Quicksilver M60 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Quicksilver Audio M60 Mono Amplifier
Operating Instructions
Thank you for purchasing the Quicksilver Audio M60 Mono Amplifiers. The amplifiers have been engineered to have
a wide bandwidth, low distortion and excellent dynamic range.
Quicksilver believes simplicity provides the best sound and reliability. The AC signal in the M60 travels through only
one input tube, one driver tube, one coupling capacitor, the output tube and the output transformer. With only five
devices in the signal path,

ملخص المحتوى في الصفحة رقم 2

EL34 EL34 EL34 EL34 12BH7 12AX7 OR 12AU7 C 1 4 8 2 AMP SLO-BLO FUSE Standard fuse value must not be exceeded. If a fuse blows, replace and turn amp back on. Visually inspect all 4 output tubes to see if they are all glowing at the same brightness. If one tube is not glowing or is glowing red, that tube is bad. If the output tubes appear to be okay, then the cause of the fuse blowing may be due to poor system grounding, unstable preamp, shorted speaker, etc. Interchanging the amps between ch

ملخص المحتوى في الصفحة رقم 3

Quicksilver Audio M60 Mono Amplifiers SPECIFICATIONS Power Output 60 watts into 4 or 8 ohms Power Bandwidth 15 Hz to 50 KHz Peak Power 100 watts (8 ohm tap, 4 ohm load) Peak Current 10 amperes Input Sensitivity 1.25 volts Power Consumption 160 watts at idle 280 watts at full power Dimensions 15“ long x 9 3/4” wide x 5 1/2” high Finish Carbide black chassis Polished nickel transformer covers Weight 32 lbs., 36 lbs. shipping Tube Complement 1 - 12AX7 1 - 12BH7 4 - EL34 Warranty 3 years parts