ملخص المحتوى في الصفحة رقم 1
AUDIO / VIDEO CONTROL RECEIVER
RX-D211S / RX-D212B
For Customer Use:
Enter below the Model No. and Serial
No. which are located either on the rear,
INSTRUCTIONS
bottom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
LVT1557-001A
[J]
ملخص المحتوى في الصفحة رقم 2
Warnings, Cautions, and Others Mises en garde, précautions et indications diverses CAUTION CAUTION Changes or modifications not approved by JVC could void the RISK OF ELECTRIC SHOCK user’s authority to operate the equipment. DO NOT OPEN ATTENTION CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, Des changements ou modifications non approuvés par JVC DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. pourront invalider l’autorité
ملخص المحتوى في الصفحة رقم 3
Table of Contents Parts identification ................................................ 2 Getting started ...................................................... 4 Before Installation .................................................................. 4 Checking the supplied accessories ....................................... 4 Putting batteries in the remote control ................................... 4 Connecting antennas ............................................................. 5 Connecting
ملخص المحتوى في الصفحة رقم 4
Remote control See pages in parentheses for details. Parts identification 1 MUTING button (14) 2 Standby/on buttons (12, 37 – 41) AUDIO, DVR/DVD , VCR , DBS/CATV , TV/SIRIUS 3 Source selecting buttons (12, 16, 17, 34, 37 – 41) DVR/DVD, VCR, DBS, TV, USB, XM, FM/AM, SIRIUS 4 TV VOL (volume) +/– button (37, 39) 5 CHANNEL +/– button (37 – 41) 6 • Operating buttons for video components (37, 38, 40, 41) 4, 3, ¢, 1, 7, 8, ¡ • Operating buttons for FM/AM tuner (15) ( TUNING, TUNING 9 A/V CONTROL RECEI
ملخص المحتوى في الصفحة رقم 5
See pages in parentheses for details. Front panel 1 2 3 45 6 7 89 SOURCE MASTER SELECTOR VOLUME AUDIO/VIDEO CONTROL RECEIVER / MULTI JOG DVR / DVD VCR DBS TV/SIRIUS USB XM FM AM STANDBY/ON DIMMER SETTING ADJUST SURROUND SET / TUNER PRESET PHONES USB p q w e 1 STANDBY/ON button and standby lamp (12) 8 • SOURCE SELECTOR (12, 16, 17) 2 DIMMER button (14) • MULTI JOG (16, 19, 20, 22, 26, 34) 3 SETTING button (20, 22) 9 MASTER VOLUME control (13) 4 ADJUST button (26) p PHONES jack (13) 5 SURROUND
ملخص المحتوى في الصفحة رقم 6
Putting batteries in the remote control Getting started Before using the remote control, put two supplied batteries first. 12 3 1 Press and slide the battery cover on the back Before Installation of the remote control. 2 Insert batteries. General precautions Make sure to match the polarity: (+) to (+) and (–) to (–). • Be sure your hands are dry. • Turn the power off to all components. 3 Replace the cover. • Read the manuals supplied with the components you are going to connect. If the range or
ملخص المحتوى في الصفحة رقم 7
Connecting antennas Do not connect the AC power plug to the wall outlet until all connections are completed. 7 Connecting FM and AM antennas AM loop antenna (supplied) If FM reception is poor, connect an outdoor FM antenna (not supplied). Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna. AM LOOP ANTENNA FM antenna (supplied) If AM reception is poor, connect FM 75 an outdoor single vinyl-covered COAXIAL AM EXT wire (not supplied). NOTES AM antenna connection •
ملخص المحتوى في الصفحة رقم 8
Connecting the speakers Do not connect the AC power plug to the wall outlet until all connections are completed. Speaker Layout Diagram SW C R L Center speaker (C) SURROUND BACK SURROUND CENTER FRONT SPEAKERS SPEAKERS SPEAKER SPEAKERS RIGHT LEFT RIGHT LEFT RIGHT LEFT RS LS SUBWOOFER OUT SBR SBL (*SB) CAUTION:SPEAKER IMPEDANCE 6 -16 Left front Right surround Left speaker back speaker surround (L) (SBR) speaker (LS) Powered subwoofer Right front *Left surround Right (SW) speaker back speaker su
ملخص المحتوى في الصفحة رقم 9
Connecting audio/video components Do not connect the AC power plug to the wall outlet until all connections are completed. This receiver is equipped with the following video terminals— Turn off all components before making connections. composite video, S-video, and component video terminals. • When you connect other components, refer also to their • If your video components have S-video (Y/C-separation) and/or manuals. component video (Y, PB, PR) jacks, connect them using an S- video cable (not
ملخص المحتوى في الصفحة رقم 10
Do not connect the AC power plug to the wall outlet until all connections are completed. 7 Connecting a VCR Turn off all components before making connections. • When you connect other components, refer also to their manuals. COMPONENT VIDEO Green Component video cable (not supplied) Y Blue Å PB Red PR VCR(DBS) DVR/DVD MONITOR IN IN OUT VCR AUDIO ıÎ Ç ‰ÏÌ VCR OUT(REC) IN(PLAY) White Red VCR OUT(REC) IN(PLAY) Stereo audio cable Red (not supplied) White Composite video cable (not supplied) S-video
ملخص المحتوى في الصفحة رقم 11
Do not connect the AC power plug to the wall outlet until all connections are completed. 7 Connecting a TV Turn off all components before making connections. Connect the TV to the appropriate MONITOR OUT jacks to • When you connect other components, refer also to their manuals. view the playback picture from any other connected video components. COMPONENT VIDEO Green Y Blue Component video cable (not supplied) PB Red PR VCR(DBS) DVR/DVD MONITOR IN IN OUT Å TV TV/SIRIUS DB IN IN White L Red Stere
ملخص المحتوى في الصفحة رقم 12
NOTES About video signal conversion • When shipped from the factory, the DIGITAL IN terminals have This receiver can convert video signals. See the table below about been set for use with the following components: video signal conversion. – 1(DVR/DVD): For DVD recorder or DVD player Video Input Converted Video Output – 2(DBS): For DBS tuner – 3(VCR): For VCR Component Component If you connect other components, change the digital input (DIGITAL IN) terminal s
ملخص المحتوى في الصفحة رقم 13
2. Check if the drivers are correctly installed. USB connection 1. Open the Control Panel on your PC: Select [Start] = [Control Panel]. This receiver is equipped with a USB terminal. You can enjoy 2. Select [System] = [Hardware] = [Device Manager] = sound reproduced through your PC. [Sound, video and game controllers] and [Universal Serial When you connect your PC for the first time, follow the procedure Bus controllers]. below. • The following window appears, and you can check whether • Remembe
ملخص المحتوى في الصفحة رقم 14
2 Select the source to play Basic operations On the front panel: Turn SOURCE SELECTOR until the source name you want appears on the display. The source lamp corresponding to the selected source lights in red. • As you turn SOURCE SELECTOR, the source changes as follows: ANALOG AUTO SURR TUNED STEREO AUTO MUTING L R S.WFR MHz 3 1 2 2 DVR/DVD VCR DBS 1 USB XM TV (SIRIUS* ) (Back to the beginning) FM AM Source lamps 2 DVR/DVD* : Select this for the DVD recorder or DVD player. 2 VCR* : Select this
ملخص المحتوى في الصفحة رقم 15
From the remote control ONLY: 3 Adjust the volume Press ANALOG/DIGITAL to select the analog or digital input mode. To increase the volume, turn MASTER VOLUME • Each time you press the button, the input mode changes as control clockwise (or press VOLUME + on the follows: remote control). AUTO SURR DIGITAL AUTO L CR To decrease the volume, turn MASTER VOLUME S.WFR LFE DIGITAL LS RS control counterclockwise (or press VOLUME – on the remote control). • When you adjust the volume, the volume level in
ملخص المحتوى في الصفحة رقم 16
Basic adjustment of auto memory Turning off the sounds temporarily This receiver memorizes sound settings for each source: • when you turn off the power, and From the remote control ONLY: • when you change the source. Press MUTING to turn off the sound through all When you change the source, the memorized settings for the connected speakers and headphones. newly selected source are automatically recalled. “MUTING” appears on the display and the volume turns off. The following can be stored for e
ملخص المحتوى في الصفحة رقم 17
Tuning in to FM/AM stations manually FM/AM tuner From the remote control ONLY: operations 1 Press FM/AM to select the band. The last received station of the selected band is tuned in. • Each time you press the button, the band alternates between “FM” and “AM.” ANALOG TUNED STEREO AUTO MUTING L R S.WFR MHz FM/AM tuner operations are mainly done from the remote control. 2 Press repeatedly or hold TUNING 9 or ( TUNING until the station you want is tuned in. • Pressing (or holding) TUNING 9 increase
ملخص المحتوى في الصفحة رقم 18
3 Press the numeric buttons (0 – 9, h10) to On the front panel: select a channel number while the channel 2 1,3 number position is flashing. • For channel number 5, press 5. • For channel number 10, press h10, 1, then 0. • For channel number 15, press h10, 1, then 5. ANALOG TUNED STEREO AUTO MUTING Before you start, remember... L R S.WFR There is a time limit in doing the following steps. If the setting is MHz canceled before you finish, start from step 2 again. 1 Turn SOURCE SELECTOR to select
ملخص المحتوى في الصفحة رقم 19
Preparation XM Satellite Radio To listening to XM Satellite Radio, you need the following: – The XM Connect and Play Digital Antenna (not supplied)* operations – Subscription to XM Satellite Radio**. * To connect the XM Connect and Play Digital Antenna with this receiver, see page 5. **The following channels are available without subscription: – Channel 0: This channel is for checking the XM Satellite Radio ID number. – Channel 1: This is “XM Preview” channel. R This is an XM Ready receiver. • B
ملخص المحتوى في الصفحة رقم 20
7 Direct Channel Access Tuning in to channels You can tune in to the desired channel directly by entering the From the remote control ONLY: channel number. 7 Channel Search You can search and tune in to all channels (including non- Before you start, remember... categorized channels). There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again. 1 Press XM to select “XM” as the source. 1 Press XM to select “XM” as the source. 2 Press re
