimizer microphone in the “Auto Setup” procedure (see (see page
ملخص المحتوى في الصفحة رقم 12
CONTROLS AND FUNCTIONS Remote control ■ Remote control controls and functions This section describes only the amplifier controls and functions of this unit. See the following pages for details about other control and functions. AM/FM tuning .......................................... see page 56 Note XM satellite radio tuning .......................... see page 64 The operation mode of the remote control buttons in the shaded Controlling a TV ..................................... see page
ملخص المحتوى في الصفحة رقم 13
INTRODUCTION CONTROLS AND FUNCTIONS NET RADIO SOURCE Selects the Internet radio as the sub input source of Operates the component selected with an input NET/USB. selector button (see page 119). USB TV Selects a USB memory device or a USB portable Operates the TV assigned to either DTV or PHONO audio player as the sub input source of NET/USB. (see page 118). Notes Notes Press NET/USB to select “NET/USB” as the input source To set the remote control codes for other components, see before yo
ملخص المحتوى في الصفحة رقم 14
CONTROLS AND FUNCTIONS Zone 2/Zone 3 remote control This section describes the function of each control on the 1 Input selector buttons Zone 2/Zone 3 remote control used to control the amplifier Select the desired input source of Zone 2 or Zone 3. functions of Zone 2 or Zone 3. 2 ID1/ID2 switch See the following pages for details about other controls Switches the remote control ID between ID1 and ID2 and functions. (see page 121). AM/FM tuning ........................................ see pa
ملخص المحتوى في الصفحة رقم 15
INTRODUCTION CONTROLS AND FUNCTIONS Preparing the remote control ■ Installing batteries in the remote control Notes Change all of the batteries if you notice the following conditions: – the operation range of the remote control decreases. – the TRANSMIT indicator does not flash or its light becomes 2 dim. Do not use old batteries together with new ones. 1 Do not use different types of batteries (such as alkaline and 3 manganese batteries) together. Read the packaging carefully as these
ملخص المحتوى في الصفحة رقم 16
XM CONTROLS AND FUNCTIONS Front panel display Note The XM indicator is only applicable to the U.S.A. and Canada models and the cursor on the left of the XM indicator lights up only when “XM” is selected as the input source. For details, see “Basic XM Satellite Radio operations” on page 67. 1 2 3 4 5 6 7 RECOUT V-AUX DVR/VCR 2 VCR 1 CBL/SAT DTV DVD NET/USB DOCK neural TUNED STEREO AUTO MEMORY VIRTUALHiFi DSP dB PS YPAO ENHANCER SILENT VOLUME ZONE2 PTY MUTE CINEMA DIGITAL DSD ZONE3 RT 96/24 PL
ملخص المحتوى في الصفحة رقم 17
INTRODUCTION CONTROLS AND FUNCTIONS A neural indicator I Headphones indicator (U.S.A. and Canada models only) Lights up when headphones are connected (see page 43). Lights up when the Neural Surround decoder is activated J SILENT CINEMA indicator (see page 85). Lights up when headphones are connected and a sound B DSP indicators field program is selected (see page 51). The respective indicator lights up when any of the DSP K DTS decoder indicators sound field programs are selected. The respec
ملخص المحتوى في الصفحة رقم 18
COMPONENT VIDEO PB CONTROLS AND FUNCTIONS Rear panel 1 2 3 4 5 6 7 VIDEO ANTENNA MONITOR OUT DVD CBL/SAT DVD DTV CBL/SAT IN VCR 1 OUT IN DVR/VCR 2 OUT MONITOR OUT A B DTV C AC IN FM GND AM Y Y S VIDEO PB VIDEO SPEAKERS IN OUT SP1 (PLAY) (REC) + PRESENCE + R L WRENCH HDMI MD/ PR PR HOLDER L TAPE IN3 IN OUT IN OUT REMOTE 1 2 R CBL/ SURROUND BACK/ CENTER SAT + BI-AMP + + SINGLE CENTER FRONT(6CH) SURROUND CENTER FRONT SURROUND SINGLE(SB) ZONE 2 ZONE 3 ZONE GND PHONO CD CD-R VIDEO IN2 L AC OUTLETS DT
ملخص المحتوى في الصفحة رقم 19
PRE PREP PARA ARA TION TION CONNECTIONS CONNECTIONS Placing speakers The speaker layout below shows the speaker setting we Front left and right speakers (FL and FR) recommend. You can use it to enjoy CINEMA DSP and The front speakers are used for the main source sound plus multi-channel audio sources. effect sounds. Place these speakers at an equal distance from the ideal listening position. The distance of each speaker from each side of the video monitor should be the same. PL PR C FL FR Ce
ملخص المحتوى في الصفحة رقم 20
CONNECTIONS Connecting speakers Be sure to connect the left channel (L), right channel (R), “+” (red) and “–” (black) properly. If the connections are faulty, no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass. CAUTION Before connecting the speakers, make sure that this unit is turned off (see page 34). Do not let the bare speaker wires touch each other or do not let them touch any metal part of t
