AMX Endeleo Multi-Format Receiver UDM-RX02 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Quick Start Guide
UDM-RX02 Endeleo Multi-Format Receiver
Configuration
Overview
The UDM-RX02 is configured via the UDM Hub’s WebConsole. Refer to the UDM
Installed at the display device, the UDM-RX02 (FG-UDM-RX02) converts the signal
Hub’s Operation/Reference Guide for details.
received from a UDM Multi-Format Distribution Hub to standard A/V signals (FIG. 1).
Rear Panel Components
All of the connectors and ports are located on the rear panel (FIG. 2):
Composite (Pr) port
UDM HUB port (RJ45

ملخص المحتوى في الصفحة رقم 2

Component Input at Display Device Powering on the UDM-RX02 1. Attach the Component cables (normally green, blue and red) to the Y (green), The UDM-RX02 may be powered by its hub device through a standard CAT5 cable, Pb (blue) and Pr (red) connectors on the UDM-RX02. but it may also be powered through an optional 24 VDC power supply (FG-UDM-PS) 2. Run the other end of the Component cable to the Component connectors (nor- intended to augment power for very long cable runs. mally green, blue an