ملخص المحتوى في الصفحة رقم 1
RX-V10
Natural Sound Stereo Receiver
Récepteur stéréo “Son Naturel”
OWNER’S MANUAL MODE D’EMPLOI
Thank you for selecting this YAMAHA stereo Nous vous remercions pour avoir porté votre
receiver. choix sur ce récepteur stéréo YAMAHA.
CONTENTS TABLES DES MATIERES
Safety Instructions ...............Inside the Front Cover Caractéristiques ............................................37
Caution ............................................................2 Accessoires fournis ...........................
ملخص المحتوى في الصفحة رقم 2
SAFETY INSTRUCTIONS 7 Wall or Ceiling Mounting – The unit should be mounted to a wall or ceiling only as recommended by the manufacturer. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN 8 Ventilation – The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, the unit should not be situated CAUTION: TO REDUCE THE RISK OF on a bed, sofa, rug, or similar surface, that may block the ELECTRIC SHOCK, DO NOT REMOVE ventilation openings; or p
ملخص المحتوى في الصفحة رقم 3
English 19 For US customers only: EXAMPLE OF ANTENNA GROUNDING Outdoor Antenna Grounding – If an outside antenna is connected to this unit, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides ANTENNA MAST LEAD IN information with regard to proper grounding of the mast WIRE and supporting structure, grounding of the lead-in wire to GROUND an antenna discharg
ملخص المحتوى في الصفحة رقم 4
CAUTION : READ THIS BEFORE OPERATING YOUR UNIT. 1. To assure the finest performance, please read this manual IMPORTANT carefully. Keep it in a safe place for future reference. Please record the serial number of this unit in the space below. 2. Install this unit in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, Serial No.: dust, moisture and cold. Avoid sources of humming (transformers, motors). To prevent fire or electrical shock, The serial number
ملخص المحتوى في الصفحة رقم 5
English SUPPLIED ACCESSORIES After unpacking, check that the following parts are included. AM Loop Antenna Remote Control Transmitter DELAY/REAR –+ LEVEL /CENTER TEST EFFECT ON/OFF PROGRAM PROLOGIC ENHANCED DVD/LD VCR 2CH/5CH DIR A DIR B REC/PAUSE PLAY TAPE A/B –+ PRESET A/B/C/D/E TUNER PLAY DISC CD PHONO POWER VOLUME SLEEP Indoor FM Antenna Batteries (size AA, R6, UM-3) 3
ملخص المحتوى في الصفحة رقم 6
FEATURES l l 40-Station Random Access Preset Tuning 5 Speaker Configuration Front: 45W + 45W (8Ω) RMS Output l Automatic Preset Tuning Power, 0.04% THD, 20–20,000 Hz Center: 45W (8Ω) RMS Output Power, l Preset Station Shifting Capability (Preset 0.1% THD, 1 kHz Editing) Rear: 15W (8Ω) RMS Output Power, 0.7% THD, 1 kHz l IF Count Direct PLL Synthesizer Tuning System l Digital Sound Field Processor 4 Programs for Digital Sound Field l Video Signal Input/Output Capability Processing l 5-Channel Dis
ملخص المحتوى في الصفحة رقم 7
English PROFILE OF THIS UNIT You are the proud owner of a Yamaha stereo receiver –an extremely sophisticated audio component. The Digital Sound Field Processor (DSP) built into this unit takes advantage of Yamaha’s undisputed leadership in the field of digital audio processing to bring you a whole new world of listening experiences. Follow the instructions in this manual carefully when setting up your system, and this unit will sonically transform your room into a wide range of listening enviro
ملخص المحتوى في الصفحة رقم 8
SPEAKER SETUP SPEAKERS TO BE USED This unit is designed to provide the best sound-field quality with a 5 speaker configuration. The most effective speakers to use with this unit are front speakers, rear speakers and a center speaker. You may omit the center speaker. (Refer to the “4-Speaker Configuration” shown below.) The front speakers are used for the main source sound plus the effect sounds. They will probably be the speakers from your present stereo system. The rear speakers are used f
ملخص المحتوى في الصفحة رقم 9
English CONNECTIONS Before attempting to make any connections to or from this unit, be sure to first switch OFF the power to this unit and to any other components to which connections are being made. CONNECTIONS WITH OTHER COMPONENTS When making connections between this unit and other components, be sure all connections are made correctly, that is to say L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. Also, refer to the owner’s manual for each component to be connected to this unit. *
ملخص المحتوى في الصفحة رقم 10
Connecting with a Dolby Digital (AC-3) Decoder If you have a Dolby Digital (AC-3) Decoder unit or an LD player etc. which incorporates a Dolby Digital (AC-3) Decoder, its discrete outputs can be connected to this unit. OUTPUT Dolby Digital (AC-3) Decoder unit MAIN CENTER SURROUND SUBWOOFER AC-3 RF IN 1 CD FM ANT CENTER 75Ω 3 UNBAL. TAPE PB MONITOR TAPE OUT SURROUND MAIN GND GND 4 DVD/LD 5CH DISCRT INPUT REC OUT AM ANT IN IN VCR VCR OUT OUT DVD DVD /LD /LD AC-3 RF PHONO VIDEO AUDIO SIGNAL SPEAKER
ملخص المحتوى في الصفحة رقم 11
English CONNECTING SPEAKERS Note Note on a subwoofer connection: Use speakers with the specified impedance shown on the rear You may wish to add a subwoofer to reinforce the bass of this unit. frequencies. Connect the SUBWOOFER OUT terminal of this unit to the Note on front speaker connections: INPUT terminal of the subwoofer amplifier, and connect the One or two speaker systems can be connected to this unit. If speaker terminals of the subwoofer amplifier to the subwoofer. you use only one spe
ملخص المحتوى في الصفحة رقم 12
How to Connect: Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and – markings are observed. If these wires are reversed, the sound will be unnatural and lack bass. Caution Do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. This could da
ملخص المحتوى في الصفحة رقم 13
English ANTENNA CONNECTIONS l Each antenna should be connected to the designated terminals correctly, referring to the following diagram. l Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal strength. Nevertheless, a properly installed outdoor antenna will give clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may result in improvement. Outdoor AM antenna Outdoor FM ante
ملخص المحتوى في الصفحة رقم 14
CONTROLS AND THEIR FUNCTIONS FRONT PANEL 123 4 56 INPUT VOLUME DVD-LD/VCR/TAPE/CD/TUNER/PHONO NATURAL SOUND STEREO RECEIVER RX–V10 5CH/2CH POWER PTY SELECTOR 0I0 PRESET STATIONS TUNING PHONES SPEAKERS RDS MODE/FREQ EON A/B/C/D/E KEY MODE BASS TREBLE BALANCE 0 0 B EDIT ON OFF TUNING CENTER PTY SEEK FM/AM MODE MEMORY MODE PROGRAM A –+ –+ LR MODE START AUTO/MAN’L MONO MAN’L/AUTO FM 79 8 =ABCDEFGHIJK L M Parts in the shaded areas are provided for Europe and U.K. models only. The power indicator (2)
ملخص المحتوى في الصفحة رقم 15
English 0 RDS MODE/FREQ button H PRESET STATIONS/TUNING button Functions as the PRESET STATIONS button when “PRESET” When an RDS station is received, pressing this button changes is illuminated on the display, and functions as the TUNING the display mode into the PS mode, PTY mode and/or RT button when “PRESET” is not illuminated on the display. mode (if the station employs those RDS data services), and frequency display in turn. PRESET STATIONS: Selects a preset st
ملخص المحتوى في الصفحة رقم 16
REMOTE CONTROL TRANSMITTER The remote control transmitter provided with this unit is designed to control all the most commonly used functions of this unit. If the CD player and tape deck connected to this unit are YAMAHA components designed for remote control compatibility, then this remote control transmitter will also control various functions of each component. For Control of This Unit 1 DELAY/REAR/CENTER and LEVEL +/– keys 9 Adjust the delay time (DELAY), the rear channel output level (REAR)
ملخص المحتوى في الصفحة رقم 17
English 30° For Other Component Control Identify the remote control transmitter keys with your component’s keys. If these keys are identical, their functions will be the same. On each key function, refer to the corresponding instruction on your component’s manual. 1 Tape deck keys Controls tape deck. * DIR A, B and A/B are applicable only to double cassette tape deck. * For a single cassette deck with automatic reverse function, pressing DIR A will reverse the direction of tape running. 2 CD
ملخص المحتوى في الصفحة رقم 18
DISPLAY PANEL 1234 56 MEMO PRESET ST AUTO PTY H PTY FM MHz 0 l00 PS RT EON INFO SPORT PRO LOGIC CONCERT MONO ROCK CONCERT NORMAL WIDE TEST SLEEP NEWS AFFAIRS ENHANCED VIDEO MOVIE CONCERT HALL PHANTOM 789 The name(s) of RDS mode(s) employed by the currently 2 MEMO indicator received RDS
ملخص المحتوى في الصفحة رقم 19
English SPEAKER BALANCE ADJUSTMENT This procedure lets you adjust the sound output level balance between the front, center, and rear speakers using the built-in test tone generator. When this adjustment is performed, the sound output level heard at the listening position will be the same from each speaker. This is important for the best performance of the digital sound field processor. The adjustment of each speaker output level should be done at your listening position with the remote control
ملخص المحتوى في الصفحة رقم 20
DELAY/REAR –+ LEVEL /CENTER TEST EFFECT 7 ON/OFF PROGRAM PROLOGIC ENHANCED DVD/LD VCR 2CH/5CH PLAY DIR A DIR B REC/PAUSE TAPE A/B A/B/C/D/E TUNER –+ PRESET DISC PLAY CD PHONO POWER VOLUME SLEEP 6 9 8 6 Select the center channel output mode suitable for your 8 Turn up the volume. speaker configuration. (Refer to “SPEAKER CONFIGURATION” on page 6.) VOLUME CENTER MODE NORMAL WIDE PHANTOM You will hear a test tone (like pink noise) from the left front speaker, then the center speaker, then the right
