PYLE Audio PZR50XA دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Please complete warranty card, detach and return
Thank you for purchasing this PYLE
product. To activate your
warranty registration card
warranty, please mail this card
within 10 days.
PYLE PRO AMPLIFIERS
Name
Address
City, State ZIP
Model No. Serial # (if available)
Date of Purchase
Purchased at:
Music Products Store Sound Contractor/Installer Mail Order
Catalog Merchandiser Other
PZR6XA Amplifier
PZR10XA Amplifier
Limited Warranty
All PYLE PRO products are

ملخص المحتوى في الصفحة رقم 2

FEATURES AND CONTROLS Channel 1 and Channel 2 Power LED Display TABLE OF CONTENTS Your New Pyle Pro PZR series P.A. Indicate the output signal level for each channel. FRONT PANEL, PZR30XA/50XA 1 Features and Controls, PZR6XA/10XA and PZR30XA/50XA Amplifier gives you the power and 2 Installation Guidelines versatility you need in a professional 2 Input Connections 2 Connecting a CD, DVD or tape player or tuner sound system. 2 Connecting an equalizer or signal processor The amplifier's wide frequ

ملخص المحتوى في الصفحة رقم 3

INSTALLATION GUIDELINES Connecting an equalizer or external signal processor STEREO OPERATION Connect the processor's OUT to the amplifier's IN connector. Connecting the GND (GROUND) screw terminal Connecting CH 2 CH 1 SWITCH IN “STEREO” POSITION a mixer or preamplifier may cause excessive noise or hum in the amplifier output. To prevent this, connect one end of a low-capacitance shield wire to the amplifier's ground BALANCED INPUTS screw (on the rear panel). Then connect the other end of OUTPU

ملخص المحتوى في الصفحة رقم 4

Connecting to standard AC power Using the Channel 1 and Channel 2 Output Level controls Amplifier Specifications PZR6XA PZR10XA PZR30XA PZR50XA After making all other connections, set the POWER switch Rotate output level gain clockwise to increase, or counter- Input Impedance, balanced (unbalanced) 20 k-Ohms (10 k-Ohms) 20 k-Ohms (10 k-Ohms) 20 k-Ohms (10 k-Ohms) 20 k-Ohms (10 k-Ohms) to OFF position. Then connect the power cord to a standard clockwise to decrease the output power. To get the be