ملخص المحتوى في الصفحة رقم 1
VHF Wireless Microphone System
Nady Wireless Systems are type accepted under FCC rules parts 90, 74 and 15. The
device complies with RSS-210 of Industry & Science Canada. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
NADY SYSTEMS, INC.
6701 Shellmound Street • Emeryville, CA 94608 USA
Tel: 510/652-2411 • Fax: 510/652-5075
ملخص المحتوى في الصفحة رقم 2
CONTENTS INTRODUCTION Thank you for purchasing a Nady Encore I Wireless Microphone System and congratulations on your choice. The Encore I is loaded with top professional operat- ing features and is the best performance and price value available in VHF wireless CONTENTS ...........................................................................................2 systems. INTRODUCTION ....................................................................................3 USING THIS MANUAL...........
ملخص المحتوى في الصفحة رقم 3
SYSTEM FEATURES ENCORE I RECEIVER 1. Rackmounting the Receiver • Available on selected frequencies in the VHF high band There are 2 options available for rackmounting the Encore I receiver: singly or side- (171-216 MHz) for interference-free, long-range performance by-side with another Encore Series receiver. • Proprietary companding circuitry for an industry-best 120dB Dynamic Range, a. Single mounting: Remove the receiver SIDE MOUNT CLIP (1) from each side of and the clearest, most natural sou
ملخص المحتوى في الصفحة رقم 4
16 5. Connecting the Audio Output The Encore I receiver provides both a fixed mic level BALANCED AUDIO OUTPUT XLR (14) and an adjustable line level UNBALANCED AUDIO OUTPUT 1/4" JACK (13). The level from the UNBALANCED OUTPUT is controlled by the rear panel VOLUME CONTROL (6). (Note: As when making any connection, make sure the amplifier or mixing board volume is at the minimum level before plugging in the receiver to avoid possible sound system damage. Also make sure that the phantom power on t
ملخص المحتوى في الصفحة رقم 5
WHT-15 HANDHELD MICROPHONE TRANSMITTER 1. Unscrew the BATTERY COMPARTMENT COVER (17) and remove, exposing the BATTERY HOLDER (18). Insert a fresh 9V ALKALINE BATTERY (19), observing the correct polarity as marked, and screw the cover back on to the microphone. Make sure the cover is screwed on completely. A fresh alkaline battery can last up to 16 hours in use, but in order to ensure optimum performance, it is recommended that you replace the battery after every 10 hours of use. 2. Turn on the
ملخص المحتوى في الصفحة رقم 6
WLT-15 LAVALIER/LAPEL OR HEADWORN MICROPHONE 24 BODYPACK TRANSMITTER 1. Snap open the BATTERY COMPARTMENT (22) and insert a fresh 9V BATTERY (23), observing the correct polarity. Close the compartment. 29 28 2. The WLT-15 is provided with a 3.5 mm LOCKING JACK (24) for connecting the 27 microphone. Plug in either the LAVALIER/LAPEL (25) or the HEADWORN MICRO- PHONE (26), as supplied. To secure the connection, turn the metal slip ring on the plug clockwise to thread it on to the jack. To unpl
ملخص المحتوى في الصفحة رقم 7
WGT-15 INSTRUMENT BODYPACK TRANSMITTER 32 35 1. Snap open the BATTERY COMPARTMENT (30) and insert a fresh 9V BATTERY (31), observing the correct polarity. Close the compartment. The WGT-15 is provided with a 3.5 mm LOCKING JACK (32) for connecting the INSTRUMENT CABLE (35). To 34 secure the connection, turn the metal slip ring on the plug clockwise to thread it on to 33 the jack. To unplug, reverse the process. Slip the transmitter into a pocket or clip on to your clothes or instrument stra
ملخص المحتوى في الصفحة رقم 8
THE LINK 2™ PLUG-IN TRANSMITTER 4. Microphone Operation a. Turn on the Link 2 by sliding the ON/STANDBY/OFF SWITCH (41) to the 1. Transmitter Set-Up STANDBY position (transmitter on, audio muted) or the ON position (transmitter First, slide open the BATTERY COMPARTMENT DOOR (43) to expose compartment. and audio both on). The LOW BATTERY INDICATOR LED (40) will give a single Insert a fresh 9V ALKALINE BATTERY (45), observing polarity. Close the battery quick flash, indicating usable battery s
ملخص المحتوى في الصفحة رقم 9
SPECIFICATIONS ENCORE I OVERALL SYSTEM PERFORMANCE Frequency Response 25-20,000 Hz, +/-3dB 38 Dynamic Range 120dB Total Harmonic Distortion < 0.3% RF Carrier Frequency Range 169-216 MHz Frequency Stability +/- 0.005%, crystal controlled Modulation FM (F3E), +/-20KHz max. Operating Range Up to 250 ft. typical (depending on site conditions); up to 500+ feet optimum line-of-sight 44 TRANSMITTERS 43 36 Audio Inputs •WHT-15 Nady DM-10D neodymium dynamic cartridge •WLT-15/WGT-15 3.5mm mono locking
ملخص المحتوى في الصفحة رقم 10
ENCORE I RECEIVER Controls Power ON/OFF, volume control, mute control Connectors Balanced XLR and unbalanced adjustable 1/4" audio out jacks, 2.1 mm barrel-type DC input jack LED Indicators Power ON, 5-LED RF & AF level displays , Dimensions (Max.) 1.75" x 7.5" x 8.1" (4.4 x 19 x 20.7 cm) Weight 1.6 lbs (.73 kg) Power Requirements 12V @ 400mA, nominal, AC/DC adapter supplied Antenna 11.2" (28.5 cm), single telescopic SERVICE (U.S.) Should your Nady Encore I Wireless Microphone System require s
ملخص المحتوى في الصفحة رقم 11
Nady Wireless Systems are type accepted under FCC rules parts 90, 74 and 15. The device complies with RSS-210 of Industry & Science Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. NADY SYSTEMS, INC. 6701 Shellmound Street • Emeryville, CA 94608 USA Tel: 510/652-2411 • Fax: 510/652-5075 www.nadywireless.com